Horizon Fitness T30, T40 User Manual
Par ts
• 1 Power Cord
• 1 Safety Key
• 2 Water Bottle Holders
• 1 Hardware Pack (contents listed below)
Tools (included)
• 5mm Allen Wrench/Phillips Screw Driver
• Flat Wrench
• 8mm Allen Wrench
or
• 6mm Allen Wrench
HARDWARE
B) 16mm Washer
Quantity: 2
ASSEMBLY
GUIDE
HORIZON T30 & T40
A) 60mm Bolt
Quantity: 2
E) 20mm Bolt
C) 13mm Nut
D) Arc Washer
Quantity: 4
Quantity: 2
Quantity: 2
1
D
E
A
B
C
1. LIFT CONSOLE MAST INTO
UPRIGHT POSITION.
E
D
B
C
A
3
2
E
E
2. SET CONSOLE INTO PLACE.
4
SAFETY KEY
UNPACKING
Take caution when handling and transporting this unit. Never
open box when it is on its side. Once the banding straps have
been removed, do not lift or transport this unit unless it is fully
assembled and in the upright folded position, with the lock
latch secure. Unpack the unit where it will be used. The
enclosed treadmill is equipped with high-pressure shocks and
may spring open if mishandled. See owner’s guide for reference. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD
RESULT IN INJURY! Place your treadmill on a level flat surface. It is recommended that you place a protective covering
on your floor.
= Tighten
NOTE: It is recommended that you apply grease
to the threads of each bolt as you assemble your
treadmill, to prevent loosening and noise. Also,
during each assembly step, ensure that ALL nuts
and bolts are in place and partially threaded in
before completely tightening any ONE bolt.
HORIZON FITNESS CUSTOMER ASSISTANCE CENTER 1.800.244.4192 or www.horizonfitness.com
3. TIGHTEN PRE-INSTALLED BOLTS.
Loading...