Honda Power Equipment HS80 User Manual
Thank you for purchasing a Honda snowblower.
This manual covers the operation and maintenance of the HS80
snowblower.
All information in this publication is based on the latest product information
available at the time of approval for printing.
Honda Motor Co., Ltd. reserves the right to make changes at any time
without notice and without incurring any obligation.
No part of this publication may be reproduced without written permission.
This manual should be considered a permanent part of the snowblower and
should remain with the snowblower if it is sold.
Pay special attention to statements preceded by the following words:
ADANGER: Indicates severe personal injury or death will result if instructions are not followed.
lamI
if instructions are not followed.
CAUTION: Indicates a possibility of personal injury or equipment damage
if instructions are not followed.
Indicates a strong possibility of severe personal injury or death
NOTE: Gives helpful information.
If a problem should arise,
or if you have any questions about the
snowblower consult an authorized Honda dealer.
riB!ml
safety of the operator and the safety of others. Read and understand this
Owner’s Manual before operating this equipment; failure to do so could
result in personal injury or equipment damage.
Operating this equipment requires special effort to ensure the
HONDA MOTOR CO., LTD. 1987; ALL RIGHTS RESERVED
1
CONTENTS
1.
POWER EQUIPMENT SAFETY
WARNING LABEL LOCATION .................................................
2.
COMPONENT IDENTIFICATION AND FUNCTION
3.
ENGINE SWITCH AND AC STARTER BUTTON
FUEL VALVE :.
CHOKE LEVER
STARTER GRIP
THROTTLE LEVER (ENGINE SPEED)
SHIFT LEVER
AUGER CLUTCH LEVER AND DRIVE CLUTCH LEVER
CHUTE CRANK ....................................................................
CHUTE GUIDE
SKID PLATE .........................................................................
HEIGHT ADJUSTMENT PEDAL (TRACK MODEL ONLY)
PRE-OPERATION CHECK
4.
FUEL LEVEL .........................................................................
ENGINE OIL LEVEL ....................................................
5.
STARTING THE ENGINE
6.
SNOWBLOWER OPERATION
HIGH ALTITUDE OPERATION .................................................
STOPPING THE ENGINE
7.
MAINTENANCE ...........................................
8.
MAINTENANCE SCHEDULE
TOOL KIT ............................................................................
ENGINE OIL CHANGE .........
SPARK PLUG SERVICE
TRACK-ADJUSTMENT (TRACK MODEL ONLY)
9.
STORAGE ...........................................................................
TROUBLESHOOTING ............................................................
10.
SPECIFICATIONS .................................................................
11.
WARRANTY SERVICE ...........................................................
12.
.....................................................
.....................................................................
....................................................................
.......................................................................
......................................................................
.................................................
......................... 8
.........................................
.......................................................
........................................................
..................................................
........................................................
...................................................
.: .................................................
..........................................................
....................... 6
.
.................
................. 1 1
.............. 14
I’. .......... 17
. ....................... 24
.........................
3
5
8
9
9
10
10
12
12
13
15
15
18
21
21
23
24
25
26
27
28
29
32
33
34
2
WER EOUIPIVIENT SAFETY
To ensure safe operation-
. Before operating the snowblower, inspect the area in which you are go-
ing to clear snow. Remove debris and other obstacles the snowblower
might strike or throw, as that may cause injury or damage to the
snowblower..
l Inspect the snowblower before operating it. Repair any damage and cor-
rect any malfunction before operation. If you hit an obstacle while
operating the snowblower, stop the engine immediately, and check for
damage. Damaged equipment may increase the possibility of injury during operation.
l Do not use the snowblower when visibility is poor. Under conditions of
poor visibility, there is a greater risk of striking an obstacle or causing
injury.
l Never use the snowblower to clear snow from a gravel road or
driveway, as rocks may be picked up and thrown. They may cause in-
jury to bystanders.
l Adjust the snow discharge chute to avoid hitting the operator,
bystanders, windows, and other objects with thrown snow. Stay clear
of the snow discharge chute while the engine is running.
l Children and pets must be kept away from the area of operation to avoid
injury from flying debris and contact with the snowblower.
l To avoid overturning, be careful when changing the direction of the
snowblower while operating it on a slope. Do not use the snowblower to
remove snow from roofs. The snowblower may overturn on steep
slopes if left unattended, causing injury to the operator or bystanders.
3
Know how to stop the snowblower quickly, and understand the operation of all controls.
Never permit anyone to operate the snowblower without proper instruction. If people or pets suddenly appear in front of the snowblower while
it is in operation, immediately release the auger and drive clutch levers to
stop the snowblower and avoid possible injury from rotating auger
blades.
