Hooker Furniture 57517590699 Assembly Guide

Diagram 1

Diagram 2

ALLEMBLY INSTRUCTION

(for connecting the wire of the light on this cabinet)

Item# 5751-75906-99 Display Cabinet

*** Caution: Please read all instructions carefully before starting the assembly process.

Please note this cabinet can be used alone with can light on by a touch dimmer. Also, when
two or more are bunched together, you can control all can lights by touching one dimmer.

Assembly Steps:

1. When each piece of cabinet is used alone, attach male connector of the power switch
(A) to a wall plug. (See Diagram 1)

1/2

Diagram 3

2. Touch dimmer is at the inside of right post.

3. If you want to bunch two or more cabinets together, place them all side by side in a
desired location.

4. Leave male connector of the can light (C) and female connector of power switch (B)
for the first cabinet (#1) as it is. Keep male connector of the can light (C) and female
connector of power switch (B) off for the rest cabinets (#2, #3, and so on). (See
Diagram 2)

5. Connect female connector of the can light (D) (#1 cabinet) with male connector of
power wire (E), then have female connector of power wire (F) connected to male
connector of the can light (C) (the #2 cabinet). (See Diagram 3)

Cleaning instruction: Clean finished parts with a mild dishwashing liquid and water solution on a damp
cloth. Polish the finish with soft cloth and an industry recognized furniture polish.

6. Repeat step 5 for the 3rd cabinet and the rest of ones when more than two are
bunched together till each one is connected.

7. Plug in male connector of power switch (A) (#1 cabinet).

8. Touch the dimmer of the #1 cabinet, all can lights connecting together will be on at
the same time.

2/2