HONDA 08E55-S01-100H User Manual

INSTALLATION

www.collegehillshonda.com/parts

INSTRUCTIONS

Accessory Application Publications No.

SECURITY SYSTEM

(LX/EX/VP MODELS ONLY)

2000 CIVIC

4-DOOR

AII 20469

Issue Date

AUG 1999

PARTS LIST Security System (sold separately):

P/N 08E51-S01-101F

Control unit

Owner’s Man ual (discard)

2 Washer-scre ws (not used)

Relay 4-pin

Remote T ransmitter (sold separately): P/N 08E61-S01-101

(Required for LX model only) 2 T ransmitters

Owner’s Man ual

Security Attachment (sold separately): P/N 08E55-S01-100H

Control unit bracket

Relay 5-pin

2 Fuses (3A)

2 Long wire ties

Card (not used)

2 Decals

Fuse box label

LED

Disarm switch

Push nut (for LED)

2-Pin connector

Y0540-B

08E55-S01-1H00-91

3-Pin connector

Nut

Washer

INSTALLATION

Customer Information: The information in this

installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your car . These procedures should not be attempted by “do-it-yourself ers.”

Owner’s Man ual

Cushion tape

2 Collars

Flange bolt, 6 x 12 mm

2 Bolts, 4 x 30 mm

Wire tie

4 Short wire ties (white)

NOTE: The Owner’s Man ual included with the Security Attachment should be placed in the glove box for future reference. The Owner’s Man ual included with the Security System should be discarded.

1. Make sure you hav e the anti-theft code f or the radio , then write down the frequencies for the preset buttons.

2. Disconnect the negative cable from the battery.

3. Check to be sure the switch on the control unit is in the correct mode for the HX, EX and VP models .

CX/DX

HX/LX/EX

CONTROL UNIT

Resistor

The knob is set in this position at the

TOOLS AND SUPPLIES REQ UIRED

Phillips screwdriver Stubby Phillips screwdriver Drill Eye protection (face shield, safety goggles, etc.)

5.5 mm and 12 mm Drill bits T ape measure 10 mm and 12 mm Sockets Ratchet

Tear off this label.

7 mm, 10 mm, 12 mm and 17 mm Combination wrenches Diagonal cutters Utility knife Electrical tape

factory.

4. Remove the driver's dashboard lower cover:

• Remove the three screws.

• Gently pull along the top to release the three retaining clips.

• Unplug the connector(s) and remove the co ver.

6. Remove the left kick panel (two clips, and slide back while pulling its lower end inside).

RETAINING CLIP

CLIP (LARGE)

DRIVER'S DASHBO ARD LOWER CO VER

MOONROOF MODEL

5. Remove the knee bolster (two bolts).

SELF-TAPPING SCREW

LOWER END

CLIP

LEFT KICK P ANEL

7. Remove the upper steering column cover (three screws and six clips).

UPPER STEERING COLUMN COVER

TAB

Push.

BOLTS

KNEE BOLSTER

SELF-TAPPING SCREWS

+ 5 hidden pages