Honda Automobiles 08V03-S9A-100B, 08V03-S9A-101 User Manual

INSTALLATION

www.collegehillshonda.com/parts

INSTRUCTIONS

Accessory Application Publications No.

AUTOMATIC DAY/NIGHT

MIRROR

ATTACHMENT KIT

2005-2006 CR-V

AII 30556

Issue Date

SEP 2005

PARTS LIST

Automatic Day/Night Mirror Attachment Kit (sold separately) P/N 08V03-S9A-101

Upper and lower covers

Clip

Day/night mirror harness

Mirror harness

TOOLS AND SUPPLIES REQUIRED

Phillips screwdriver

Flat-tip screwdriver

Small flat-tip screwdriver

10 mm Combination wrench

Ratchet

8 mm, 10 mm and 14 mm Sockets

T20 and T25 Torx bits

Diagonal cutters

Torque wrench

Isopropyl alcohol

Shop towel

Piece of steel wire

Tape measure

Scissors

Electrical tape

Pliers

Illustration of the Day/Night Mirror Installed on the Vehicle

10 Wire ties

2 EPT sealer

Ground bolt

Automatic Day/Night Mirror Kit (sold separately) P/N 08V03-S9A-100B

Day/Night mirror

Owner’s Manual

MIRROR HARNESS

DAY/NIGHT MIRROR

FUSE CASE (2A)

DAY/NIGHT MIRROR HARNESS

4202061

INSTALLATION

Customer Information: The information in this

installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.”

1. Make sure you have the anti-theft code for the radio, then write down the radio station presets.

2. Disconnect the negative cable from the battery.

08V03-S9A-1000-91

3. Remove the lens from the roof console (four

retaining tabs).

ROOF CONSOLE

RETAINING TABS (4)

LENS

4. Remove the roof console (four screws, and unplug one connector).

5. Remove the mirror by sliding the mirror up.

MIRROR HOLDER

MIRROR

4130070

6. Remove the sunvisor holders. Turn the holder 90°, then pull it out.

SCREW

CONNECTOR

ROOF CONSOLE

4130081

SUNVISOR HOLDER

4130060

7. Remove the cap from the right sunvisor (four

retaining tabs).

RETAINING TABS (4)

10. Remove the passenger’s dashboard under cover (release the three clips and two pins.)

CLIPS (3)

CAP

RIGHT SUNVISOR

TORX SCREW

4130090

8. Remove the right sunvisor (two T25 Torx screws).

9. Remove the door opening weatherstrip from the right front pillar in the area shown. Remove the right front pillar trim (2 clips).

CLIP

Pull out part way to release.

DOOR OPENING WEATHERSTRIP

PASSENGER’S DASHBOARD UNDER COVER

PINS (2)

11. Open the glove box. Release the right and left stops.

TABS (2)

STOPS (2)

GLOVE BOX

SCREW

RIGHT FRONT PILLAR TRIM

4130100

12. Remove the two screws from the bottom of the glove box, and remove the glove box.

+ 7 hidden pages