Hooker Furniture 36675218 Assembly Guide

ASSEMBLY INSTRUCTION

Item#: 366-75-218 ROUND TOP LEAF PED TABLE W/2-10” LEAVES

** Please make sure you have all parts indicated below prior to assembly.

Diagram 1 Diagram 2 Diagram 3

Assembly Steps:

1. Align locator dowels at the table post top to the holes in the mending bridge panel, attach them
using 2 bolts(E), 2 lock washers(B), 2 flat washers(A), by turning with allen wrench(D) in a
clockwise direction. (see diagram 1).

2. Align locator dowels at the bottom of table post to holes in base, attach them using 2 bolts(E), 2
lock washers(B), 2 flat washers(A), by turning with allen wrench(D) in a clockwise direction.
(see diagram 2).

3. Put table top upside down on a soft surface to prevent from scratching top, attach the

assembled base to top using 4 bolts(E), 4 lock washers(B), 4 flat washers(A), by turning with
allen wrench(D) in a clockwise direction. (see diagram 3).

4. Turn table upright, lift up the drop down leaf on each side and pull out the support lid under it

for supporting.

Caution: Do not over tighten.

Cleaning Instruction: Clean finished parts with a damp cloth using a mild dishwashing liquid and water solution.
Polish the finish with soft cloth and an industry recognized furniture polish.