HV-120 series OM.qxd 10/12/06 12:39 PM Page 1
PRO SERIES®UTILITY
DUAL POWER FAN
Model HV-120 Series
IMPORTANT SAFETY
INSTRUCTIONS
READ AND SAVE THESE SAFETY
INSTRUCTIONS BEFORE USING
THIS FAN
When using electrical appliances, basic
precautions should always be followed to
reduce the risk of fire, electric shock, and
injury to persons, including the following:
1.
Use this fan only as described in this manual.
Other use not recommended may cause fire,
electric shock or injury to persons.
2. This product is intended for household use
ONLY and not for commercial, industrial or
outdoor use.
3. This product is intended for floor use ONLY.
4. To protect against electric shock, do not place
fan in window, immerse unit, plug or cord in
water or spray with liquids.
5. This appliance has a polarized plug (one
blade is wider than the other). To reduce the
risk of shock, this plug is intended to fit only
one way in a polarized outlet. If the plug does
not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified
electrician.
safety fea
6. Close supervision is necessary when any
appliance is used by or near children.
7. Turn the fan to the OFF position and unplug
the fan from the outlet when not in use,
DO NOT attempt to defeat this
ture.
when
moving the fan from one location to another
and before cleaning.
8. To disconnect the fan, first turn control to the
OFF position, grip the plug and pull it from the
wall outlet. Never pull by the cord.
9. Do not operate the fan in the presence of
explosive and/or flammable fumes.
10. Do not place the fan or any parts near an
open flame, cooking or other heating
appliance.
11. Do not operate the fan with a damaged cord
or plug or if the product malfunctions, is
dropped or damaged in any manner (see
warranty).
12. Avoid contact with moving fan parts.
13. The use of attachments not recommended by
the manufacturer may be hazardous.
14. Place the fan on a dry level surface.
15. Turn the fan OFF and unplug it before
removing the fan grille. Do not plug in or
operate the fan if the grille is removed or not
properly assembled.
16. Do not operate if the fan housing is removed
or damaged.
17. A loose fit between the AC outlet (receptacle)
and plug may cause overheating and a
distortion of the plug. Contact a qualified
electrician to replace loose or worn outlet.
WARNING: To Reduce The Risk of Fire or
Electric Shock, Do Not Use This Fan With
Any Solid-State Speed Control Device.
The Honeywell trademark is used by Kaz,
Inc. under license from Honeywell Intellectual Properties, Inc.
HV-120 series OM.qxd 10/12/06 12:39 PM Page 2
ASSEMBLY
• Remove the fan motor assembly, the base plate and the two feet from the package.
• Lay the fan motor assembly on its back
• Remove the plastic hand screws from the bottom of the fan motor assembly by turning them counter
clockwise (Fig. 1 ).
• Holding the base plate, line up the threaded screws with the holes in the base, push base plate in.
• Tighten the hand screws onto the threaded screws protruding from the bottom of the base by turning
clockwise (Fig. 2).
Fig. 1 Fig. 2
Feet Assembly
• Unscrew metal hand nuts counter clockwise from the base plate (Fig. 3).
• Align center holes of feet to the threaded rod on base plate (Fig. 4).
• Push feet into base plate and tighten hand nut clockwise until feet are secure. Please be careful not to
over-tighten the hand screw (Fig. 5).
Fig. 3
Fig. 4
Fig. 5
OPERATION
• Place your fan on a dry, level surface
• Plug the power cord into a polarized 120 volt AC wall outlet
o operate the fans, turn the control
T
Each fan is independently opera
•
knobs to the desired speeds - High (lll),
ted.
Medium (ll),
Low (l).
• Adjust the individual fans left to right by using the small grip at the top of
each fan (6).
Fig. 6
HV-120 series OM.qxd 10/12/06 12:39 PM Page 3
OPERATION continued
• For up and down positioning, pivot by adjusting the handle front to back (Fig. 7).
• To move the unit, turn the fans off, unplug the power cord and pick it up by the handle (Fig. 8).
Fig. 7 Fig. 8
CLEANING AND STORAGE
Unplug the fan before cleaning.
