Honeywell Home PRO 1000, TH1210DH, TH1100DH, TH1110DH Operating Manual
Operating
69-2607EFS-03
Cool
On
Heat Off Cool
PRO 1000 Series
Non-Programmable Thermostat
Fan
Auto On
Manual
This manual covers the following models:
TH1100DH: For 1 Heat systems
TH1110DH: For 1 Heat/1 Cool systems
TH1210DH: For 2 Heat/1 Cool heat pump systems
(Pull thermostat from wallplate and turn over to find model number.)
CAUTION: EQUIPMENT DAMAGE HAZARD.
To prevent possible compressor damage, do not operate cooling system when outdoor
temperature is below 50°F (10°C).
Need Help?
For assistance with this product please visit http://customer.resideo.com
or call Customer Care toll-free at 1-800-468-1502
Read and save these instructions.
® U.S. Registered Trademark. Patents pending.
Copyright © 2019, Resideo Technologies, Inc. Al l rights reserved.
Table of contents
PRO 1000
About your new thermostat
Thermostat features ........................................ 2
Quick reference to controls...........................3
Quick reference to display ............................. 4
Operation
Select system setting ...................................... 5
Select fan setting .............................................. 6
Adjust the temperature................................... 7
Compressor protection ................................... 8
1 69-2607EFS—03
Appendices
Battery replacement ........................................ 9
Customer assistance .....................................10
In case of difficulty .........................................11
Limited warranty .............................................13
Operating Manual
About your new thermostat
ENGLISH
Your new thermostat has been designed to give you many years of reliable service
and easy-to-use, push-button climate control.
Features
• Backlit display is easy to read
• Displays ambient (measured) temperature at all times
• One-touch access to setpoint temperature
• Built-in compressor protection
Electrical Ratings
System Voltage (50/60Hz) Running Current
Heat (1st stage) 2030 Vac 0.021.0 A
(Powerpile) 750 mV DC 100 mA DC
Auxiliary heat* 2030 Vac 0.021.0 A
Cooling 2030 Vac 0.021.0 A
* TH1210DH only
69-2607EFS—03 2
About your new thermostat
M32821
Quick reference to controls
Set
E.M. Heat Heat Off Cool
77
Cool
On
Fan
Auto On
PRO 1000
ENGLISH
Up/Down buttons
Press to adjust
temperature.
System switch (see page 5)
• Cool: Cooling system control.
• Off: All systems off.
• Heat: Heating system control.
Fan Switch (see page 6)
On: Fan runs continuously.
Auto: Fan runs only when heating
or cooling system is on.
• Em Heat: Emergency & Auxiliary Heat control.
Compressor is locked out. (Select models only.)
3 69-2607EFS—03
Operating Manual
M32763
About your new thermostat
Quick reference to display screen
ENGLISH
Setpoint indicator
Appears when the setpoint
temperature is displayed
Set
77
Cool
Lo
Low battery warning
(see page 9)
System status
Cool on: Cooling system is on.
Heat on: Heating system is on.
Aux On: Auxiliary heat is on. (Only for heat pumps with this capability [select models only].)
When “Heat On” or “Cool On” is flashing, compressor protection is engaged (see page 8).
69-2607EFS—03 4
Batt
On
Temperature
The ambient (measured) temperature
is normally displayed. To view the
setpoint temperature, press the Up
or Down button once. The setpoint
temperature will appear for five
seconds.
PRO 1000
M32821
Select the system setting
The SYSTEM switch can be set to control
your heating or cooling system, depend-
Set
77
Cool
On
Fan
E.M. Heat Heat Off Cool
Auto On
Set SYSTEM switch to control the
heating or cooling system.
5 69-2607EFS—03
ing on the season.
• Cool: Cooling system control.
• Off: All systems are off.
• Heat: Heating system control.
• Em Heat: Emergency & Auxiliary
Heat control. Compressor is locked
out. (Select models only.)
CAUTION: EQUIPMENT DAMAGE
HAZARD. To prevent possible
compressor damage, do not operate
cooling system when outdoor
temperature is below 50°F (10°C).
ENGLISH
Operating Manual
Select the fan setting
ENGLISH
Set
77
Cool
On
Fan
E.M. Heat Heat Off Cool
Set FAN switch to choose whether the fan
runs continuously or only as needed.
69-2607EFS—03 6
Auto On
M32821
Set the FAN switch to Auto or On.
In “Auto” mode (the most commonly used
setting), the fan runs only when the heating or cooling system is on.
If set to “On,” the fan runs continuously.
About your new thermostat
M32822
Adjust the temperature
Press s or t to adjust the temperature.
Note: Make sure the thermostat is set to the
Set
77
Cool
On
system you want to control (heat or cool).
PRO 1000
ENGLISH
E.M. Heat Heat Off Cool Auto On
Fan
7 69-2607EFS—03
Operating Manual
77
M32769
Built-in compressor protection
ENGLISH
Set
Cool
On
Message flashes until safe restart
time has elapsed.
