Page 1
1/3
ASSEMBLY INSTRUCTION
ITEM#1610-90151-EGLO 5/0 Mirrored Panel Headboard
1610-90152-EGLO 5/0 Mirrored Panel Footboard
1610-90167-EGLO 6/0-6/6 Mirrored Panel Headboard
1610-90168-EGLO 6/0-6/6 Mirrored Panel Footboard
1610-90153-EGLO 5/0-6/6 Rails
1610-90163-EGLO 6/0 Rails
Caution: Please make sure you have all parts indicated below prior to assembly.
This unit is heavy and can best be assembled with the help of two or more persons.
Diagram 2
Diagram 5
Diagram 1
Diagram 3
Page 2
2/3
Please note the hardware bag to assemble side rails to HB&FB is in the box of side rails.
Assembly steps:
1. Insert 2 bolts (H) into holes of each side post on Headboard (A) and Footboard (B), attach the end of
side rails (C) to bolts (H) on posts using 2 curved washers (G)and 2 nuts (E), tighten nuts (E) securely
with spanner wrench (F). (See diagram 1)
Diagram 1
2. Take out center supports (L) from the rail box, attach center supports (L) to slats using 2 bolts (Q),
2 lock washers (V) and 2 flat washers (U). Secure bolts (Q) by using allen wrench (R). (See
diagram 2)
D
L
R
Q
V
U
Diagram 2
3. Attach slats (D) to side rails (C), align pre-drilled holes on the slat to holes on the cleat of side rail
(C), using screws (K) to tighten both. (See diagram 3)
D
k
C
Page 3
3/3
Diagram 3
Note: You can change the height of slat by adjusting the height of cleat on side rail as shown in
diagram 4. Remove bolt (I), lock washer (W) and flat washer (J) from the cleat by turning the bolt
(I) with allen wrench (M) in anti-clockwise direction. Adjust the cleat to a desired position, and
then secure lock washer, flat washer, bolt in a clockwise direction by turning with Allen wrench.
。
Diagram 4
You can adjust the height of center supports (L) as shown in Diagram 5 to meet your need by the
following steps.
1. Unscrew bolts on center supports (L) with Allen wrench (R).
2. Adjust the height of center supports, align the holes on 2pcs of woods and tighten them together
with 2 bolts(Q), 2 lock washers (V) and 2 flat washers（U）by turning with allen wrench(R) in a
clockwise direction.
D
L
V
R
Q
U
Diagram 5
Cleaning Instruction: Clean finished parts with a mild dishwashing liquid and water solution on a damp
cloth. Polish the finish with soft cloth and an industry recognized furniture polish.
Loading...