HOOVER SX2045 User Manual

Teile-Nr. 188 045

Techn. Änderungen vorbehalten

DIE SAUBERE LÖSUNG

Robert Hoover Metall- und Elektrowerke GmbH & Co. KG Postfach 18 20, 57279 Neunkirchen Hellerstraße 6, 57290 Neunkirchen Telefon +49 - 27 35 - 7 88 - 0 Telefax +49 - 2735 - 788 - 519 e-mail: info@robert-hoover.de www.robert-hoover.de GERMANY

GA 05/03

Wet&Dry-Serie 1-4 final.qxd 25/3/04 9:36 AM Page 31

Wet&Dry-Serie 1-4 final.qxd 25/3/04 9:36 AM Page 1

Contents Page

Illustration of appliance/identification of parts 3/6 Assembly diagrams 4/5 Safety points 6 Assembling the appliance 7 Dry vacuuming 7 Wet vacuuming 8 If unexpected difficulties arise 8 Customer service 8

Table des matières Page

Schéma de l’appareil/identification des pièces 3/9 Schémas pour le montage 4/5 Consignes de sécurité 9 Montage 10 Aspiration à sec 10 Aspiration humide 11 En cas de difficultés imprévues 11 Service après vente 11

Inhalt Seite

Geräteabbildung/Teileidentifizierung 3/12 Montageabbildungen 4/5 Sicherheitshinweise 12 Montage 13 Trockensaugen 13 Naßsaugen 14 Hilfe bei eventuellen Störungen 14 Kundendienst 14

Indice Pagina

Illustrazioni dell’apparecchio / identificazione dei componenti 3/15 Illustrazioni di montaggio 4/5 Indicazioni di sicurezza 15 Montaggio dell’apparecchio 16 Aspirazione a secco 16 Aspirazione umida 17 In caso di guasto 17 Assistenza clienti 17

Índice Página

Ilustraciones del aparato / Identificación de piezas

3/18 Ilustraciones de montaje 4/5 Advertencias de seguridad 18 Montaje 19 Aspiración seca 19 Aspiración húmeda 20 Ayuda en caso de posibles fallos 20 Servicio Postventa 20

Índice Página

Ilustração do aparelho / Identificação de peças

3/21 Apresentação da montagem

4/5 Instruções de segurança 21 Montagem do aparelho 22 Aspiração de sólidos 22 Aspiração de líquidos 23 Ajuda em caso de avarias 23 Serviço de assistência a clientes 23

Inhoudsopgave Pagina

Overzichtstekening/onderdelenlijst 3/24 Montagetekeningen 4/5 Veiligheidsaanwijzingen 24 Montage 25 Droog zuigen 25 Nat zuigen 26 Tips voor eventuele storingen 26 After Sales Service 26

Obsah Strana

Obrázek spotřebiče/ Identifikace součástek 3/27 Znázornění montáže 4/5 Bezpečnostní upozornění 27 Montáž spotřebiče 28 Suché vysávání 28 Mokré vysávání 29 Objeví-li se nečekané potíže 29 Zákaznický servis 29

Wet&Dry-Serie 1-4 final.qxd 25/3/04 9:36 AM Page 2

Appliance diagram · Schéma de l’appareil · Geräteabbildung · Illustrazioni dell’apparecchio · Ilustraciones del aparato · Ilustração do aparelho · Onderdelen variëren al naar gelang het model · Obrázek spotřebiče

20 21 22 23

24 27 28

15 15a* 17* 18*

12*

11*

13*

26*

25*

16*

25*

17*

* Feature varies according to model * Les équipements varient selon les modéles

Wet&Dry-Serie 1-4 final.qxd 25/3/04 9:36 AM Page 3

Assembling the Appliance · Illustrations pour le montage · Montageabbildungen · Illustrazioni di montaggio · Ilustraciones de montaje · Montaj · Onderdelen variëren al naar gelang het model · Montáž spotřebiče

A B

C* D

E F

*Feature varies according to model *Les équipements varient selon les modéles

Wet&Dry-Serie 1-4 final.qxd 25/3/04 9:36 AM Page 4

Assembling the Appliance · Illustrations pour le montage · Montageabbildungen · Illustrazioni di montaggio

· Ilustraciones de montaje · Montaj · Onderdelen variëren al naar gelang het model · Montáž spotřebiče

11*

* Feature varies according to model * Les équipements varient selon les modéles

Wet&Dry-Serie 1-4 final.qxd 25/3/04 9:36 AM Page 5

Before operating appliance for the first time

Please read through all of the information below carefully. The information provides important points for the safe use and the maintenance of the appliance. Please keep these operating instructions in a safe place and provide them to the next owner.

