Honeywell GSM-ANTHB Installation & Setup Manual
Introduction
The GSM-ANTHB Kit provides external antenna capability for GSM and iGSM communications devices.
Contents
This kit consists of an Antenna and Adapter Cable (for connection to the communications device).
Assembly
To assemble, refer to the figure below and perform the following steps:
1. Remove the front cover from the communications device.
2. Install the through-hole connector of the adapter cable in the top hole on the enclosure back of the
3. Snap the other end of the adapter cable in the external antenna port of the communications device.
4. Attach the antenna to the connector on top of the enclosure. Replace the front cover.
800-02377 7/08 Rev. A
GSM-ANTHB
Antenna Kit
Installation & Setup Guide
NOTE: This antenna is for indoor use only.
ANTENNA
WASHER
AND NUT
ANTENNA ADAPTER CABLE
gsm-exppk-002-V0
NOTE: Refer to the communication device's Installation and Setup Guide for mounting, wiring and
programming information.
communications device. Secure with lock washer and nut.
ANTENNA
P/O
GSM-ANTHB
ANTENNA KIT
NUT
WASHER
MOUNTING SCREWS
EXTERNAL
ANTENNA PORT
SMA / MMCX
ADAPTER CABLE
(P/O GSM-ANTHB
ANTENNA KIT)
TB 1
FOR EXTERNAL ANTENNA
50 OHM MMCX ONLY
7720P PROGRAMMER PORT
NOT FOR TELEPHONE SERVICE USE!
PRIMARY POWER: 9 - 16.5 VAC
CURRENT: 900mA PEAK, 70mA STANDBY
BATTERY: 8V. 3.1 AHr FOR 24 Hr BACKUP
FCC:XXXXXXXXXX IC: YYYYYYYYYY
1
2
3
4
5
6
7
8
9
10
11
GPRS
RSSI
IBS
M0
M1
BLACK
RED
BATTERY
BLK
RED
AND SPACERS (4)
COMMUNICATIONS
DEVICE
gsmt-exppk-003-V0
For the latest warranty information, please go to:
http://www.security.honeywell.com/hsc/resources/wa/
Ê800-02377MŠ
800-02377 7/08 Rev. A
2 Corporate Center Drive, Melville, NY 11747
Copyright
©
2008 Honeywell International Inc.
www.honeywell.com/security
Loading...