Hoover TCPW1450 User Manual

CAPTURE-1 glow UK.pdf 1 4/6/2011 3:23:42 PM
M
L*
S
INSTRUCTION MANUAL
P
®
C
M
Y
CM
ENGLISH GB
T*
H*
MY
CY
CMY
K
G*
F*
I*
K
J
U*
E
B
A
V*
Q
PRINTED IN P.R.C.
48004162/01
S
®
1
N**
O
W*
* Certain models only ** Nozzle design may vary according to model
2 3 4 5
C
M
Y
CM
MY
CY
CMY
K
14 15 16 17
6* 7 8 9*
*
10
11 12 13
18 19 20 21
22 23
* Certain models only
GB
IMPORTANT SAFETY REMINDERS
This cleaner should only be used for domestic cleaning, as described in this user guide. Please ensure that this guide is fully understood before operating the appliance. Use only attachments recommended or supplied by Hoover.
WARNING: Electricity can be extremely dangerous. This appliance is double insulated and
must not be earthed. This plug is tted with a 13 amp fuse (UK only).
IMPORTANT: The wires in the mains power lead are coloured in accordance with the following code:
STATIC ELECTRICITY: Some carpets can cause a small build up of static electricity. Any static discharge is not hazardous to health.
AFTER USE: Switch the cleaner off and remove the plug from the electricity supply. Always switch off and remove the plug before cleaning the appliance or attempting any
maintenance task.
HOOVER SERVICE: To ensure the continued safe and efcient operation of this appliance we recommend that any servicing or repairs are only carried out by an authorised Hoover
service engineer.
Blue – Neutral Brown – Live
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
IT IS IMPORTANT THAT YOU DO NOT:
• Position the cleaner above you when cleaning the stairs.
• Use your cleaner out of doors or on any wet surface or for wet pick up.
Pick up hard or sharp objects, matches, hot ashes, cigarette ends or other similar items.
• Spray with or pick up flammable liquids, cleaning fluids, aerosols or their vapours
as this may cause risk of fire / explosion.
• Run over the power cord when using your cleaner or remove the plug by pulling on the power cord.
• Stand on or wrap the power cord around arms or legs when using the cleaner.
Use the appliance to clean people or animals.
• Continue to use your cleaner if it appears to be faulty. If the power cord is damaged
stop using the cleaner IMMEDIATELY. To avoid a safety hazard, an authorised
Hoover service engineer must replace the power cord.
*Certain models only **Nozzle design may vary according to model
GETTING TO KNOW YOUR CLEANER
A. Main Cleaner B. Cord Rewind Pedal
C. Carry Handle
D. Exhaust Filter Cover E. On/Off Pedal F. Telescopic Tube* G. Telescopic Tube Release Button* H. Standard Tube* I. Variable Power Control Roller* J. Bag Check Indicator K. Bag Door Release Latch
L. Suction Regulator* M. Handle N. Carpet and Floor Nozzle** O. Surface selector Pedal P. Hose Q. Pre motor lter R. Exhaust lter S. 2 in 1 Tool T. Pet Hair Remover Mini Turbo Nozzle* U. Allergen Remover Mini Turbo Nozzle* V. Grand Turbo Nozzle*
W. Hard Floor Caresse Nozzle*
ASSEMBLING YOUR CLEANER
Remove all components from the packaging.
1. Connect the hose to the cleaner main body, ensuring it clips and locks into position. To release: simply press the two buttons on the hose end and pull [2].
2. Connect the tube upper end to the handle. [3].
3. Connect the tube lower end to the carpet and oor nozzle [4].
USING YOUR CLEANER
1. Extract power cord and plug it into the power supply. Do not pull the cord beyond the
red marker [5].
2. Adjust the length of the telescopic tube* by moving the telescopic release button* up
and raise or lower the handle to the most comfortable cleaning position [6].
3. Carpet & Floor Nozzle. Press the pedal on the nozzle [7] to select the ideal cleaning mode for the oor type.
Hard Floor: The brushes are lowered to protect the oor Carpet: With lifted brushes for the deepest clean
4. Switch the cleaner on by pressing the On/Off pedal on the cleaner main body [8]
5. Adjust the power level by rotating the variable power control roller*. [9]
6. Adjust the suction regulator* to the desired level. [10].
7. Switch off at the end of use by pressing the On/Off pedal. Unplug and press the cord rewind pedal to wind the power cord back into the cleaner [11].
8. Parking and Storage - The tube can be parked for temporary storage while in use, or
in the storage position when not in use [12].
1
GB
CLEANER MAINTENANCE
Replacing The Dust Bag
If the bag check indicator is red please check and, if necessary, replace the bag.
1. Lift the bag door release latch [13] to open the cover, pull the bag holder [14] and pull the bag collar to remove the bag [15].
2. Apply the peel and seal sticker, located on the bag collar, to the bag inlet. The full dust bag should be disposed of correctly and carefully.
3. Fold a new bag as shown on the bag and t by inserting the collar into the bag holder.
4. Ret the bag holder and close the bag door.
Warning - The bag door will NOT close if the dust bag and/or the bag holder are not assembled to the cleaner. Always ensure the bag and bag holder are present when closing
the bag door.
Remember: The bag check indicator may also be red if an obstruction has occurred. In this
case refer to ‘Removing A Blockage From the System’.