Part identification

1 = Collecting bin 2 = Motor block 3 = Snap fasteners 4 = Castor wheels 5 = On/Off switch 6*= Power Tool Socket 8 = Hose connection

9 = Carrying handle 10 = Mains cable 11* = Suction control 12* = Flexible hose 13* = Suction tubes 15 = Upholstery nozzle 15a*= Reduction piece 16* =

Carpet + floor nozzle 17* = Crevice Tool 18* = Drain Clearing nozzle 20 = Foam premotor filter 21 = Paper premotor filter 22 = Clamping ring 23 = Footring 24 = Dust paper bag 25* = Parking hook 26* = Suction tube – park position

* Feature varies according to model

Safety points

• HOOVER WET & DRY is intended for household use by adults.

• This product is double insulated and must not be earthed.

IMPORTANT: The wires in the power cord are coloured in accordance with the following code:

Blue-Neutral Red-Live 13 AMP FUSED PLUG ON UK MODELS ONLY.

• Do not allow nozzles and tubes (when the appliance is switched on) to come within the proximity of the head – danger for eyes and ears, for example.

• Do not vacuum noxious substances or corrosive or solvent liquids.

• Never operate the appliance in rooms where inflammable materials are stored or where gases have formed.

• Materials such as petrol, paint thinner and heating oil can form explosive gases or mixtures by being subjected to centrifugal air from the appliance.

• Never vacuum hot ash or glowing objects.

• Check before every use to be sure that you have correctly fitted the filters required for the specific application.

• Do not vacuum toner dust! Toners such as those used in printers and copiers, can be electric conductors! Furthermore, it is possible that the appliance’s filter system will not completely filter out toner dust, and in this way it can enter the air supply of the room.

• Acetone, acids and solvents can attack the materials used in this appliance.

• Extreme care is required when vacuuming stair carpets with your appliance. Ensure that the vacuum cleaner stands firmly on the step and take care that the flexible hose is not stretched beyond its actual length. When using the vacuum cleaner on stairs, always ensure that you hold the appliance steady with one hand.

• Do not leave the appliance unattended whilst it is switched on and ensure that children do not play around with the appliance.

• Always pull out the plug – if the appliance malfunctions during operation

– before cleaning and maintenance – after use – when changing the filter.

• Never unplug the appliance by pulling at the cable, but only by removing the plug directly from the socket.

• Ensure that the main cable is not exposed to either heat or chemical substances, nor that it is pulled across sharp edges or surfaces.

• Avoid using extension cables in wet rooms.

• Never repair damage to the appliance, to the

Wet&Dry-Serie 1-4 final.qxd 25/3/04 9:36 AM Page 6

Wet&Dry-Serie 1-4 final.qxd 25/3/04 9:36 AM Page 30

accessories or to the cable (special cable required); have repairs done only by an authorised customer service station, because modifications to the appliance can pose a risk to your health. Ensure that only original spare parts and accessories are used.

• Do not expose the appliance to the elements, humidity or heating sources.

• After wet vacuuming, empty the collecting bin immediately.

Unpacking the Unit

• Unpack the unit and inspect it for signs of shipping damage. Check that all items that should be included are present. Immediately notify your dealer or out customer-service department if you find any damage or if any items are missing.

• Save the original packing carton, since you can use it for storing the unit and might need it to return the unit to your dealer or a HOOVER Customer-Service Center for servicing.

Disposing of the Unit

Dispose of the appliance according to local regulations and pull out and cut off the mains cable beforehand.

Assembly

A Undo the snap-on fasteners and lift the motor

block.

B Place footring with the 4 holes to match with the

holes on the underside of tank and fix it by plugging in the fixing elements.

Push the castor wheels and the pegs into the footring until they snap into place.

C* Press snap catch (19) in the side of the motor

head and unlock.

K* Assembly float and float holder.

