®
USER MANUAL
IMPORTANT SAFETY REMINDERS
This appliance should only be used for domestic cleaning, as
described in this user guide. Please ensure that this guide is
fully understood before operating the appliance.
cigarette ends or other similar items.
Do not spray with or pick up flammable liquids, cleaning fluids,
aerosols or their vapours.
Do not run over the power cord when using your appliance or
remove the plug by pulling on the power cord.
Do not leave the appliance plugged in. Always switch off and
remove the plug from the socket after use, or before cleaning
the appliance or any maintenance task.
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
If the power cord is damaged stop using the appliance
immediately. To avoid a safety hazard, an authorised Hoover
service engineer must replace the power cord.
Keep hands, feet, loose clothing and hair away from rotating
brushes.
Use only attachments, consumables or spares recommended
or supplied by Hoover.
When using cleaning tools ensure that the appliance is kept in
the upright (parked) position. This will avoid possible damage
to the carpet or floor covering. When cleaning stairs, do not
position the appliance above you.
Static electricity: some carpets can cause a small build up
of static electricity. Any static discharge is not hazardous to
health.
Do not use your appliance out of doors or on any wet surface
or for wet pick up.
Do not continue to use your appliance if it appears faulty.
Hoover service: To ensure the continued safe and efficient
operation of this appliance we recommend that any servicing
or repairs are only carried out by an authorised Hoover service
engineer.
Do not stand on or wrap the cord around arms or legs when
using your appliance.
Do not use the appliance to clean animals or people.
When using the cleaning tools, ensure to always steady the
appliance with your other hand. This will ensure that the
appliance does not fall while in use.
WARNING: A thermal cut out switches off the appliance to prevent overheating
if it is used when full or there is a blockage or dirty filters. If this should
happen then switch off, unplug and correct the fault. It will take approximately
45 minutes for the cut out to automatically reset.
The Environment
The symbol on this appliance indicates that this appliance may not
be treated as household waste. Instead it must be handed over to the
applicable collection point for the recycling of electrical and electronic
equipment. Disposal must be carried out in accordance with local
environmental regulations for waste disposal. For more detailed
information about treatment, recovery and recycling of this appliance, please
contact your local city office, your household and waste disposal service or
the shop where you purchased the appliance.
This appliance complies with the European Directives 2006/95/EC,
2004/108/EC and 2011/65/EU.
Do not pick up hard or sharp objects, matches, hot ashes,
HOOVER Limited, Pentrebach, Merthyr Tydfil, Mid Glamorgan, CF48 4TU, UK
- 2 -
GETTING TO KNOW YOUR CLEANER
Effortless
cleaning
with your
new Hoover
This vacuum cleaner is
supplied with an Energy Label
as required by European
Regulation (EU) 665/2013.
REMOVABLE
HANDLE
BIN RELEASE
DUST
CONTAINER
WASHABLE
HEPA FILTER
EXHAUST
FILTER COVER
CARPET CARE
CONTROL
SELECTOR
CORD
CLIP
HANDLE
RELEASE
HOSE
CORD STORAGE
HOOK
POWER CORD
CREVICE TOOL /
DUSTING BRUSH
HOSE
CONNECTOR
CLEANER
RELEASE
PEDAL
ON/OFF
BUTTON
* Certain models only
- 3 -
PARQUET
NOZZLE*
PET HAIR &
ALLERGEN
REMOVER*
PREPARING YOUR CLEANER
3
4
1
2
5
CARPET CARE CONTROL SELECTOR
CLEANER RELEASE
Insert the removable handle into the body
of the cleaner.
CORD CARE
Place the power cord in the cord
storage clip whilst in use. This will
prevent any accidental damage to the
power cord.
DO NOT vacuum over the power cord.
CARPET CARE CONTROL SELECTOR
Ensure that the cleaner is in the upright (parked)
position and move the selector to the required
setting for the carpet type or oor covering.
