HON HAI PRECISION IND T60H563 Users Manual
U S E R ’ S M A N U A L
T60H563
MiniPCI WLAN/Bluetooth Combo Module
Ambit Microsystems Corporation
5F-1, 5 Hsin-An Rd., Hsinchu Science-Based Industrial Park, Hsinchu, Taiwan, R.O.C.
TEL: 886-3-5784975, FAX: 886-3-5782924, Internet: http:\\www.ambit.com.tw\
1
Contents
SECTION ONE: INTRODUCTION................................................................................................. 1
FEATURES .....................................................................................................................................1
1.1
1.1.1
WIRELESS LAN FUNCTION ........................................................................................................1
1.1.2
BLUETOOTH FUNCTION ...................................................... ERROR! BOOKMARK NOT DEFINED.
1.2
PACKAGE CONTENTS ..................................................................................................................... 3
SECTION TWO: BLUETOOTH INSTALLATION.......................................................................... 3
DRIVER INSTALLATION ................................................................................................................. 3
2.1:
2.2:
AT COMMANDS .................................................................... ERROR! BOOKMARK NOT DEFINED.
2.3:
S-REGISTERS ........................................................................ ERROR! BOOKMARK NOT DEFINED.
2.4:
RESULT CODE SUMMARY ..................................................... ERROR! BOOKMARK NOT DEFINED.
2.5:
FCC NOTICE ......................................................................... ERROR! BOOKMARK NOT DEFINED.
2.5.1
FCC COMPLIANCE ............................................................... ERROR! BOOKMARK NOT DEFINED.
2.5.2
FCC CLASS B STATEMENT ................................................. ERROR! BOOKMARK NOT DEFINED.
SECTION THREE:.................................................................... WIRELESS LAN INSTALLATION 8
SYSTEM REQUIREMENTS ................................................................................................................ 8
3-1
3-2
INSERTING THE WIRELESS CARD ............................................ ERROR! BOOKMARK NOT DEFINED.
3-3
INSTALLATION AND UNINSTALL PROCESS ......................................................................................8
SECTION 4 WIRELESS UTILITY AND CONFIGURATION .................................................... 14
4-1
WINDOWS 98/ME/2000 WIRELESS UTILITY .................................................................................14
4-2
WINDOWS XP WIRELESS UTILITY ................................................................................................ 17
APPENDIX A GLOSSARY ............................................................................................................... 24
The information contained in this manual has been verified at the time of this manual printing. The
manufacturer reserves the right to make any changes and improvements in the product described in this
manual at any time and without notice.
All registered trademarks are the property of their respective owners.
2
Section One: Introduction
AMBIT MINIPCI 3B WLAN/Bluetooth Combo Module complied with IEEE 802.11b 11Mbps
Standard. The WLAN/Bluetooth application is implemented via a Intersil Prism 2.5 RF
circuit. This RF circuit is developed for Wireless LAN application complied with IEEE
802.11b 11Mbps standard in ISM band. It can be used to provide a variety of low-cost
wireless network interfaces to build your wireless connection via simply SMT procedure to
speed the time to market. Three Intersil’s chips are implemented including ISL3984, ISL3685,
HFA3783. With Bluetooth technology, the Bluetooth part can achieve internet connection
rates up to 721 kbits/s. The Notebook communicate with Bluetooth by MiniPCI Interface
Reserve pin. The WLAN/Bluetooth combo card mechanical complies with MINIPCI 3B form
factor.
1.1 Features
1.1.1 WLAN Hardware Specification
Form Factor & Bus Interface MiniPCI Type IIIB, compliant to MiniPCI 1.0
Wireless LAN Compliance IEEE 802.11b
Radio Technology Direct Sequence Spread Spectrum
Operating Frequency 2.4 ~ 2.497GHz ISM band
Modulation Schemes DQPSK, DBPSK and CCK
Channel Numbers IEEE 802.11b compliant
1 ~ 11 channels for United States
1 ~ 13 channels for Europe
1 ~ 13 or 14 channels for Japan
WLAN Data Rate 11Mbps with fall back rates of 5.5, 2, and 1Mbps
Spreading 11-chip Barker Sequence
Media Access Protocol CSMA/CA with ACK
Transmitter Output Power Typ. 15 dBm
Receiver Sensitivity Typ. –82 dBm for 11Mbps @ 8% PER
Typ. –85 dBm for 1Mbps @ 8% PER
Antenna Type Integrated diversity switch with Hirose compliant
connectors(U-FL) for connecting dual diversity
antennas
1
1.1.2 Bluetooth Hardware Specifications
Bluetooth Module Chip Set CSR BlueCore 02
Supply Voltage 2.7V to 3.3V
Power Features Host wake-up on the module
Detach the module from host
Frequency Range 2.400-2.497 GHz
Antenna Load 50 Ohm
Receive Sensitivity –80 dBm@0.1% BER
Maximum Receiver Signal -20 dBm
TX Power 4 dBm maximum (class 2 and class 3)
RF Power Control Step Size 2 dB
Range 10 meters at 0 dBm TX power (class 2)
Radio Compliant with Bluetooth standard version 1.1
Pico Net 1 master to 7 slaves
Operating Channels 79 channels of 1 MHz BW
Security Full support of Bluetooth security provisions
including hardware support for full length 128
bit encryption keys.
Host Interface (USB) USB specification 1.1 compliant
1.1.3 Software Specification
OS - Supports Windows 98SE, ME, 2000, XP
Configuration - User interface for configuration and status
monitoring
WLAN Standard Compliance - 802.11b,- 802.1X for Windows XP
Bluetooth Standard - Bluetooth Specification 1.1
Site Survey - Auto scan to find APs nearby and show
signal strength for each channel (for WLAN
only)
2
1.2 Package Contents
Make sure you have received the following items in your package:
One Mini-PCI Type IIIB WLAN/Bluetooth Module
One Phone Cable (Bluetooth)
User Manual
Section Two: Bluetooth Installation
The following steps provide instructions for installing Bluetooth.
1. Make sure your MiniPCI WLAN/BT Combo card already insert into the slot.
2. Insert the connector of Antenna cable into the antenna connector of MiniPCI Module .
The antenna connector assembly need to be performed by well trained engineer to cause
antenna connector mismatch then degrade Bluetooth connection performance. Please find your
vendor to help this connector assembly.
2.1 Driver Installation
Your Bluetooth is using the Plug and Play (PnP) capabilities of you computer. PnP is a set of
specifications that define the ability for the computer hardware and operating system to
automatically configure all compliant devices that are installed, relieving the user of the need
to determine which addresses and interrupts to user for each device.
Proceed to the following section.
Install Bluetooth (Windows 98/2K/ME/XP)
1Execute the program ‘Setup.exe’ in the CD. Windows displays the dialog as below. Press
‘Next’ button to continue.
2.Select the “ Device name “ and “Device Type” that you want to Install.
3
3.Wait for the install program to do the installation.
4. Select “ OK” to avoid Microsoft Digital Signature message
4
5.Congratulations! Bluetooth has been installed successfully.
Please click ‘Finish’ to go to the next step.
6.Select the Application that you want to use.
5
6
Loading...