Dry vacuuming

After wet vacuuming, the appliance must be absolutely dry; dry off the flexible hose or tubes if necessary beforehand.

Never dry vacuum without filters or with damaged filters.

D Assemble the foam premotor filter, premotor

paper filter and clamping ring and fasten them with the locking clips.

E Press the filter bag on the suction connection

firmly and lay it against the wall of the collecting bin.

F Place the motor block on top and secure it by

means of snap-on fasteners.

G Connecting the flexible hose. Remove the hose by

turning the hose connecting piece and withdrawing the hose.

Assemble the accessories you require. Connect the mains cable.

H Turn the appliance on with the On/Off switch (5).

Suction control (11, figure J) allows you to vary the suction power.

– Sliding air trap closed = full suction power – Sliding air trap open = reduced suction power

Dependant on equipment: Appliance with plug box.

Electric tools with a rating in accordance with the rating printed on the plug box can be connecting up to the appliance plug box (6).

This plug box is ready for service as soon as the vacuum cleaner has been connected to the main voltage.

* Feature varies according to model

Wet&Dry-Serie 1-4 final.qxd 25/3/04 9:36 AM Page 7

Wet vacuuming

Always remove the filter assembly (figure D+E) before commencing wet vacuuming, since otherwise the filter assembly will be ruined. Do not forget to unplug the power cord before removing the motor housing (2) from the tank.

When vacuuming out containers in which the liquid level is higher than the top of the collecting bin and which have a larger volume than the capacity of the collecting bin, liquid can continue to be vacuumed beyond the capacity of the collecting bin if the float valve is closed.

In such cases, vacuum only in partial amounts and intermittently empty the collecting bin.

Lift the tube and flexible hose out of the liquid first and then turn off the appliance afterwards, in order to prevent an overflow of liquid.

Keep the float valve (27, fig. K) clean and accessible at all times. It automatically interrupts vacuuming when the collecting bin is full.

After completion of wet vacuuming, please clean and dry the appliance and the accessories used.

If unexpected difficulties arise

If your appliance does not operate to your satisfaction, you do not have to contact customer service straight away. Please check first as to whether the fault is due one of the following minor causes:

Dust escaping from suction sockets:

- Has the filter system been fitted in accordance with the instructions?

- Has an original HOOVER filter been used?

Gradual reduction in suction power:

- Are the pores of the paper filter bag clogged up by dust or soot?

- Is the collecting bin full?

- Is there a blockage in the nozzle, extension tube or flexible hose?/Stretch the flexible hose while the appliance is switched on – this will loosen the obstruction.

Water is coming out of the air expulsion openings of the appliance during vacuuming:

- Is the float (figure K) blocked when vacuuming liquid and unable to operate?

Sudden reduction in suction power

- Has the float stopped the flow of air? This can happen if the appliance is standing at a slant or if the appliance falls over. Turn off the vacuum cleaner – the float will fall back into place – the appliance is ready for use again.

The motor does not function:

- Is there damage to the mains cable, plug or socket?

- Pull out the plug before checking.

- Never open the motor yourself!

Customer Service:

To obtain approved HOOVER service and genuine HOOVER parts, please call: Gias Customer Service 08705400600 or your nearest Hoover Service Centre. Ensure that all service and repairs are carried out by an authorised Hoover Service Engineer.

Use only genuine Hoover spare parts. Always identify your cleaner by the complete model number when requesting information or ordering parts. (The model number appears on the back of the cleaner body.)

HOOVER LTD Pentrebach, Merthyr Tydfil, Mid-Glamorgan CF48 4TU Gias Customer service 08705 400600 Hoover Spares 01204 556111

Guarantee

Your new appliance is fully guaranteed for 12 months against electrical/mechanical breakdown excluding:

a) Any faults which occur due to incorrect

installation or misuse of the machine or accidental damage.

b) Repair of, or interference with the machine by

any person not authorised by the manufacturer to carry out service.

c) Any parts which are fitted to the machine

which are not original manufacturers parts. d) Non-domestic use of the machine. e) Operation at incorrect voltage.

The guarantee applies to Great Britain and Northern Ireland only. The aforegoing does not affect your statutory rights.

Wet&Dry-Serie 1-4 final.qxd 25/3/04 9:36 AM Page 8

+ 21 hidden pages