Honda Automobiles 08E55-SHJ-100, 08E51-SHJ-100, 08E55-SHJ-1000-81 User Manual

Kit No. 08E51-SHJ-100

08E55-SHJ-100

Security System Owner’s Manual

ODYSSEY

Contents

Introduction Emergency Disarming

During the Panic Alarm Activation ............ 4

During the Entry Delay Time ..................... 4

System Controls

Arming Mode (MANUAL Arming Mode (AUTOMATIC

Valet

Placing the System in the Valet Mode ...... 7

In the Valet Mode ...................................... 8

Exit From the Valet Mode .......................... 9

..................................................... 3

AUTOMATIC). 5

MANUAL) ..

Arming

Arming Methods ...................................... 10

Manual Arming (Remote Controlled) ...... 10

Automatic Arming (Passive) .................... 11

Alarm Mode

Alarm Triggered Mode ............................. 13

Disarming

Remote Control Disarming ..................... 14

Tripped Sensor Warning and Indication

Tripped Sensor Warning.......................... 15

Tripped Sensor Indication ....................... 16

Glossary ........................................................ 17

Specifications................................................ 19

Please write the serial number of the remote control and the main unit belo Keep this booklet as a record of your purchase.

Remote Control No.:

Main Unit No.:

Introduction

Congratulations on your purchase of this Honda Security System. Your Honda Security System is the product of years of research and development. It will give you many years of reliable perf protection, and convenience.

The system consists of two major components: a main unit and a remote control transmitter.

The main unit is the brain of the system. The built-in prog microprocessor monitors your vehicle for optimal protection. Security System also offers various options to tailor the system to the preferences of different users.

The remote control allows you to turn the system on and off from outside the vehicle while simultaneously locking and unloc doors*. The transmitter can also be used to intentionally activ horn in case of an emergency.

To take full advantage of your Honda Security System, w you to read this manual thoroughly.

The Security System can be operated with the vehicle’ For operation of the Keyless Entry System, refer to the v

ormance,

rammable

The

king the

ate the

e encourage

s Keyless Entry System.

ehicle Owner’s Manual.

Due to the expertise required to properly install the Honda Secur System, we highly recommend that the installation be perf your Honda dealer. Proper wiring and component placement are essential for optimum system performance.

ormed by

ity

Emergency Disarming

During the Panic

• The system can be disarmed using the ignition ke

Alarm Activation

• This method of disarming also serves as an emergency o

LOCK

During the Entry Delay Time

Status LED

LOCK

the system.

transmitter cannot be used.

Enter the vehicle and insert the ignition key.

Turn the ignition key to the ON (II) position. The system stops the panic alarming when the ignition k Check to see the status LED goes off.

4625011B

• When the system is being armed by the AUTOMATIC ar 20-seconds entry delay time after opening a door or the tailgate

• If the system is armed by the remote control transmitter seconds, and the alarm is triggered immediately when a door is opened.

To disarm the entry delay time mode, insert the ignition k

Turn the ignition key to the ON (II) position. The security system disar turned to the ON (II) position. Check to see the status LED goes off.

y regardless of the method used to arm

verride if the remote control

ey is turned to the ON (II) position.

ming method, there is a

, the entry delay time is set to 0

ey after opening a door or the tailgate.

ms when the ignition key is

System Controls

Arming Mode (MANUAL

AUTOMATIC)

within 5 seconds

4625020B

This section explains how to change the arming mode from MANU

The arming mode of the Security System is preset to MANU

NOTE:

NOTE: Steps 1 thru 5 must be completed within 5 seconds.

Insert the ignition key.

Remove the ignition key from the ignition switch. (All the w

Insert the ignition key.

Remove the ignition key from the ignition switch. (All the w

Insert the ignition key. Observe that the system beeps once.

MANUAL MODE

AUTOMATIC MODE

ay out)

The switching procedure is

Not completed No beep

Completed

AL to AUTOMATIC.

AL arming.

The result

Beep once

System Controls

Arming Mode (AUTOMATIC

4625030B

4 5

6 7

LOCK

MANUAL)

Status LED

4625051B

within 5 seconds

4625020B

This section explains how to change the arming mode from A

Turn the ignition key from the ON (II) position to the LOCK (0) position. Remove the key from the ignition switch.

Open a door or the tailgate and close it. (The EXIT dela Check that the status LED blinks.

NOTE: Steps 3 thru 7 must be completed within 5 seconds.

Insert the ignition key.

Remove the ignition key from the ignition switch. (All the w

Insert the ignition key.

Remove the ignition key from the ignition switch. (All the w

Insert the ignition key. Observe that the system beeps twice.

AUTOMATIC MODE

MANUAL MODE

The switching procedure is

UTOMATIC to MANUAL.

y starts.)

ay out)

Not completed No beep

Completed Beep twice

The result

+ 14 hidden pages