Honda Automobiles Security System 2007 Fit User Manual

Kit No. 08E50-SLN-100

Security System User’s Information

FIT

Contents

Introduction ..................................................... 3

Emergency Disarming

During Alarming ........................................ 4

During the Entry Delay Time ..................... 4

System Controls

Arming Mode (MANUAL AUTO) ...............

Arming Mode (AUTO MANUAL)...............

Valet (Auto Arming Mode only)

Placing the System in the Valet Mode ...... 7

In the Valet Mode ...................................... 8

Exit From the Valet Mode .......................... 9

Arming

Arming Methods ...................................... 10

Manual Arming (Remote Controlled) ...... 10

Auto Arming (Passive) ............................ 11

Please write the serial number of the remote control and the main unit below. Keep this booklet as a record of your purchase.

Remote Control No.: Main Unit No.:

No.:

Alarm Mode

Alarm Triggered Mode ............................. 12

Disarming

Remote Controlled Disarming ................. 13

Panic 5 6

Activating the Panic Function ................. 14

Deactivating the Panic Function ............. 14

Tripped Sensor Warning and Indication

Tripped Sensor Warning ........................... 15

Tripped Sensor Indication (using both

the transmitter and ignition key) ............ 16

Tripped Sensor Indication (using only

the ignition key)...................................... 17

Glossary ........................................................ 18

Specifications................................................ 20

Introduction

Congratulations on your purchase of this Honda Security System. Your Honda Security System is the product of years of research and development. It will give you many years of reliable performance, protection, and convenience.

The system consists of two major components: a main unit and a remote control transmitter.

The main unit is the “brain” of the system. The built-in programmable microprocessor monitors your vehicle for optimal protection while offering various options to tailor the system to the preferences of different users.

The remote control allows you to turn the system on and off from outside the vehicle while simultaneously locking and unlocking the doors. The transmitter can also be used to intentionally activate the horn in case of an emergency.

To take full advantage of your Honda Security System, we encourage you to read this manual thoroughly.

The Security System can be operated with the vehicle’s Keyless Entry System. For operation of the keyless entry system, refer to the vehicle Owner’s Manual or User’s Information for the optional keyless entry system.

Due to the expertise required to properly install the Honda Security System, we highly recommend that the installation be performed by your Honda dealer. Proper wiring and component placement are essential for optimum system performance.

Emergency Disarming

During Alarming

1

2

During the Entry Delay Time

1

ON

OFF

ON

OFF

• The system can be disarmed using the Ignition key regardless of the method used to arm the system.

• This method of disarming also serves as an emergency override if the remote control transmitter cannot be used.

Enter the vehicle and insert the ignition key.

Turn the ignition key to the “ON” (II) position. The security system will disarm when the ignition key is turned to the on position.

• When the system is being armed by the AUTO arming method, there is a 20 second entry delay time after opening a door.

• If the system is armed by the remote control transmitter, the entry delay time is changed to zero seconds, and the alarm is triggered immediately when a door is opened.

Insert the ignition key after opening the door.

Turn the ignition key to the “ON” (II) position. The security system will disarm when the ignition key is turned to the on position.

System Controls

Arming Mode (MANUAL AUTO)

1

2

3

4

4713010M

5N25010S

This section explains how to switch the arming mode from MANUAL to AUTO.

NOTE: Factory preset is MANUAL.

Disarm the security system. Steps from 2 to 4 must be completed within 3 seconds.

Insert the ignition key, and remove the ignition key from the ignition switch. (All the way out.)

within 3 seconds

Insert the ignition key. You will observe the following.

• The system “beep” once. MANUAL MODE

AUTO MODE

The switching procedure is

Completed Beep once

Not completed No beep

The result

System Controls

Arming Mode (AUTO MANUAL)

1

ON

OFF

2

3

4

4713010M

5

4713010M

6

5N25021S

5N25120S

This section explains how to switch the arming mode from AUTO to MANUAL.

Turn the ignition key to the OFF position. Remove the key from the ignition switch.

Open a door and close it. (The EXIT delay starts.)

Steps from 4 to 6 must be completed within 3 seconds.

Insert the ignition key, and remove the ignition key from the ignition switch. (All the way out.)

within 3 seconds

Insert the ignition key. You will observe the following.

• The system “beeps” twice.

AUTO MODE

MANUAL MODE

The switching procedure is

Completed Beep twice

Not completed No beep

The result

Valet (Auto Arming Mode only)

Placing the System in the Valet Mode (Valet Mode cannot be used in the

Manual Arming Mode)

1

2

3

4

4713010M

4

Status LED

within 3 seconds

Disarm the system. Steps from 2 to 4 must be completed within 3 seconds.

Insert the ignition key, and remove the ignition key from the ignition switch. (All the way out.)

Insert the ignition key. The Status LED will flash once, indicating that the system is in the Valet mode.

When the security system is placed in the valet mode, it is temporarily placed on “hold.” When in the valet mode, the system cannot be armed, but panic mode is still functional. This is a convenient feature if the car is to be washed, serviced, or valet parked.

Valet (Auto Arming Mode only)

In the Valet Mode:

LED

5N25031S

LED

If you follow either procedure below, LED blinks once to show the system is in the Valet mode.

Open one of the doors. LED blinks once.

After turning the ignition switch to OFF, remove the ignition key. LED blinks once.

Keyless/Security during the Valet Mode.

Lock/Unlock of Keyless

VALET MODE is ON Active Active Non-Active

VALET MODE is OFF Active Active Active

Panic of Keyless

Set/Unset of Security