HON HAI PRECISION IND T60H67703 Users Manual

U S E R ’ S M A N U A L

T60H677

Mini-PCI Type IIIB 802.11a/b WLAN CARD

Ambit Microsystems Corporation

5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C.

TEL: [phone], FAX: [phone], Internet: http:\\www.ambit.com.tw\

中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之

886-3-5784975

電話

，傳真：

國碁電子(股)公司

886-3-5782924

1

Contents

SECTION ONE: INTRODUCTION............................................................................................1

1-1

1.1.1 W

1-2 FCC N

1.2.1 FCC C

1.2.2

F

EATURES

IRELESS

FCC C

.............................................................................................................................. 1

LAN F

UNCTION

.......................................................................................................................... 3

OTICE

OMPLIANCE

LASS

.........................................................

B S

TATEMENT

.................................................................................................... 1

RROR! BOOKMARK NOT DEFINED.

E

...........................................ERROR! BOOKMARK NOT DEFINED.

SECTION TWO: WIRELESS LAN INSTALLATION ..............................................................6

2-1 S

YSTEM REQUIREMENTS

2-2 I

NSTALLATION AND UNINSTALL PROCESS

................................................................................................................6

......................................................................................6

SECTION THREE: WIRELESS UTILITY AND CONFIGURATION.................................. 14

3-1 W

INDOWS

98/ME/2000 W

IRELESS UTILITY

................................................................................ 14

SECTION FOUR: WINDOWS XP WIRELESS UTILITY AND CONFIGURATION.......... 22

4-1 W

INDOWS

XP W

IRELESS UTILITY

............................................................................................... 22

APPENDIX A GLOSSARY ............................................................................................................... 29

The information contained in this manual has been verified at the time of this manual printing. The
manufacturer reserves the right to make any changes and improvements in the product described in this
manual at any time and without notice.
All registered trademarks are the property of their respective owners.

Ambit Microsystems Corporation

國碁電子(股)公司

5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C.

TEL: [phone], FAX: [phone], Internet: http:\\www.ambit.com.tw\

中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之

886-3-5784975

電話

，傳真：

886-3-5782924

1

Section One: Introduction

Ambit Wireless Mini-PCI Module complied with IEEE 802.11a/b Standard, it can be
used to provide a variety of low-cost wireless network interface card to connect your
wireless LAN via fitting into the Mini-PCI Type III slot. The Wireless Mini-PCI
Module that complies with this specification and combines networking with high­speed Internet access will let people connect to the Internet anywhere, anytime.

With seamless roaming, fully interoperability and advanced security with WEP
standard, Wireless Mini-PCI Module can allow user to switch to different vendors’
Access Points through the wireless networks and to prevent from eavesdropping.

1-1 Features

1.1.1 Wireless LAN Function

802.11a

Wireless LAN Compliance

Operating Frequency

5.725~5.825GHz (high band) for US

Modulation Schemes

WLAN Data Rat

Media Access Protocol

Transmitter Output Power

5.15~5.25GHz (lower band) for US/Canada/Japan

OFDM, QPSK, BPSK,16-QAM and 64-QAM

e 54Mbps with fall back rates of 48, 36, 24, 18, 12, 9,

CSMA/CA with ACK

IEEE 802.11a

5.25~5.35GHz (middle band) for US/Canada

and 6Mbps

Typical 12 dBm for 54, 48Mbps of 5.15 to 5.35GHz

Typical 12 dBm for 48Mbps of 5.725 to 5.825GHz

Receiver Sensitivity

Ambit Microsystems Corporation

5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C.

TEL: [phone], FAX: [phone], Internet: http:\\www.ambit.com.tw\

中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之

886-3-5784975

電話

Typical 10 dBm for 54Mps of 5.725 to 5.825GHz

Typical 15 dBm for 36, 24, 18, 12, 9, 6Mbps

UNII low and middle band (5.15 to 5.35GHz)

Typical –70 dBm for 54Mbps @ 10% PER

1

，傳真：

國碁電子(股)公司

886-3-5782924

Typical –72 dBm for 48Mbps @ 10% PER

Typical –78 dBm for 36Mbps @ 10% PER

Typical –81 dBm for 24Mbps @ 10% PER

Typical –83 dBm for 18Mbps @ 10% PER

Typical –85 dBm for 12Mbps @ 10% PER

Typical –87 dBm for 9Mbps @ 10% PER

Typical –87 dBm for 6Mbps @ 10% PER

UNII high band (5.725 to 5.825GHz)

Typical –63 dBm for 54Mbps @ 10% PER

Typical –71 dBm for 48Mbps @ 10% PER

Typical –78 dBm for 36Mbps @ 10% PER

Typical –81 dBm for 24Mbps @ 10% PER

Typical –83 dBm for 18Mbps @ 10% PER

Typical –85 dBm for 12Mbps @ 10% PER

Typical –87 dBm for 6Mbps @ 10% PER

Current Consumption

330mA at receive mode (typically)

Typical –87 dBm for 9Mbps @ 10% PER

600mA at transmit mode (typically)

20mA at normal power saving mode (typically)

10mA at maximum power saving mode (typically)

802.11b

Radio Technology

Operating Frequency

Modulation Schemes

Channel Numbers

11 channels for United States

IEEE 802.11b Direct Sequence Spread Spectrum

2412 ~ 2462MHz ISM band

DQPSK, DBPSK and CCK

IEEE 802.11b compliant

13 channels for Europe Countries

Ambit Microsystems Corporation

5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C.