To obtain the best performance and energy
efciency
#1
it is recommended that the adjustment
setting position 1 is used for the main cleaning
operations. The other adjustment settings are
for ease of use, use on longer pile carpets, or for
specialist cleaning tasks.
Settings
1. Best performance and energy efciency, short to
medium pile carpets, hard wooden oors, wooden
oor boards with crevices, ceramic tiles.
2. Medium pile carpets, delicate oor coverings
such as vinyl or linoleum, parquet ooring.
3 or 4. For longer pile carpets the motion
resistance may increase. Use these intermediate
settings to reduce the force required to push the
vacuum cleaner.
5. Luxury carpet and Tool mode
IMPORTANT: Using this cleaner for loop pile
carpets with pile greater than 30mm is not
recommended. Please consult the oorcare/carpet
manufacturer’s recommended cleaning instruction
before vacuuming.
IMPORTANT: When cleaning delicate hard oors
such as vinyl or linoleum the selector switch must
be moved to position 2. Failure to do so may cause
damage to the oor surface.
Unlock the cleaner by pressing down on the pedal
with your foot.
POWER SWITCH
To switch the cleaner on or off press down on the
pedal with your foot.
The carpet care control selector raises and lowers
the height of the nozzle.
Label as required by European Regulation (EU)
665/2013. If the label shows a red prohibition
circle on the right covering the hard oor symbol,
then this indicates that the vacuum cleaner is not
suitable for use on hard oors.
This vacuum cleaner is supplied with an Energy
#1
NOTE: Dust pick up ability carpet, dust pick up
ability hard oor, and energy efciency in accord
with Commission Regulations (EU) 665/2013 and
(EU) 666/2013.
* Certain models only.
- 4 -
CLEANING TOOLS*
Removable Handle
Fitted onto the exible hose with the various accessories attached, this creates an ideal solution for stairs and
overhead cleaning.
Pet Hair & Allergen Remover*
The pet hair & allergen remover is ideal for removing pets hairs.
DO NOT touch the rotating brush.
Parquet Nozzle*
The parquet nozzle is ideal for cleaning delicate surfaces.
All accessories can t onto the end of the exible hose or end of the removable handle. Combine accessories
depending on use.
Remove the handle. Remove hose from the foot. Attach hose to the handle end
1
2
3
of the removable handle.
CLEANING THE STAIRS
It is dangerous to place the
cleaner above you when cleaning
stairs.
ALWAYS work with the cleaner
below you. Ensure it is positioned
up against the bottom step.
STORING THE CLEANER
Turn the cleaner off and remove the plug. Wind the
power cord around the cord storage hooks.
Attach crevice tool to the end of
4
the removable handle.
!
* Certain models only
Rotate the end piece of the
5
crevice tool to use the dusting
brush.
IMPORTANT! When using cleaning tools, the cleaner must be kept in the upright position,
particularly when cleaning stairs. The nozzle height should also be set to tool mode.
Fit the pet hair & allergen
6
remover* and parquet nozzle*.
- 5 -
EMPTYING THE DUST CONTAINER
1
To remove the dust container from the
cleaner press the bin release button.
CLEANING THE PRE MOTOR FILTERS
Hold the container over
2
the bin and press the bin
open button .
The dust container door
43
will open and you can
empty with no contact
with the dust.
Once emptied, gently tap
44
or shake the container to
release any excess dust
from the filters.
Rotate the upper part of the
1
dust bin to open.
Gently tap both lters to release any
4
excess dust.
!
IMPORTANT! Ensure the mesh sleeve is
reassembled to the HEPA lter before use
2
CLEANING THE EXHAUST FILTER
The exhaust filter should be washed every month.
Press down on the latch to remove the exhaust cover.
Remove filter and wash with warm water.
Remove excess water by shaking and leave to dry for
24 hours. Refit filters only when completely dry.
Remove the lter assembly
from the upper part.
Wash both lters under hand warm water until the
5
water runs clean. Remove excess water by shaking
and leave to dry for 24 hours.
When completely dry reassemble and refit filters to
cleaner.
Remove the mesh lter from
3
the lter assembly.
