HON HAI PRECISION IND J07H081 Users Manual

INSTALLATION MANUAL

J07H081

ThinkPad Bluetooth with Enhanced Data Rate

Contents

SECTION ONE: INTRODUCTION ............................................................................................ 1

1.1 F

1.1.1 B

1.2 H

EATURES .............................................................................................................................. 1

LUETOOTH FUNCTION................................................................................................................ 1

ARDWARE REQUIREMENTS........................................................................................................... 1

SECTION TWO: BLUETOOTH INSTALLATION........................................................................... 3

2.1 B

LUETOOTH INSTALLATION.................................................................................................... 3

SECTION THREE: FCC NOTICE................................................................................................... 1

3.1 FCC C

3.2 FCC C

OMPLIANCE ................................................................................................................. 9

LASS B STATEMENT .................................................................................................. 10

The information contained in this manual has been verified at the time of this manual printing. The
manufacturer reserves the right to make any changes and improvements in the product described in this
manual at any time and without notice.
All registered trademarks are the property of their respective owners.

 Section One: Introduction

The Bluetooth Module use a monolithic single-chip, Broadcom BCM2045 and it can compliant Bluetooth

2.0.This Bluetooth module is base on the highly integrated BCM2045 stand-alone baseband processor with an
integrated 2.4GHz transceiver. It is fully compliant with the Bluetooth radio specification and incorporates new
modulation schemes to support enhanced data rate(EDR) of 3MBps.

1.1 Features

1.1.1 Bluetooth Function

o Bluetooth radio firmware is upgradeable for bug fixes, initial version compatible with Bluetooth

specification version 2.0

o Fully compliant to Bluetooth SIG (BQB) compatibility testing.
o USB Pin assignment is to use MDC reserve pin to communicate with Host.interface
o Bluetooth Profile Support

- Pim Item Transfer

- Pim Synchronization

- Network Access

- Dial-up Networking

- Bluetooth Serial Port

- Fax

- Audio Gateway

- Headset

- Bluetooth Imaging

o Drivers support Windows 98, 98SE, ME, 2000, XP.

o Supports Power Management

1.2 Hardware Requirements

Supply Voltage 3.3V

Frequency Range 2.400-2.4835 GHz

Antenna Load 50 Ohm

Receive Sensitivity –78 dBm@0.1% BER

Maximum Receiver Signal -20 dBm

TX Power 4 dBm maximum (class 2)

RF Power Control Step Size 2 dB

Range 10 meters at 0 dBm TX power (class 2)

Radio Compliant with Bluetooth radio specification and incorporates

new modulation schemes to supports enhance data rate (EDR)

of 3Mbps

Pico Net 1 master to 7 slaves

Operating Channels 79 channels of 1 MHz BW

Security Full support of Bluetooth security provisions including

hardware support for full length 128 bit encryption keys.

Host Interface (USB) USB specification 2.0 compliant and using MDC reserve pin to

communicate with Host

Software Requirements Windows 98SE, ME, 2000, XP.

Mechanical Requirements 26mm x 14mm

 Section Two: Bluetooth Installation

The following steps provide instructions for installing Bluetooth.

1. Make sure your Bluetooth device already insert into your notebook.

2. Make sure your notebook operating system support Windows 98SE or ME or 2000 or XP.

2.1 Bluetooth Installation

Proceed to the following section.

Double click the program “Setup.exe” to execute the setup procedure in the software package：

1. Windows shows the dialog as below to check your operation system version：