USER MANUAL
48011580-01 Turbopower IM UK.indd 1 2014/6/5 17:36:44
IMPORTANT SAFETY REMINDERS
This appliance should only be used for domestic cleaning, as
described in this user guide. Please ensure that this guide is
fully understood before operating the appliance.
cigarette ends or other similar items.
Do not spray with or pick up flammable liquids, cleaning fluids,
aerosols or their vapours.
Do not run over the power cord when using your appliance or
remove the plug by pulling on the power cord.
Do not leave the appliance plugged in. Always switch off and
remove the plug from the socket after use, or before cleaning
the appliance or any maintenance task.
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
If the power cord is damaged stop using the appliance
immediately. To avoid a safety hazard, an authorised Hoover
service engineer must replace the power cord.
Keep hands, feet, loose clothing and hair away from rotating
brushes.
Use only attachments, consumables or spares recommended
or supplied by Hoover.
When using cleaning tools ensure that the appliance is kept in
the upright (parked) position. This will avoid possible damage
to the carpet or floor covering. When cleaning stairs, do not
position the appliance above you.
Static electricity: some carpets can cause a small build up
of static electricity. Any static discharge is not hazardous to
health.
Do not use your appliance out of doors or on any wet surface
or for wet pick up.
Do not continue to use your appliance if it appears faulty.
Hoover service: To ensure the continued safe and efficient
operation of this appliance we recommend that any servicing
or repairs are only carried out by an authorised Hoover service
engineer.
Do not stand on or wrap the cord around arms or legs when
using your appliance.
Do not use the appliance to clean animals or people.
When using the cleaning tools, ensure to always steady the
appliance with your other hand. This will ensure that the
appliance does not fall while in use.
WARNING: A thermal cut out switches off the appliance to prevent overheating
if it is used when full or there is a blockage or dirty filters. If this should
happen then switch off, unplug and correct the fault. It will take approximately
45 minutes for the cut out to automatically reset.
The Environment
The symbol on this appliance indicates that this appliance may not
be treated as household waste. Instead it must be handed over to the
applicable collection point for the recycling of electrical and electronic
equipment. Disposal must be carried out in accordance with local
environmental regulations for waste disposal. For more detailed
information about treatment, recovery and recycling of this appliance, please
contact your local city office, your household and waste disposal service or
the shop where you purchased the appliance.
This appliance complies with the European Directives 2006/95/EC,
2004/108/EC and 2011/65/EU.
Do not pick up hard or sharp objects, matches, hot ashes,
HOOVER Limited, Pentrebach, Merthyr Tydfil, Mid Glamorgan, CF48 4TU, UK
- 2 -
48011580-01 Turbopower IM UK.indd 2 2014/6/5 17:36:45
GETTING TO KNOW YOUR CLEANER
Effortless
cleaning
with your
HANDLE
new Hoover
This vacuum cleaner is
supplied with an Energy
Label as required by
European Regulation (EU)
665/2013.
BIN RELEASE
WASHABLE
PRE MOTOR FILTER
DUST
CONTAINER
EXHAUST
FILTER
CARPET CARE
CONTROL
SELECTOR
DUSTING
BRUSH
ON/OFF
BUTTON
EXTRA LONG
HOSE HOOK*
PET HAIR &
ALLERGEN
REMOVER*
HOSE HOOK/
CARRY HANDLE
CORD STORAGE
HOOK
HOSE
EXTENSION TUBE
/CREVICE TOOL
POWER CORD
HOSE
CONNECTOR
CLEANER
RELEASE
PEDAL
PARQUET
EXTRA LONG HOSE
* Certain models only
48011580-01 Turbopower IM UK.indd 3 2014/6/5 17:36:45
- 3 -
NOZZLE*
PREPARING YOUR CLEANER
Insert the handle into the body of the cleaner. Screw handle in place with the screws provided. Attach turbo nozzle to the cleaner.
1
Ready for use To convert product to use accessories: simply remove
4
* Certain models only.
2
*
short hose and attach extra long hose in same locations.
- 4 -
3
48011580-01 Turbopower IM UK.indd 4 2014/6/5 17:36:45
3
4
1
2
5
CARPET CARE CONTROL SELECTOR
CARPET CARE CONTROL SELECTOR
POWER SWITCH
The carpet care control selector raises and lowers
the height of the nozzle.
Ensure that the cleaner is in the upright (parked)
position and move the selector to the required
setting for the carpet type or oor covering.
