Hooker Furniture 507090008, 507090002 Assembly Guide

ASSEMBLY INSTRUCTIONS

Diagram

2

Item#: 5070-90008 MIRROR
Item#: 5070-90002 DRESSER

** Please make sure you have all parts indicated below prior to assembly.

This unit is heavy and can best be assembled with the help of two or more persons.

Diagram 1

Assembly Steps:

1. Place the mirror on top of the dresser. Be sure to position the mirror in the middle of the top.
The back bottom edge of the mirror and the back edge of the top should be flushed.

2. Attach a mending plate (E) at back of mirror and back of dresser. Align holes on mending plate
to the pre-drilled holes at the back of dresser and tighten 4pcs of screws (F) through the holes.
Tighten another 4 screws at random location through mending plate to mirror frame with care.
(See Diagram 1)

3. Repeat step 2 for another mending plate (E).

1/2

Note: The mirror can be hung to the wall alone by following steps below:

1. Drill two holes into the wall using 1/4”drill bit and insert the plastic anchors (D).

2. Screw hook (C) into plastic anchor (D). Check and make sure the plastic anchor (D) is

securely held in the wall.

3. Set mirror in place and hang the metal rings attached at back of mirror on to the hook (C) (See

diagram 2).

Cleaning Instruction: Clean finished parts with a damp cloth using a mild dishwashing liquid and water
solution. Polish the finish with soft cloth and an industry recognized furniture polish.

2/2