Hoover TE70EN20 User Manual

Page 1
OK-NEW 2003.4.4 3:23 PM Page 1
Page 2
OK-NEW 2003.4.4 3:23 PM Page 2
Page 3
ENGLISH
This appliance is double insulated and must not be earthed.
IMPORTANT: The wires in the mains lead are coloured in accordance with the following code:
9
Cord reel pedal (5) *
Push to automatically reel in supply cord.
Controls (6)
a)❉Power control
Move slide control to set power level.
b) Bag check indicator
Turns from green to red as bag fills. When
2
/3 red, bag needs
emptying.
Storing the cleaner (7) *
Use stowage clip as shown when storing the cleaner.
Park position (8)
For temporary stowage during cleaning.
*Feature varies according to model
Telescopic tubes (1) *
a) Twist to release lock.
Pull out to required length.
Twist to tighten. or b) Push latch forward or upwards as
applicable.
Pull out to required length.
Release latch to lock.
Hose fitting (2)
Push into hose inlet. To release squeeze both buttons and
pull out.
Suction regulator (3)
Squeeze trigger to reduce suction.
ON/OFF pedal (4)
Push to switch on Push again to switch off.
WARNING!
ELECTRICITY CAN BE EXTREMELY DANGEROUS.
Electrical requirements
(+) increase decrease (-)
Page 4
ENGLISH
10
Carpet/floor nozzle (9) *
a) Carpet position - brushes in
b) Hard floor position - brushes out
c) Universal nozzle
Cleaning tools (10)
a) Crevice tool
b) Dusting brush
c) Multi-purpose nozzle
Changing the paper bag (11)
The bag check indicator will turn red when the bag needs emptying.
For true bag check indication the power control* must be set to maximum.
DO NOT overfill the bag.
To change the bag:
1. Remove hose.
2. Press latch and open bag door.
3. Lift out bag cassette.
4. Pull bag collar from cassette using
finger grips. The bag will self seal.
5. Slide collar of new bag into cassette
and lower cassette into bag housing.
6. Close bag door and refit hose.
IMPORTANT: Switch cleaner off
and remove plug from electricity
supply before changing paper
bag or removing any filters.
DO NOT use cleaner without bag in
place.
Hoover recommend that new filters are fitted after five full bags of dirt have been removed.
Changing the secondary filter (12)
With paper bag removed lift filter from bag housing.
Fit new filter and replace paper bag.
a) *Secondary filter
b) *‘S’ class filter cassette
or *Active carbon filter
Changing the exhaust filter (13)
1. Lift off filter cover.
2. Remove filter.
Fit new filter and replace cover.
*Exhaust filter
Page 5
ENGLISH
Calling for service
A charge will be made if the cleaner is found to be in working order or has not been assembled in accordance with these instructions or has been used incorrectly.
Before calling a HOOVER Service Engineer run through the following checklist:
1. Is there a working electricity supply to the cleaner? Check with another appliance.
2. Is the paper bag full?
3. Is the hose blocked?
4. Are the filters blocked?
If there is any doubt call your local Hoover Service Office for advice, they may be able to assist you over the telephone.
11
Loading...