To obtain the best performance and energy
efciency
#1
it is recommended that the adjustment
setting position 1 is used for the main cleaning
operations. The other adjustment settings are
for ease of use, use on longer pile carpets, or for
specialist cleaning tasks.
Settings
1. Best performance and energy efciency, short to
medium pile carpets, hard wooden oors, wooden
oor boards with crevices, ceramic tiles.
2. Medium pile carpets, delicate oor coverings
such as vinyl or linoleum, parquet ooring.
3 or 4. For longer pile carpets the motion
resistance may increase. Use these intermediate
settings to reduce the force required to push the
vacuum cleaner.
5. Luxury carpet and Tool mode
IMPORTANT: Using this cleaner for loop pile
carpets with pile greater than 30mm is not
recommended. Please consult the oorcare/carpet
manufacturer’s recommended cleaning instruction
before vacuuming.
IMPORTANT: When cleaning delicate hard oors
such as vinyl or linoleum the selector switch must
be moved to position 2. Failure to do so may
cause damage to the oor surface.
This vacuum cleaner is supplied with an Energy
Label as required by European Regulation (EU)
665/2013. If the label shows a red prohibition
circle on the right covering the hard oor symbol,
then this indicates that the vacuum cleaner is not
suitable for use on hard oors.
#1
NOTE: Dust pick up ability carpet, dust pick up
ability hard oor, and energy efciency in accord
with Commission Regulations (EU) 665/2013
and (EU) 666/2013.
CLEANER RELEASE
Unlock the cleaner by pressing down on the pedal
with your foot.
To switch the cleaner on or off press down on the
pedal with your foot.
CLEANER STORAGE
Turn the cleaner off and remove the plug. Wrap the
cord around the cord storage hooks.
For quick release of the full length of the power cord,
rotate the top storage hook.
48011580-01 Turbopower IM UK.indd 5 2014/6/5 17:36:46
* Certain models only.
- 5 -
CLEANING TOOLS*
Crevice Tool
For corners and hard to reach areas.
Dusting Brush
For bookshelves, frames, keyboards and other delicate areas.
Pet Hair & Allergen Remover*
The pet hair & allergen remover is ideal for removing pets hairs. DO NOT touch the rotating brush.
Parquet Nozzle*
The parquet nozzle is ideal for cleaning delicate surfaces.
All accessories can t onto the end of the exible hose or end of the extension tube. Combine accessories
depending on use.
Remove the short stretch hose from
1
the Hose socket. Plug in the extra
long hose in the hose socket.
Remove the extension tube. Slide the crevice tool out of the
2
3
extension tube.
CLEANING THE STAIRS
Both short and extra long
hoses are supplied with the
cleaner. When the user needs
to use the longer stretch
hose, the short hose should
be removed from the hose
socket and replaced by the
longer stretch hose.
It is dangerous to place
the cleaner above you
when cleaning stairs.
ALWAYS work with
the cleaner below you.
Ensure it is positioned up
against the bottom step.
Attach extension tube to the
4
end of the hose.
!
IMPORTANT! When using cleaning tools, the cleaner must be kept in the upright position,
particularly when cleaning stairs. The nozzle height should also be set to tool mode.
* Certain models only
48011580-01 Turbopower IM UK.indd 6 2014/6/5 17:36:47
Fit the crevice tool or dusting
5
brush to the extension tube or
hose.
Fit the Pet Hair and Allergen
6
Remover* to the hose or at
the end of the extension tube.
Fit the parquet nozzle* to the
crevice tool.
- 6 -
LONGER LENGTH HOSE HOOK*
For longer length hose*. Use the upper hose hook for
storage.
EMPTYING THE DUST CONTAINER
1
To remove the dust container from the
cleaner press the bin release button.
Hold the container
2
over the bin and
press the bin open
button.
CLEANING THE PRE MOTOR FILTERS
Rotate the upper part of the dust bin to open.
1
Remove the lter assembly from the dust bin.
2
CLEANING THE EXHAUST FILTER
Remove the dust container rotate and remove
1
the exhaust lter cover.
Remove the xhaust lter.
2
Separate the foam lter from the lter pack.
3
The dust container
43
door will open and
you can empty with
no contact with the
dust.
44
Once emptied, gently
tap or shake the
container to release
any excess dust from
the filters.
Wash both lters under hand warm water until
4
the water runs clean. Remove excess water by
shaking and leave to dry for 24 hours.
When completely dry reassemble and refit
filters to cleaner.
