Honeywell V5863A, M6410A, V5862A, M7410F User Manual

M6410A, M7410F Actuators

V5862A,V5863A Valves

HIGH-FORCE NON-SPRING RETURN ACTUATORS

AND 1, 1-1/4, 1-1/2 INCH NPT CARTRIDGE GLOBE VALVES

M6410A and M7410F Series 3000 Non-Spring Return Valve Actuators provide floating or modulating control of V5862A and V5863A Series 3000 Cartridge Globe Valves.

The actuators are used in electronic temperature control systems, which use hot and/or cold water (with glycol up to 50 percent) as the controlled medium in variable air volume (VAV) terminal units, fan-coil units, small reheaters and recoolers.

SPECIFICATIONS

CAUTION

Equipment Damage Hazard. Installing a high-force (67.5 lb [300 N]) actuator on 1/2 or 3/4 in. valve can damage the valve beyond repair.

Use only Series 1000 (40.5 lb [180 N]) actuators with the smaller (1/2 in. and 3/4 in.) valves.

CAUTION

Electrical Shock or Equipment Damage Hazard. Can shock individuals or short equipment circuitry.

Disconnect power supply before installation.

IMPORTANT

— A low-force (40.5 lb [180 N]) actuator installed on a

valve larger than 3/4 in. cannot operate the valve.

— Install high-force actuators (67.5 lb) only on large

valves (1 in., 1-1/4 in., 1-1/2 in.).

Models:

❑ M6410A: Non-Spring Return Valve Actuator. Provides

floating control of the V5862A and V5863A Valves.

❑ M7410F: Non-Spring Return Valve Actuator. Provides

modulating control of V5862A and V5863A Valves.

❑ V5862A: Two-way NPT Valves. ❑ V5863A: Three-way NPT Mixing Valves.

Control Modes:

❑ M6410A: Floating. ❑ M7410F: Modulating.

Ambient Ratings:

❑ Operating Temperature Range: 32° to 122°F (0° to 50°C). ❑ Storage Temperature Range: -40° to 158°F (-40° to 70°C). ❑ Humidity Range: 5 to 95% RH (noncondensing).

Weight:

❑ M6410A: 5 oz (0.15 kg). ❑ M7410F: 5.6 oz (0.16 kg).

SPECIFICATION DATA

FEATURES

• Small size allows installation in limited space.

• Long stroke allows wider range of control.

Actuators

• Low power consumption.

• Synchronous motor.

• No mounting tools required.

• Low-maintenance plastic housing.

• Conduit connector standard.

• No separate linkage required.

• M6410A provides 3-position floating control without proportional feedback.

• M7410F receives 0 to 10 Vdc or 2 to 10 Vdc input signal, selectable at the site.

• M7410F includes direct/reverse acting switch.

• Especially suitable for Excel Room Controller (IRC) System.

• Internal valve position indicator.

• Magnetic coupling for torque limitation independent of voltage supply, and self-adjustment of close-off port.

• Ready-to-wire connecting cable.

Valves

• V5862A is a two-way female NPT valve.

• V5863A is a three-way female NPT mixing valve.

• Pressure-balanced plug.

• Soft valve seat provides low leakage rate.

• Valve inserts are changeable with the insert replacement tool.

• Threaded plastic cover allows manual operation.

• Brass body and stainless steel stem.

Mounting:

❑ Actuator screws onto valve body.

Connections:

❑ M6410A, M7410F: 4.9 ft (1.5m) cable.

Electrical Ratings:

❑ Input Power:

❑ 24 Vac, +10/-30 percent, 50/60 Hz.

❑ Power Consumption:

❑ M6410A: 0.7 VA. ❑ M7410F: 1.4 VA.

❑ Input Signal (M7410F): Modulating 0 to 10V, 2 to 10V

(adjustable), 0.1 mA.

❑ Input Impedance (M7410F): 100K ohms.

Controller or Individual

63-1293-2

M6410A, M7410F ACTUATORS V5862A,V5863A VALVES

Stroke:

❑ 1/4 in. (6.5 mm).

Running Time:

❑ At 50 Hz: 150 seconds. ❑ At 60 Hz: 125 seconds.

Stem Force:

❑ 67.5 lb (300 N).

Suitable Medium:

❑ Water with maximum 50% glycol.

Controlled Water Temperature:

❑ 36° to 230°F (2° to 110°C).

Rangeability:

❑ Two-way Valve: 50:1. ❑ Three-way Valve: 50:1 for controlled port (A to AB).

Flow Characteristic:

❑ Linear.

Valve Cv Rating:

❑ See Table 1.

NOTE: To determine the capacity index (Cv) needed for your

application, use the following formula: Cv = gallons per minute divided by the square root of the pressure drop across the valve when the valve is fully open.

Body Material:

❑ Brass.

Stem and Plug Assembly:

❑ Stem: Stainless steel. ❑ Plug: Brass.

Actuator Required:

❑ M6410A: Non-Spring Return Valve Actuator (3-position

floating).

❑ M7410F: 0 to 10 Vdc or 2 to 10 Vdc Electronic Actuator. ❑ Valve inserts are provided as spare parts. See Table 2.

Leakage Rate:

❑ ≤0.05% of Cv.

Valve Close-off Ratings:

❑ See Table 1.

Approvals (Actuators):

❑ Underwriters Laboratories Inc. listed for plenum use

(UL94-5V).

Table 1. Valve Close-off Ratings.

Pipe Size in

in. (mm)

Close-off Rating (psi)

Two-way Three-way

1 (25) 5.5 232 232

7.8

1-1/4 (32) 18 174 174

1-1/2 (38) 25 145 145

The Cv for the bypass port (B) on all three-way valves is reduced by one Cv level. Example: A Port Cv = 11; B Port Cv = 7.8. This feature eliminates the need for a balancing valve with the load matched to the proper Cv.

Accessories and Replacement Parts:

❑ WV3000R Insert Replacement Tool, for replacing cartridge

insert.

Table 2. Valve Insert Replacement Parts.

Diameter (in.) For Valve Cv Part Number

Two-Way

1 V5862A3003 5.5 0903827

V5862A3011 7.8

V5862A3029 11

1-1/4 V5862A3037 18 0903828

1-1/2 V5862A3045 25 0903829

Three-Way

1 V5863A3002 5.5 0903827

V5863A3010 7.8

V5863A3028 11

1-1/4 V5863A3036 18 0903828

1-1/2 V5863A3044 25 0903829

M19693

63-1293—2 2

+ 2 hidden pages