Honic HN-IRDN200F User Manual

USER MANUAL

HN-IRDN200F

1080P AHD/CVI/TVI/960H

Hybrid Dome Camera

Product Description

The HN-IRDN200F is a high-definition camera designed around
a 1/2.7" Color 2.0 megapixel CMOS image sensor, 14µ x 18pcs
IR LEDs providing infrared capability up to 65 feet, and a

3.6mm lens with wide angle field of view of 90 degrees.

Notice Before Using

Default Mode: 1080P AHD Video Output.

If your DVR is TVI, CVI or Analog DVR, please switch the
corresponding video output mode by OSD joystick.

POWER ON the camera, switch the video output mode by OSD
joystick according to your DVR video type:

 LEFT Push 5s to 960H mode for analog DVR.
 RIGHT Push 5s to TVI mode for 1080P TVI DVR or XVR.
 DOWN Push 5s to CVI mode for 1080P CVR or XVR.
 UP Push 5s to AHD mode for 1080P (N) AHD DVR or

XVR.

OSD

Note: 5s means 5 seconds

Installation and Operation:

1. Unpacking and Handling

Each unit is shipped assembled and factory tested.
Ensure that all accessories are removed from the container
before discarding packing material.

Package includes

1x dome camera
4x mounting screws
4x screw anchors
1x install guide
1x user manual
1x drill template
1x Allen wrench

2. Mechanical Inspection

Inspect the front and rear of the equipment for shipping
damage. Make sure the equipment is clean, and no connectors

are broken, damaged, or loose. If equipment appears to be
damaged or defective please contact us for assistance.

3. Special Attention

(i) The installer must comply with electrical safety standards.

There must be sufficient space between the camera's
power supply and video line and any high voltage
equipment and/or cables.

(ii) To help ensure the camera's life and proper operation do

not point the camera towards the sun or strong light.

(iii) Do not install the camera in an environment where the

temperature is too high or too low, recommended operating
temperature is 14F ~ 122F.

(iv) Do not install the camera near a magnetic field or a high-

power motor.

(v) Only use a dry cloth to clean the camera. If there is dirt that

is difficult to remove, wipe gently with a mild detergent.
Never use strong or abrasive detergents.

(vi) A 12V DC 1A or 2A power supply must be used. AC power

cannot be applied. AC power will damage the camera and
void warranty. Power supply output voltage, current,

voltage polarity and operating temperature must match
requirement of this equipment.

(vii) Only qualified installers are allowed to install, test and

disassemble the camera.
(viii) Any change to the camera's lens will affect image quality.
(ix) The camera is a low voltage product. If installed outdoors,

proper safety and lightening grounding are required.

4. Wiring Connections

(i) Connect the power supply's DC plug to the camera's power

outlet.
(ii) Connect the camera to the DVR with a 75Ω coaxial video

cable.
(iii) Connect power supply's AC plug to a suitable AC power

outlet.
(iv) Adjust the lens direction according to the required

surveillance area and environment.

Note: Before connecting the power supply, please check its

output voltage (12V).