- 6 -
CHANGING THE BELT OR BRUSHES CLEARING A BLOCKAGE
If your cleaner is not picking up efciently, the belt or brushes (or both) may need replacing, but rst please make
sure you have:
• Emptied the dust container
• Cleaned the lters
• Checked for blockages
Turn the cleaner over and
1 4
remove 6 retaining screws
attaching the brush guard
to the base.
Remove the brush guard
2
IMPORTANT: Switch the cleaner off and
remove the plug from the electricity supply
before dismantling cleaner
Hold the brush assembly and
stretch the belt until the brush
can be slotted back into
the cleaner housing.
Rotate the brush to ensure
5
movement of the belt.
IMPORTANT: Switch the cleaner off and
remove the plug from the electricity supply
before dismantling cleaner
If cleaning tools were
in use check the
cleaning tool and the
removable handle.
Check the hose by
removing it from the
cleaner, stretching it to
full length .
Turn the cleaner
over and rotate the
brushes until they
are free to rotate.
Remove brush assembly and
3
check for wear on the belt.
Loop the new belt around
the motor and brush
channel.
* Certain models only.
Refit the brush guard with 6
6
retaining screws.
Check for a blockage in
the hose socket. Use a
flexible rod to remove
any obstruction.
Removing a blockage from
the Pet hair & allergen
remover.
Open the nozzle at each
side, lift cover and remove
the blockage.
*Certain models only.
- 7 -
User checklist
If your cleaner is not working properly run through the
following checklist.
1. Is there a working electricity supply to the cleaner?
Check with another electrical product.
2. Is the dust container full or choked with fine dust?
To empty the dust container, see instructions on P6.
3. Is the hose blocked?
To clear a blockage, see instructions on P7.
4. Is there a blockage in the cleaner base?
To clear a blockage, see the instruction on P7.
5. Are the filters blocked?
To clean filters, see the instruction on P6.
6. Is the nozzle height set correctly?
To set the carpet height selector, see the instruction on p4.
7. Are the brushes rotating correctly?
To check the brushes, see the instructions on p7.
8. Has the cleaner overheated?
If so, it will take about 30 minutes to reset.
If there is any doubt call the Hoover Service Office for advice. They may be able
to assist you over the telephone. A service charge will be made if the cleaner is
examined and found to be in working order, has not been assembled in
accordance with these instructions or has been used incorrectly. working order,
has not been assembled in accordance with these instructions or has been used
incorrectly.
IMPORTANT INFORMATION
Hoover Service
Should you require service at any time, please contact your local Hoover Service Ofce.
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering parts always quote your model number.
USE ONLY HOOVER SPARES
SPARE PARTS CODE
WASHABLE HEPA FILTER S88 - 35600740
EXHAUST MICROFILTER T94 - 35600741
AGITATOR Y203E - 35601614
BELT V201E -35601616
HOSE D100 - 35600745
PET HAIR AND ALLERGEN REMOVER J30 - 35600742
PARQUET NOZZLE G101PC -35600887
Quality
WARNING!
A thermal cut out switches off the cleaner to prevent overheating if it is used when
full or there is a blockage or dirty filters. If this should happen switch off, unplug and
correct the fault.
It will take about 45 minutes for the cut out to automatically reset.
IMPORTANT: Do not run cleaner over the supply cord as this could damage the
supply cord insulation.
Hoover’s factories have been independently assessed for quality. Our products
are made using a quality system which meets the requirements of ISO 9001
GUARANTEE STATEMENT
The guarantee conditions for this appliance are as defined by our representative in
the country in which it is sold. Details regarding these conditions can be obtained
from the dealer from whom the appliance was purchased. The bill of sale or receipt
must be produced when making any claim under the terms of this guarantee.
Subject to change without notice.
- 8 -
®
Hoover Limited
Pentrebach
Merthyr Tydl
Mid Glamorgan
CF48 4TU
HOOVER CUSTOMER HELPINE
08444 995 599
© 2014 48011579/01
Loading...