Honda Automobiles HS522 User Manual
Thank you for purchasing a Honda snowblower.
This manual covers the operation and maintenance of the HS522
snowblower.
All information in this publication is based on the latest product information
available at the time of approval for printing.
Honda Motor Co., Ltd. reserves the right to make changes at any time
without notice and without incurring any obligation.
No part of this publication may be reproduced without written permission.
This manual should be considered a permanent part of the snowblower and
should remain with the snowblower if it is resold.
Pay special attention to statements preceded by the following words:
A DANGER: Indicates severe personal injury or death will result if instructions are not followed.
m Indicates a strong possibility of severe personal injury or death if
instructions are not followed.
CAUTION: 1ndicates.a possibility of personal injury or equipment damage
if instructions are not followed.
NOTE: Gives helpful information.
If a problem should arise, or if you have any questions about your
snowblower, consult an authorized Honda snowblower dealer.
mm
safety of the operator and the safety of others. Read and understand this
Owner’s Manual before operating this equipment; failure to do so could
result in personal injury or equipment damage.
Operating this equipment requires special effort to ensure the
HONDA MOTOR CO., LTD. 1987, ALL RIGHTS RESERVED
CONTENTS
1.
SAFETY ..............................................................................
WARNING LABEL LOCATION
SAFETY INFORMATION
2.
COMPONENT IDENTIFICATION AND FUNCTION
ENGINE SWITCH
FUEL VALVE ........................................................................
CHOKE KNOB
STARTER GRIP
THROTTLE LEVER (ENGINE SPEED)
SHIFT LEVER
CHUTE GUIDE
DRIVE CLUTCH LEVER
AUGER CLUTCH LEVER
HEIGHT ADJUSTMENT BOLT (TRACK MODEL ONLY)
SKID PLATE, SCRAPER
HANDLEBAR HEIGHT ADJUSTMENT
3.
PRE-OPERATION CHECK
FUEL LEVEL
ENGINE OIL LEVEL
4.
STARTING THE ENGINE
HIGH ALTITUDE OPERATION
5.
SNOWBLOWER OPERATION
STOPPING THE ENGINE
6.
7.
MAINTENANCE
MAINTENANCE SCHEDULE
TOOL KIT
ENGINE OIL CHANGE
SPARK PLUG SERVICE
TRACK-ADJUSTMENT (TRACK MODEL ONLY)
STORAGE
8.
TROUBLESHOOTING
9.
10.
SPECIFICATIONS
11.
WARRANTY SERVICE
............................................................................
...........................................................................
..................................................................
......................................................................
....................................................................
.......................................................................
......................................................................
........................
......................
................................................................
.. . ................................................................
............................................................
..........................................................
........................................................
..................................................................
...........................................................
.................................................
........................................................
..........................................
. ..................................
........................................................
.........................................................
......................................
.......................................................
. ..................................................
.........................................................
....... . ...... . ...................
....................
........................................................
...................................................
. ............. . ...............
.......................
.................
. ..........
.........................
3
3
4
6
8
8
9
9
10
10
1 1
1 1
12
12
13
13
15
15
17
18
..:;. 20
21
23
24
24
25
26
27
28
29
.; .. 32
33
34
.2
. .. :
WARNING LABEL LOCATION
Read these labels before operating the snowblower.
.I. SAFETY
ENGINE IS RUNNING
\
Honda snowblowers are designed to give safe and dependable service if
operated according to instructions. Read and understand this Owner’s
Manual before operating the snowblower. Failure to do so could result in
personal injury or equipment damage.
Before operating the snowblower, inspect the area in which you are going to clear snow. Remove debris and other obstacles the snowblower
might strike or throw that may cause injury or damage to the
snowblower.
Inspect the snowblower before operating it. Repair any damage and correct any malfunction before operation. If you hit an obstacle while
operating the snowblower, stop the engine immediately, and check for
damage. Damaged equipment may increase the possibility of injury during operation.
Do not use the snowblower when visibility is, poor. Under conditions of
poor visibility, there is a greater risk of striking an obstacle or causing
injury.