This feature helps prevent damage to the
compressor in your air conditioning or heat
pump system.
Damage can occur if the compressor is
restarted too soon after shutdown. This feature forces the compressor to wait 5 minutes
before restarting.
During the wait time, the display will flash the
message Cool On. When the safe wait time
has elapsed, the message stops flashing and
the compressor turns on.
69-2607EFS—03 8
PRO 1000
M32823
M32707
Battery replacement
Pull at bottom to
remove thermostat
from wallplate.
Not
W/
Used
Aux
Turn thermostat over,
insert fresh AAA alkaline
batteries, then reinstall
thermostat.
E.M. Heat Heat Off Cool Auto On
RTHXXXX
Set the System switch to Off before removing the
batteries. Otherwise, the heating/cooling system
could remain activated even when batteries are
removed.
9 69-2607EFS—03
Install two fresh AAA batteries when
Lo Batt flashes on the screen. Lo
Batt appears for 60 days before the
batteries are depleted.
Replace batteries once a year, or
when you will be away for more than
a month.
The settings are stored in nonvolatile (permanent) memory
Fan
and are thus preserved when the
thermostat is without batteries.
ENGLISH
Operating Manual
M32823
M32707
Customer assistance
ENGLISH
Pull at bottom to
remove thermostat
from wallplate.
Not
W/
Used
Aux
Turn thermostat over
to find model number
and date code.
E.M. Heat Heat Off Cool Auto On
RTHXXXX
69-2607EFS—03 10
For assistance with this product, please
visit
http://customer.resideo.com.
Or call Customer Care toll-free at
18004681502.
To save time, please note your model
number and date code before calling.
Fan
PRO 1000
In case of difficulty
If you have difficulty with your thermostat, please try the following suggestions.
Most problems can be corrected quickly and easily.
Display is blank • Make sure fresh AAA alkaline batteries are correctly installed (see
Heating or
cooling system
does not respond
11 69-2607EFS—03
page 9).
• Set system switch to Heat (see page 5). Make sure the temperature
is set higher than the Inside temperature.
• Set system switch to Cool (see page 5). Make sure the temperature
is set lower than the Inside temperature.
• Wait 5 minutes for the system to respond.
• Check circuit breaker and reset if necessary.
• Make sure power switch at heating & cooling system is on.
• Make sure furnace door is closed securely.
ENGLISH
Operating Manual
In case of difficulty
ENGLISH
Temperature
settings do not
change
“Heat On” or
“Cool On” is
flashing
“Heat On” is not
displayed
“Cool On” is not
displayed
69-2607EFS—03 12
Make sure heating and cooling temperatures are set to acceptable ranges:
• Heat: 40° to 90°F (4.5° to 32°C).
• Cool: 50° to 99°F (10° to 37°C).
• Compressor protection feature is engaged. Wait 5 minutes for the
system to restart safely, without damage to the compressor (see page 8).
• Set the System switch to Heat, and set the temperature level above the
current room temperature (see page 5).
• Set the System switch to Cool, and set the temperature level below the
current room temperature (see page 5).
PRO 1000
About your new thermostat
2-year limited warranty
Resideo warrants this product, excluding battery, to be free from defects in workmanship or materials, under normal use
and service, for a period of two (2) years from the date of first purchase by the original purchaser. If at any time during the
warranty period the product is determined to be defective due to workmanship or materials, Resideo shall repair or replace it
(at Resideo’s option).
If the product is defective,
(i) return it, with a bill of sale or other dated proof of purchase, to the place from which you purchased it; or
(ii) call Resideo Customer Care at 18004681502. Customer Care will make the determination whether the product should
be returned to the following address: Resideo Return Goods, 1985 Douglas Dr. N., Golden Valley, MN 55422, or whether a
replacement product can be sent to you.
This warranty does not cover removal or reinstallation costs. This warranty shall not apply if it is shown by Resideo that the
defect was caused by damage which occurred while the product was in the possession of a consumer.
Resideo’s sole responsibility shall be to repair or replace the product within the terms stated above. RESIDEO SHALL NOT
BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND, INCLUDING ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES
RESULTING, DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY, EXPRESS OR IMPLIED, OR ANY OTHER
FAILURE OF THIS PRODUCT.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so this limitation may not apply
to you.
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY RESIDEO MAKES ON THIS PRODUCT. THE DURATION OF ANY IMPLIED
WARRANTIES, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS
HEREBY LIMITED TO THE TWO YEAR DURATION OF THIS WARRANTY. Some states do not allow limitations on how long an
implied warranty lasts, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may have other rights which vary from state to state. If you have any
questions concerning this warranty, please write Resideo Customer Care, 1985 Douglas Dr, Golden Valley, MN 55422 or call
18004681502.
13 69-2607EFS—03
ENGLISH
Loading...