Hootoo HT-IP212HDP User Manual

IP CAMERA

Model: HT-IP212HDP

Advanced User Manual

For MAC

For MAC

1.Access the IP Camera

1.1 Wired Mode

1) Please find the IPCamSearch software in the Resource CD, and
copy it to your local drive.

2) Make sure the camera is connected to your router via network cable

3) Open IPCamSearch from your local drive

4) Locate your camera’s IP address:

5) Select the IP address and double click on it. This will lead you
to HT-IP212HDP web setting page

6) Login with default Username “admin” and Password “admin”

7) Once logged in, you should be able to see the live video at home page.

1.2 Wireless Mode

1) After login the web setting page, click on “ ” at the
top of the page

2) Click “Network Settings”, then click “Wireless” to scan nearby
wireless network

3) Select the wireless network you wish to connect to. Enter the
password, and then click “Save”

01/02

5) Select the IP address and double click on it. This will lead you
to HT-IP212HDP web setting page

6) Login with default Username “admin” and Password “admin”

7) Once logged in, you should be able to see the live video at home page.

1.2 Wireless Mode

1) After login the web setting page, click on “ ” at the
top of the page

2) Click “Network Settings”, then click “Wireless” to scan nearby
wireless network

3) Select the wireless network you wish to connect to. Enter the
password, and then click “Save”

4) After the progress bar finish, wait about 60 seconds for device
to restart

5) Once restart finished, pull out the network cable from the
connected camera

6) Open the Search IPCam Tool software again. It may take up to 10
seconds for searching the result.

7) Double click on the new IP address. This will lead you to the login
page of the HT-IP212HDP web setting page in your default browser.

8) Use the default username and password “admin” to login

9) If a WebCMS add-in pops up, please allow the computer to run it:

10) Now you have setup the camera in Wi-Fi mode

Note:

• When you fill in Wi-Fi password, please note that there should be no
special characters ( such as < > ‘ ’)

• If you fail to find the camera’s IP address while other IP addresses
show normally after searching, please fill in the SSID manually

• If the camera gets offline once you unplug the network cable, please
open your router’s webpage and then make proper settings.

03/04