Hoover TELIOS CYCLONIC User Manual

Download

Page 1

TÉLIOS

CYCLONIC

USER INSTRUCTIONS

Electrical requirements

THIS APPLIANCE IS DOUBLE INSULATED AND MUST NOT BE EARTHED.

IMPORTANT: THE WIRES IN THE MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:

BLUE - NEUTRAL BROWN - LIVE

WARNING!

ELECTRICITY CAN BE EXTREMELY DANGEROUS.

*Feature varies according to model

Telescopic tubes (1) *

A) Twist to release lock.

Pull out to required length.

Twist to tighten.

B) Push latch forward or

Upwards as applicable.

Pull out to required length.

Release latch to lock.

Hose fitting (2)

Push into hose inlet.

To release squeeze both buttons and pull out.

Suction regulator (3)

Move slider to adjust suction.

On/off pedal (4)

Push to switch on.

Push again to switch off.

CORD REEL PEDAL (5) *

Push to automatically reel in supply cord.

CONTROLS (6)

POWER CONTROL

Move slide control to set power level.

Storing the cleaner (7) *

Use storage clip as shown when storing the cleaner.

Park position (8)

For temporary storage during cleaning.

ENGLISH

Page 2

ENGLISH

Calling for service

A charge will be made if the cleaner is found to be in working order

has not been assembled in accordance with these instructions

has been used incorrectly.

Before calling a HOOVER service engineer run through the following checklist:

1. Is there a working electricity supply to the cleaner? Check with another appliance.

2. Is the cassette full?

3. Is the hose blocked?

4. Are the filters blocked?

If there is any doubt call your local HOOVER service office for advice, they may be able to assist you over the telephone.

Guarantee statement

The guarantee conditions for this appliance are as defined by our representative in the country in which it is sold. Details regarding these conditions can be obtained from the dealer from whom the appliance was purchased. The bill of sale or receipt must be produced when making any claim under the terms of this guarantee.

Subject to change without notice.

GIAS CUSTOMER SERVICE 08705 400600

HOOVER SPARES 01204 556111

ENVIRONMENT

This appliance is marked according to the European directive 2002/96/EC on the Waste of Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.

The symbol on the product indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.

ENGLISH

Carpet/floor nozzle (9) *

A) Carpet position - brushes in

B) Hard floor position -

brushes out

C) Universal nozzle

Cleaning tools (10)

3 cleaning tools are supplied with your product. The extension tube storage allows two tools to be stored.

A) Crevice tool

B) dusting brush

C) Multipurpose nozzle

EMPTYING AND CLEANING CYCLONIC CASSETTE AND FILTERS

DO NOT use the cleaner without

the cassette or filters in place.

Please note the cover will not close unless the cassette is in place.

Emptying the cyclonic cassette (11)

For optimum performance HOOVER recommends that you empty the cyclonic cassette after each use.

To empty the cassette:

• Remove the hose.

• Push in the button and

open the cover.

• Lift out cassette using

the carry handle.

• Position the cassette over a

bin before opening it.

• Pull the latch and open

the cassette door.

• Grip the cyclonic cassette

firmly and tip the contents into the bin.

• Close cassette door and refit

the cassette in it’s original position in the cleaner.

Maintaining the cyclonic screen (12)

Clean the cyclonic screen after each empty.

• Rotate the cyclonic screen to

release.

• The screen can be cleaned using

the dusting brush supplied.

Maintaining the filters (13 & 14)

HOOVER recommends that you wash the filters after five cassette empties.

Remove the cassette filter by means of the handle (13A).

• Tap the filter over a bin.

• Rinse under hand warm water.

• Leave to dry for 24 hours or

until completely dry before refitting.

To access the pre motor filter please remove the cyclonic cassette. Remove the filter from its rubber frame (13B).

• Rinse the filter under hand

warm water.

• Leave to dry for 24 hours or

until completely dry before refitting.

Changing the exhaust filter (14), HOOVER recommends that you replace the exhaust filter every 12 months.

• Lift off the filter cover.

• Remove filter.

• Fit new filter and replace cover.

Important: Switch

cleaner off and remove plug from electricity supply before emptying cassette or removing

any filters

PLEASE READ THESE INSTRUCTIONS

THOROUGHLY

THIS PRODUCT MUST BE ASSEMBLED AND OPERATED IN ACCOR-

DANCE WITH THESE INSTRUCTIONS AND USED

ONLY FOR DOMESTIC CLEANING TO REMOVE DRY DIRT

AND DUST FROM HOUSEHOLD CARPETS AND FLOORING.

THE TOOL KIT CAN BE USED TO REMOVE DIRT AND

DUST FROM FURNITURE AND FABRICS.

User’s manual. This Cleaner

should only be used for its intended purpose as described in these instructions. Ensure that these are fully understood before operating the appliance.

Maintain the filters

frequently when picking up material such as powder or fine dust or when cleaning new carpets.

Do not use your cleaner out

of doors or on any wet surface or for wet pick-up.

Do not pick up hard or sharp

objects, matches, hot ashes, cigarette ends or other similar items.

Static electricity. Some

carpets can cause a small build up of static electricity. Any static discharge is not hazardous to health.

Only use attachments

reccomended or supplied by hoover.

Do not pick up flammable

liquids such as cleaning fluids, petrol etc, or their vapours.

Aerosol sprays may be

flammable. Do not spray near the cleaner.

Supply cord. Do not remove

the plug by pulling on the supply cord. If the supply cord is damaged, the cleaner must be repaired by an authorised

Hoover service engineer to

avoid a safety hazard.

Faults. Do not continue to use

your cleaner if it appears to be faulty or the supply cord is damaged.

After use. Switch the cleaner

off and remove the plug from the electricity supply. Always switch off and remove the plug before cleaning the appliance or attemting any maintenance work.

Hoover service. To ensure

the continued safe and efficient operation of this appliance, we recommend that any servicing or repairs are only carried out by an authorised Hoover service engineer.

Safety reminders

ENGLISH