If the snow discharge chute becomes clogged, stop the engine and use a
wooden stick to unclog it. Never put your hand into the snow discharge
chute while the engine is running; serious personal injury could result.
Gasoline is extremely flammable and is explosive under certain conditions. Do not smoke or allow flames or sparks where the snowblower is
refueled or where gasoline is stored. Refuel in a well-ventilated area with
the engine stopped. Do not overfill the fuel tank, and make sure the filler
cap is closed securely after refueling.
Never run the engine in an enclosed or confined area. Exhaust contains
poisonous carbon monoxide gas; exposure can cause loss of consciousness and may lead to death.
The muffler becomes very hot during operation and remains hot for a
while after stopping the engine. Be careful not to touch the muffler
while it is hot. Let the engine cool before storing the snowblower
indoors.
Always make a pre-operation inspection (page 15) before you start the
engine. You may prevent an accident or equipment damage.
NOTE: While operating the snowblower, hold the handle firmly, and walk,
don’t run. Wear suitable winter boots that resist slipping.
I STAND CLEAR OF AUGER ;$
DISCHARGE CHUTE WHILE .
INE IS RUNNING. I
Do NOT DIRECT DISCHARGE AT
BYSTANDERS OR WINDDW.
BEFORE LEAVING OPERATOR’S POSITION
1. DISENGAGE THROWER CLUTCH.
2. STOP ENGINE.
STOP ENGINE, WAIT FOR AU MOVEMENT
TO STOP AND REMOVE SPARK PLUG IGNITION WIRE BEFDRE SERVICING MACHINE.
WCHECK FOR SPILLED FUEL OR FUEL LEAKS.
STOP ENGINE BEFORE REFUELING.
~CONTRiJLER OUIL N-V A NI FUITE NI ESSENCE
ARRhER LE MOTEUR AVANT OE REFAIRE LE PLEIN.
llNSPECClONAR PARi COMRUSTIRLE OERRAMAOO
PARAR MOTOR ANTES OE WAR. I
5
3. COMPONENT PDENTBFBCATBON AND FUNCTION
WHEEL TYPE
DRIVE CLUTCH LEVER
FUEL CAP
LEVER
AUG
6
CHUTE CRANK
AUGER CLUTCH LEVER
THROTTLE LEVER
AC STARTER
SKID PLATE
\
ENGINE OIL FILLER CAP
BUTTON
TRACK TYPE
DRIVE CLUTCH LEVER
LEVER
AUGER CLUTCH LEVER
ENGIN
FUEL
CHUTE CRANK
HEIGHT ADJUSTMENT PEDAL
(TA Type)
HROTTLE LEVER
AC STARTER BUTTON
SKID PLATE
NGINE OIL FILLER CAP
ENGINE OIL DRAIN PLUG
7
ENGINE SWITCH A.C. STARTER BUTTON
Use the engine switch to turn the ignition system ON for starting, and to
STOP the engine.
ENGINE SWITCH
I
Push the A.C. starter button to operate the electric starter. (TAS, WAS
Type)
STARTER
BUTTON
FUEL VALVE
The fuel valve opens and closes the fuel line leading from the fuel tank to
the carburetor. Make sure that the valve is positioned exactly at either the
ON or OFF position.
FUEL VALVE
NOTE: Before transporting the snowblower, be sure to turn the duel valve
to OFF to prevent possible fuel leaks.
8’
CHOKE LEVER
Close the choke when the engine is cold or difficult to start.
STARTER GRIP
Pull this grip to start the engine.
STARTER GRIP
9
THROTTLE LEVER (ENGINE SPEED)
Use the throttle lever to select engine speed. In normal operation, use the
FAST position.
THROlTLE LEVER
SHIFT LEVER
Use the shift lever to select drive speed or direction.
1: LOW SPEED
2: MEDIUM SPEED
3: HIGH SPEED
N: NEUTRAL
R: REVERSE
10
SHI
AUGER CLUTCH LEVER AND DRIVE CLUTCH LEVER
Use these controls to engage the snow blowing mechanism and/or the
drive mechanism.
DRIVE CLUTCH LEVER
Squeeze to engage the
AUGER CLUTCH LE\I
Squeeze to engage
the snow ,blowing
mechanism.
‘ER
drive mechanism.
NOTE: When both levers are squeezed, the drive clutch lever locks the
auger clutch lever down. Releasing the drive clutch lever then unlocks and
releases the auger clutch lever.
Both levers squeezed
LOCKED
The auger clutch lever
remains locked down SO
long as one hand continues
to squeeze the drive clutch
lever.
11
Loading...