Horizon Hobby HBZ4771 User Manual

Transmitter Setup

1. Remove the transmitter back cover.

2. Install the included “AA” batteries. Use four fresh 1.5V “AA”

batteries only.

3. Be sure to observe proper polarity when installing the

batteries, and then replace the cover.

4. To test, switch on the transmitter. The LED should glow

brightly

5. Replace the batteries when you hear the low battery

alarm(beeping sound)

Note: You many notice a small switch immediately below

the LED and the power switch.

This small switch determines the controls for the

transmitter with default position to the left.

It is not recommended to change it.

Motor Test and Battery Discharging

1. Turn on transmitter.

2. Install the flight battery into fuselage and

plug it into the connector

3. Move the transmitter’s left stick all the way

down and hlod for one second. This will arm the

motor.

4. Move the transmitter’s left stick up. Since

most batteries come partially changed, the prop

should spin at high spped. (If the motor does not run.

Proceed to charging the battery.)

5. In order to fully discharge the battery, run

the motor at high speed until it shuts off. If there is

not enough charge in the battery to power the

propeller, then proceed to step 4.

6. When finished with the motor test, be sure to disconnect the battery first, then turn off the

transmitter.

Tail Control Test

1. Switch on the transmiiter. Check the LED.

Do not touch the sticks for 2 secoonds while the

transmiiter automatically calibrates the controls.

2. Install the battery in the fuselages slot and plug in the

connnector. Do not arm the motor

3. The small buttons under and to the side of the sticks are

the digital trim buttons and are used to adjust the

“neutral” point of your control stick. Each time the

transmitter is powerd up, it should reset the trim

automatically. These should self-center when you turn the

transmitter on

4.If you find that the control surface flap is not level with

the rest of the tail surface, you can correct this with a few

pushes of the appropriate trim buttons.

5. Move the right stick side to side which observing that the

tail flaps are moving as shown.

6. Move the right stick up and down which observing that

the tail flaps are moving as shown.

2 1wqwqwew wq