Hooker Furniture 575075401LTWD Assembly Guide

ASSEMBLY INSTRUCTION

1/3

Item#:5750-75401-LTWD Metal Back Arm Chair

** Please make sure you have all parts indicated below prior to assembly.

Assembly Steps:

Diagram 1 Diagram 2

2/3

Diagram 3

There are two K/D chairs in one box.Please follow numbers on one chair and letters on the other
chair during assembly.

1. Place chair back (G) on a clean surface.

2. Tighten seat frame (L) to chair back (J) by using bolts (F), lock washers (B) and flat washers (C) at the
center location with allen wrench(D) (see diagram 2). Then tighten seat frame (L) to chair back (J) by
using bolts (A), lock washers (B) and flat washers (C) at the corner blocks with allen wrench(D) (see
diagram 1).

3. Please follow numbers on legs(N) and corner blocks. Assemble front legs (N) onto front corner blocks

of seat frame (L),using bolts(F), lock washer(B) and flat washers (C).Tighten all bolts by hand.(See
diagram 2)

4. Tighten center stretcher to side stretcher .then connect front legs(N) with chair back (J) by stretcher (M)

using screws (E) (See diagram 2) .

5. Attached chair arms (K) to seat frame (L ) by using bolts (G), lock washers (B) and flat washers (C).

Tighten all bolts by allen wrench (D). (See diagram 3)

6. Attached chair arms (K) to chair back(J)by using bolts (G), lock washers (B) and flat washers (H).

Tighten all bolts by allen wrench (D). (See diagram 3) .Then Insert wood plugs(I). (See diagram 3)

7. After all bolts are attached and hand tightened, turn the chair upright.

8 Level the chair following the “chair leveling instruction” as below.

9. Make sure the chair is level and then tighten all bolts completely by using allen wrench (D).

2/3