TEL: [phone], FAX: [phone], Internet: http:\\www.ambit.com.tw\

中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之

886-3-5784975

電話

，傳真：

國碁電子(股)公司

886-3-5782924

1

14 channels for Japan

Data Rate

Spreading

Media Access Protocol

Transmitter Output Power

Receiver Sensitivity

Typical –85dBm for 5.5Mbps @ 8% PER

Typical –90dBm for 1Mbps @ 8% PER

Current Consumption

350mA at receive mode (typically)

11Mbps with fall back rates of 5.5, 2, and 1Mbps

11-chip Barker Sequence

CSMA/CA with ACK

15dBm typically

Typical –83dBm for 11Mbps @ 8% PER

Typical –86dBm for 2Mbps @ 8% PER

500mA at transmit mode (typically)

40mA at normal power saving mode (typically)

30mA at max power saving mode (typically)

1-2 FCC Notice

U.S. Regulatory Wireless Notice

This device complies with Part 15 of the FCC Rules. This product emits radio
frequency energy, but the radiated output power of this device is far below the
FCC radio frequency exposure limits. Nevertheless, the device should be
used in such a manner that the potential for human contact with the antenna
during normal operation is minimized.

This device is intended only for OEM integrators under the following

conditions:

1) The antenna must be installed such that 20 cm is maintained between the

antenna and users. For laptop installations, the antenna must be installed to

ensure that the proper spacing is maintained in the event the users places the

device in their lap during use (i.e. positioning of antennas must be placed in

the upper portion of the LCD panel only to ensure 20 cm will be maintained if

the user places the device in their lap for use) and

2) The transmitter module may not be co-located with any other transmitter or

Ambit Microsystems Corporation

5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C.

TEL: [phone], FAX: [phone], Internet: http:\\www.ambit.com.tw\

中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之

886-3-5784975

電話

，傳真：

國碁電子(股)公司

886-3-5782924

1

antenna.

End Product Labeling

This transmitter module is authorized only for use in devices where the

antenna may be installed such that 20 cm may be maintained between the

antenna and users (for example access points, routers, wireless ASDL

modems, certain laptop configurations, and similar equipment).

The final end product must be labeled in a visible area with the following: "

FCC ID: MCLT60H67703"

Additional Information That must be Provided to OEM Integrators

The end user should NOT be provided any instructions on how to remove or

install the device.

USA Radio Frequency Interference Requirements

FCC Regulations Part 15 Declaration of Conformity (DoC)

Ambit Microsystems Corporation declares that the equipment described in this

document is within the requirements of the Code of Federal Regulations listed

below:

Title 47 Part 15, Subpart B, Class B for a digital device.

This declaration is based upon the compliance of the Wireless LAN Mini PCI

Adapters to the above standards. Ambit has determined that the models listed

have been shown to comply with the applicable technical standards if no

unauthorized change is made in the equipment and if the equipment is

properly maintained and operated. The hardware or software can not be

replaced or modified by any third party other than Ambit. Changes or

modifications not expressly approved by Ambit could void the user’s authority

to operate the equipment.

These units are identical to the units tested and found acceptable with the

applicable standards. Records maintained by Ambit continue to reflect that

units being produced under this Declaration of Conformity, within the variation

Ambit Microsystems Corporation

5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C.

TEL: [phone], FAX: [phone], Internet: http:\\www.ambit.com.tw\

中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之

886-3-5784975

電話

，傳真：

國碁電子(股)公司

886-3-5782924

1

that can be expected due to quantity production and tested on a statistical

basis, continue to comply with the applicable technical standards.

Ambit Microsystems Corporation

5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C.

TEL: [phone], FAX: [phone], Internet: http:\\www.ambit.com.tw\

中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之

886-3-5784975

電話

，傳真：

國碁電子(股)公司

886-3-5782924

1

Section Two: Wireless Lan Installation

2-1 System Requirements

In order to install Wireless LAN driver and Utility and use the Wireless LAN card in your notebook computer.

Your notebook system must meet the following requirements:

Ambit Mini-PCI Wireless LAN Card already inserted



Windows 98SE,2K,ME,XP OS Support



2-2 Installation and Uninstall Process

Install Wireless LAN (Windows 98/2K/ME/XP)

1. While starting the Windows system, if it detect the 802.11a/b card exist, then it will pop

up the following message to start Install process.

Or you can execute the program ‘Setup.exe’ in the CD. Windows displays the dialog as
below. Press ‘Next’ button to continue.

Ambit Microsystems Corporation

5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C.

TEL: [phone], FAX: [phone], Internet: http:\\www.ambit.com.tw\

中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之

886-3-5784975

電話

，傳真：

國碁電子(股)公司

886-3-5782924

1

It displays a License Agreement dialog. Press ‘

2.

’ to continue.

Yes

Ambit Microsystems Corporation

5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C.

TEL: [phone], FAX: [phone], Internet: http:\\www.ambit.com.tw\

中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之

886-3-5784975

電話

，傳真：

國碁電子(股)公司

886-3-5782924

1

3.

Select the destination folder that you want to place the files.

Wait for the install program to do the installation.

4.

Ambit Microsystems Corporation

5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C.

TEL: [phone], FAX: [phone], Internet: http:\\www.ambit.com.tw\

中華民國臺灣省新竹縣新竹科學園區新安路5號5樓之

886-3-5784975

電話

，傳真：

國碁電子(股)公司

886-3-5782924

1