Wash the lter under hand warm water until
3
the water runs clean. Remove excess water by
shaking and leave to dry for 24 hours.
When completely dry reassemble and refit
filters to cleaner.
- 7 -
48011580-01 Turbopower IM UK.indd 7 2014/6/5 17:36:48
CHANGING THE BELT OR BRUSHES
CLEARING A BLOCKAGE
If your cleaner is not picking up efciently, the belt or brushes (or both) may need replacing, but rst please make
sure you have:
• Emptied the dust container
• Cleaned the lters
• Checked for blockages
Turn the cleaner over and remove 5 retaining
1 4
screws attaching the brush guard to the
base.
Remove the brush guard
2
IMPORTANT: Switch the cleaner off and
remove the plug from the electricity supply
before dismantling cleaner
Hold the brush assembly and stretch the belt
until the brush can be slotted back into the
cleaner housing.
Rotate the brush to ensure movement of the belt.
5
IMPORTANT: Switch the cleaner off and
remove the plug from the electricity supply
before dismantling cleaner
If cleaning tools were
in use check the
cleaning tool and the
removable handle.
Check the hose by
removing it from the
cleaner, stretching it to
full length .
Turn the cleaner
over and rotate the
brushes until they
are free to rotate.
Check for a blockage in
Remove brush assembly and check for wear
3
on the belt. Loop the new belt around the motor
and brush channel.
* Certain models only.
48011580-01 Turbopower IM UK.indd 8 2014/6/5 17:36:49
Refit the brush guard with 5 retaining screws.
6
- 8 -
the hose socket. Use a
flexible rod to remove
any obstruction.
Removing a blockage from
the pet hair & allergen
remover.
Open the nozzle at each
side, lift cover and remove
the blockage.
*Certain models only.
User checklist
If your cleaner is not working properly run through the
following checklist.
1. Is there a working electricity supply to the cleaner?
Check with another electrical product.
2. Is the dust container full or choked with fine dust?
To empty the dust container, see instructions on P7.
3. Is the hose blocked?
To clear a blockage, see instructions on P8.
4. Is there a blockage in the cleaner base?
To clear a blockage, see the instruction on P8.
5. Are the filters blocked?
To clean filters, see the instruction on P7.
6. Is the nozzle height set correctly?
To set the carpet height selector, see the instruction on p4.
7. Are the brushes rotating correctly?
To check the brushes, see the instructions on p8.
8. Has the cleaner overheated?
If so, it will take about 30 minutes to reset.
IMPORTANT INFORMATION
Hoover Service
Should you require service at any time, please contact your local Hoover Service Ofce.
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local Hoover
dealer or direct from Hoover. When ordering parts always quote your model number.
USE ONLY HOOVER SPARES
SPARE PARTS CODE
AGITATOR Y200E 35601611
BELT V200E 35601615
HOSE D130 35601199
PET HAIR AND ALLERGEN REMOVER J44 35601064
HARD FLOOR CARESSE NOZZLE G135 PC 35601201
If there is any doubt call the Hoover Service Office for advice. They may be able
to assist you over the telephone. A service charge will be made if the cleaner is
examined and found to be in working order, has not been assembled in accordance
with these instructions or has been used incorrectly. working order, has not been
assembled in accordance with these instructions or has been used incorrectly.
WARNING!
A thermal cut out switches off the cleaner to prevent overheating if it is used when
full or there is a blockage or dirty filters. If this should happen switch off, unplug and
correct the fault.
It will take about 45 minutes for the cut out to automatically reset.
IMPORTANT: Do not run cleaner over the supply cord as this could damage the
supply cord insulation.
- 9 -
CONSUMABLES CODE
FILTER KIT
(PRE MOTOR AND EXHAUST)
U65 35601202
Quality
Hoover’s factories have been independently assessed for quality. Our products
are made using a quality system which meets the requirements of ISO 9001
GUARANTEE STATEMENT
The guarantee conditions for this appliance are as defined by our representative in
the country in which it is sold. Details regarding these conditions can be obtained
from the dealer from whom the appliance was purchased. The bill of sale or receipt
must be produced when making any claim under the terms of this guarantee.
Subject to change without notice.
48011580-01 Turbopower IM UK.indd 9 2014/6/5 17:36:49
Hoover Limited
Pentrebach
Merthyr Tydl
Mid Glamorgan
CF48 4TU
HOOVER CUSTOMER HELPINE
08444 995 599
© 2014 48011580/01
48011580-01 Turbopower IM UK.indd 11 2014/6/5 17:36:49
Loading...