• Use only a soft, damp cloth to gently wipe the fan clean.
• DO NOT immerse the fan in water and never allow water to drip into the motor housing.
• DO NOT use gasoline, paint thinner or other chemicals to clean the fan.
REMOVAL OF THE FRONT GRILLE FOR CLEANING
DO NOT remove the fan grille unless the fan’s power is turned off and
the power cord is unplugged.
• Gently lay the fan face down on a table.
• Remove the front grille by unscrewing the 6 screws located on the back of the
fan head (Fig. 9).
• Unscrew the screws using a standard phillips head screw driver ( ).
NOTE: The screws will remain attached to the rear housing to ensure they are
not lost. Do not try to force the removal of the screws
• Lift the whole fan up by the handle to separate from the front grille.
• Gently wipe the fan blade and grilles with a cloth. DO NOT IMMERSE THE FAN
IN WATER AND NEVER ALLOW WATER TO DRIP INTO THE MOTOR HOUSING. DO
NOT USE GASOLINE, PAINT THINNER, OR OTHER CHEMICALS TO CLEAN THE FAN.
• Re-assemble the fan by replacing the front grille and aligning the screw holes
between the front grille and the fan body (Fig. 10). Gently tighten the screws.
• For storage, clean the fan carefully as instructed. Store the fan in the original
packaging or cover the product to protect it from dust. Store the fan in a cool,
dry place.
Fig. 9
Fig.
10
HV-120 series OM.qxd 10/12/06 12:39 PM Page 4
CONSUMER RELATIONS
Mail questions or comments to:
Kaz, Incorporated
Consumer Relations Dept.
250 Turnpike Road
Southborough, MA 01772
Call us toll-free at: 1-800-477-0457
E-mail: consumerrelations@kaz.com
Or visit our website at:
www.kaz.com
Please be sure to specify a model number.
NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT CONSUMER RELATIONS FIRST OR SEE
YOUR WARRANTY. DO NOT RETURN TO THE ORIGINAL PLACE OF PURCHASE. DO NOT ATTEMPT TO
OPEN THE MOTOR HOUSING YOURSELF, DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE
TO THE FAN OR PERSONAL INJURY.
5 YEAR LIMITED WARRANTY
You should first read all instructions before
attempting to use this product.
This 5 year limited warranty applies to repair
A.
or replacement of product found to be
defective in material or workmanship. This
warranty does not apply to damage resulting
from commercial, abusive, unreasonable use
or supplemental damage. Defects that are the
result of normal wear and tear will not be
considered manufacturing defects under this
warranty.
KAZ IS NOT LIABLE FOR
INCIDENTAL OR CONSEQUENTIAL DAMAGES
OF ANY NATURE. ANY IMPLIED WARRANTY
OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE ON THIS PRODUCT IS
LIMITED IN DURATION TO THE DURATION OF
THIS WARRANTY
. Some jurisdictions do not
allow the exclusion or limitation of incidental
or consequential damages or limitations on
how long an implied warranty lasts, so the
above limitations or exclusions may not apply
to you. This warranty gives you specific legal
rights, and you also may have other rights
which vary from jurisdiction to jurisdiction.
This warranty applies only to the original
purchaser of this product from the original
date of purchase.
B. At its option, Kaz will repair or replace this
product if it is found to be defective in material
or workmanship.
C. This warranty does not cover damage
resulting from any unauthorized attempts to
repair or from any use not in accordance with
the instruction manual.
D. Return defective product to Kaz, Incorporated
with a brief description of the problem.
Include proof of purchase and a $10
US/$15.50 CAN check or money order for
handling, return packing and shipping
charges. Please include your name, address
and a daytime phone number.
You must prepay shipping charges. We
suggest having tracking or delivery
confirmation. Send to:
In U.S.:
Kaz, Incorporated
Attn: Returns Department
4755 Southpoint Drive
Memphis, TN 38118
USA
In Canada:
Kaz Canada Inc.
Attn: Returns Department
510 Bronte Street South
Milton, ON L9T 2X6
Canada
© 2006 Kaz, Incorporated. All Rights Reserved.
P/N 31IMV120191
Loading...