Cleaning the Filters
To maintain optimum performance of your cleaner, please wash the lters after each 5 bag
changes.
Cleaning the pre-motor lter:
1. Lift the bag door release latch [13] to open the cover and remove the bag holder.
2. To remove the pre-motor lter slide the pre-motor lter frame from the cleaner. [16]
3. Remove the lter from the holder. [17]
4. Wash it in hand warm water, [20] and allow it to dry thoroughly before replacing to the cleaner [21].
Cleaning the exhaust lter:
1. To remove the exhaust lter, unclip the exhaust lter cover [18] and remove the lter
pack. [19]
2. Wash the lter in hand warm water [20] and allow it to dry thoroughly before replacing to the cleaner. [21].
Removing a Blockage From The System
If the bag check indicator is illuminated or ashing:
1. Check if the bag is full. If so refer to ‘Replacing The Dust Bag’.
2. If it is not full, then; A. Do the lters need cleaning? If so refer to ‘Cleaning the Filter’. B. Check if there is any other blockage in the system - Use a rod or a pole to remove
any blockage from the Teletube or exible hose. Warning - The bag check indicator will turn red if the cleaner is used when full, if there is a blockage or if the lters are dirty. If the cleaner is used for a signicant period of time with the bag check indicator is red, a thermal cut out will switch the cleaner off to prevent overheating. The bag check indicator turn green once the cleaner has switched off to signal that the thermal cut out has been activated. If this should happen, switch the cleaner off, unplug and correct the fault. It will take about 30 minutes for the cut out to automatically
reset.
ACCESSORIES AND NOZZLES
All accessories can be tted to the end of the handle or the end of the tube. [23]
2 in 1 tool – Combines two functions in one, the 2 in 1 tool can be connected as a crevice tool. By rotating the end piece converts to a dusting brush. The 2 in 1 tool can be stored
neatly at the rear of the cleaner. [22]
Crevice Tool – For corners and hard to reach areas. Dusting Brush – For bookshelves, frames, keyboards and other delicate areas. To extend
the brushes push the button on the body of the tool.
Pet Hair Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep cleaning on textile surfaces and other hard to clean areas [1T].
Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep cleaning on textile surfaces and other hard to clean areas. [1U]
Grand Turbo Nozzle* – Use the turbo nozzle for deep cleaning on carpets. [1V]
Remember: Do not use hot water or detergents. In the unlikely event of the lters becoming damaged, t a Genuine Hoover replacement. Do not try and use the product without a dust bag or lter tted.
Cleaning the permanent cloth dust bag*
To maintain optimum performance we recommend that you wash the permanent cloth dust bag under hand warm water after every 5 full bags. Remove excess water and leave to dry
fully before replacing.
*Certain models only
Hard Floor Caresse Nozzle*– For wooden oors and other delicate oors. [1W]
IMPORTANT: Do not use the grand turbo nozzle or mini turbo nozzles on rugs with long
fringes, animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary while the brush is rotating.
2
GB
USER CHECKLIST
Should you have a problem with the product, complete this simple user checklist
before calling your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another electrical
appliance
• Is the dust bag over-lled? Please refer to ‘Cleaner Maintenance’
• Is the Filter blocked? Please refer to ‘Cleaning the lter’
• Is the hose or nozzle blocked? Please refer to ‘Removing a blockage from the system’
• Has the cleaner overheated? If so, it will take approximately 30 minutes to automatically
reset
IMPORTANT INFORMATION
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local Hoover dealer or direct from Hoover. When ordering parts always quote your model
number.
Consumables:
• PAPER BAG: H64, 35600637
• HEPA BAG: H63, 35600536
• FILTER KIT (pre-motor and exhaust): U63, 35601193
Quality
BSI ISO 9001 Hoover’s factories have been independently assessed for quality. Our products are made using a quality system which meets the requirements of ISO 9001.
The Environment:
This appliance is marked according to the European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
The symbol on the product indicates that this product may not be treated as
houshold waste. Instead it shall be handed over to the appliance collection point for recycling of electrical and electronic equipment.
Disposal must be carried out in accordance with the local environmental regulations for waste disposal.
For more detailed information about treatment, recovery and recycling of this product,
please contact your local city ofce, your household waste disposal service or the shop where you purchased the product.
Spares:
• CARPET & FLOOR NOZZLE: G130, 35601195
• PARQUET CARESSE NOZZLE: G131 PC, 35601196
• GRAND TURBO NOZZLE: J54, 35601197
• PET HAIR MINI TURBO NOZZLE: J46, 35601116
• COMPLETE FLEXIBLE HOSE: D128, 35601194
Hoover Service
Should you require service at any time, please contact your local Hoover Service Ofce.
Hoover Customer Helpline Service
Should any faults occur with your cleaner during the rst 12 months contact the Hoover Customer Helpline on the number below.
Tel: 08444 995 599 Email: customer.services@hoovercandy.com
Hoover have a computerised nationwide service network of over 500 engineers who will quickly respond to your call and guarantee your repair for 12 months.
Your Guarantee
The guarantee conditions for this appliance are as dened by our representative in the country in which it is sold. Details regarding these conditions can be obtained from the dealer from whom the appliance was purchased. The bill of sale or receipt must be produced when making any claim under the terms of this guarantee.
Subject to change without notice.
3
Loading...