Never use the snowblower to clear snow from a gravel road or
driveway, as rocks may be picked up and thrown. They may cause injury to bystanders.
Adjust the snow discharge chute to avoid hitting the operator,
bystanders, windows, and other objects with thrown snow. Stay clear
of the snow discharge chute while the engine is running.
Children and pets must be kept away from the area of operation.to avoid
injury from flying debris and contact with the snowblower.
To avoid overturning, be careful when changing the direction of the
snowblower while operating it on a slope. Do not use the snowblower to
remove snow from roofs. The snowblower may overturn on, steep
slopes if left unattended, causing injury to the operator or bystanders.
4
mEm
l
Know how to stop the snowblower quickly, and understand the operation of all controls.
l
Never permit anyone to operate the snowblower without proper instruction. If people or pets suddenly appear in front of the snowblower while
it is in operation, immediately release the auger and drive clutch levers to
stop the snowblower and avoid possible injury from rotating auger
blades.
l
If the snow discharge chute becomes clogged, stop the engine and use a
wooden stick to unclog. it. Never put your hand into the snow discharge
chute while the engine is running: serious personal injury could result.
l
Gasoline is extremely flammable and is explosive under certain conditions. Do not smoke or allow flames or sparks where the snowblower is
refueled or where gasoline is stored. Refuel in a well-ventilated area with
the engine stopped. Do not overfill the fuel tank, and make sure the filler
cap is closed securely after refueling.
l
Never run the engine in an enclosed or confined area. Exhaust contains
poisonous carbon monoxide gas; exposure can cause loss of consciousness and may lead to death.
l
The muffler becomes very hot during operation and remains hot for a
while after stopping the engine. Be careful not to touch the muffler while
it is hot. Let the engine cool before storing the snowblower indoors.
l
Always make a pre-operation inspection (page 15) before you start the
engine. You may prevent an accident or equipment damage.
NOTE: While operating the snowblower, hold the handle firmly, and walk,
don’t run. Wear suitable winter boots that resist slipping. .
5
2. COMPONENT IDENTIFICATOON AND FUNCTION
WHEEL TYPE
CHUTE- Y” 1
AUGER
,
DRIVE CLUidH LEVER
THROTTLE LEVER
AUGER CLUTCH LEVER
SH’FT tEVER I
11 \\
CHOKE KNOB
-
CHUTE GUIDE
I
ENGINE OIL
,FILLER CAP
FUEL VALVE \
STARTER GRI
ENGINE OIL DRhlN PI
TRACK TYPE
CHUTE
ENG!NE SWITCI
CHOKE KNOB
‘MUFFLER
TRACK
DRIVE Cl
AUGER CLUTCH LE
LUTCti LEVER
THROTTLE LEVER
FUEL VALVE
STARTER GRIP
SHIFT LEVER
ENGINE OIL DRAIN/PLUG
CHUTE GUIDE
/
/
-
ENGIN\E OIL FILLER CAP
7
ENGINE SWITCH
Use the engine switch to turn the ignition system ON for starting, and to
STOP the engine.
ENGINE SWITCH
FUEL VALVE
The fuel valve opens and closes the fuel line leading from the fuel tank to
the carburetor. Make sure that the valve is positioned exactly at either the
ON or OFF position.
cmm
valve to OFF to prevent possible fuel leaks; spilled fuel or fuel vapor may
ignite.
Before transporting the snowblower, be sure to turn the fuel
8
CHOKE KNOB
Close the choke when the engine is cold or difficult to start.
CLOSE
STARTER GRIP
Pull this grip to start the engine.
STARTER GRIP
.9
THROTTLE LEVER (ENGINE SPEED)
,
Use the throttle lever to select engine,speed. In normal operation, use the
FAST position.
SHIFT LEVER
Use the shift lever to select drive speed or direction.
1: LOW SPEED
2: HIGH SPEED
N: NEUTRAL
R: REVERSE
10
SHIFT LEVER
Loading...