Hongjiayi Electronics YTS M501 User Manual

Wireless m ouse

User ’s Manual

Operating:

1. Pull o ff the co ve rs of the mou se , and tak e

the rec ei ver fro m mo use.

2. Put on e AA battery in to t he mous e, a nd pull on th e ov ers.

3. Inse rt t he rece iv er into the U SB p ort of co mp uter.

4. Turn on t he p ower of t he m ouse.

5. Oper at e your mo us e.

Sugge st ion:

Kindl y su ggest t o us e Alkali ne b at terie s fo r your pr od uc ts.

the pow er o f mouse c an w ork for one m on th.

Notic e:

The mou se w ill go in to s leeping a ft er it doe s no t work for 5

minut es , you may w ak e up it by pres si ng any mo us e buttons .

TroubleShooting:

If the Mo us e canno t wo rk normal ly, plea se t ry follow in g:

1. Pull o ut t he rece iv er from the c om puter

2. Turn of f the pow er o f the mou se .

3. Inse rt t he rece iv er into the U SB p ort of co mp uter.

4. Turn on t he p ower of t he m ouse.

5. Oper at e your mo us e.

Pro du ct S pe ci fi ca ti on s:

*Mous e

Work ing Volt age : 1.5V

Work ing c urr ent: <2 0mA

Sle eping c urren t:<0. 2mA

Mou se Butt ons: Fo ur

DPI L evels : 800/1 200/1 600dp i

Mou se size : 113x64x3 0mm

Weig ht: 135 g

But tons li fetim e: 300 mi llion s
Fre qucen y: 2.4G H z

Wire less op erati ng dist ance: 10 mete rs

Sto rage Temp eratu re: -40℃ 〜1 25℃

Com patib le with Wi ndows X P/7/8 /10/V ISTA

FCC Notice

This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receive r .

-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

-Consult the dealer or an experienced radio/TV technician for help.

NOTE 2: Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.