Homewood BUNN0404DSL-1AA Instruction manual

© Bunny playhouse
Complies with EN71
These instructions are for your safety. Please read through them thoroughly before use .
Version 5 16/01/2015 Julian Shepherd
PLEASE KEEP THIS LEAFLET FOR FUTURE REFERENCE
GB
Let’s
get started...
Important information...
Safety 03
Base and positioning 04
Warranty 04
Care maintenance & Recycling 05
In more detail...
Hardware Chart & Fascia bag 06-07
Stacked Parts List 08-09
02
Detailed Technical Drawings 10-11
12 Before you start
Assembly instructions 13-24
For a copy of the instructions or a copy in another language please send
EN
Pour obtenir un exemplaire des instructions ou une copie dans une autre
F
langue s'il vous plaît envoyez un e-mail ou écrire à l'adresse ci-dessous.
Na kopii instrukcji lub kopii w innym języku prosimy o wysłanie maila
PL
RUS
Для получения копии инструкции или копия на другом языке, пожалуйста, отправьте по электронной почте или написать по
Başka bir dilde talimatları veya bir kopyasını bir kopyası için bir e-posta
TR
Brigstock Road Wisbech Cambridgeshire PE13 3JJ
an email or write to the address below.
lub pisać na adres podany poniżej.
указанному ниже адресу.
gönderebilir veya aşağıdaki adrese yazınız.
customerservice@shiregb.co.uk
Tel 01945 465 295
Safety
Check that you have noted all the following instructions
We advise the use of non slip protective gloves throughout the assembly process.
We advise the use of steel capped protective footwear throughout the assembly process
We advise the use of protective headwear and safety goggles throughout the assembly process
Where a ladder is in use another person must hold the ladder.
Do not attempt to work in windy conditions
We advise the use of a scaffold tower when fitting the roof , for felting or if you cannot reach from the ground.
Do not allow children near the tools and work area
Follow any safety precautions quoted by the manufacturer for any equipment you use
Check all parts before assembly
Only use child and animal safe wood preservative
Do not use creosote
GB
IE
Started…..
Getting
Allow the wood preservative to fully dry before use
Regularly check the building for wear and tear
Children must be supervised at all times while playing with this playhouse
Not suitable for children under 3 years old.
Important!
EVERY PRECAUTION IS TAKEN TO ENSURE THAT YOUR BUILDING HAS NO ELEMENT INCORRECTLY PLACED OR POSSIBLY HAZARDOUS, HOWEVER PRIOR TO USE PLEASE CHECK ALL SURFACES FOR THE FOLLOWING:
(1) (1) RAISED GRAIN, SPLINTERS: Sand down timber to smooth finish (2) (2) NAIL/SCREW/PIN HEADS PROUD: Tap home to be flush with surface of timber (3) (3) DAMAGED SCREW HEADS RESULTING IN SHARP SPLINTERS OF METAL: Replace (4) (4) SHARP ENDS OF NAILS/ SCREWS/ PINS PROTRUDING THROUGH THE PANEL: Re-
move and reposition.
(5) (5) ENSURE ALL PARTS ARE SECURED AGAINST REASONABLE FORCE: Remove and refit
(6) (6) ENSURE THERE ARE NO LOOSE PARTS: Remove and refit/discard
IMPORTANT !
read carefully the safety warnings
For your saf ety pleas e
03
GB
IE
04
Started…..
Getting
Base and Warranty
Preparation of base...
We recommend that the base onto which your building will stand should be at least 75mm larger in each direction than the total floor size of the building.
Actual floor area of the building: 1190mm x 1190mm Total height clearance: 1408mm Roof size 1283mm wide x 1260mm long The chosen position in your garden for your building should be excavated to a depth of 75mm to allow a base of sand, on to which paving slabs can be evenly laid. You may also use an adjustable timber base or a concrete base. Whatever base you
decide upon IT MUST BE LEVEL AND FIRM.
Warranty...
10 Year anti rot warranty subject to the following -
The building must be raised so it is not in contact with any water
retaining base surface (for example grass).
This can be achieved using a timber, concrete or slab base
When using a concrete or slab base use damp proofing strips
under the bearers
The building must have been completely treated and sealed
immediately prior to or after assembly
The building must have been re-treated and re-sealed annually
If your building has been pressure treated or has any pressure treated
parts additional treatment need not be applied (except for aesthetic purposes )
Wood is a natural product and therefore the following are excluded
from the warranty
Colour changes Warping Splitting
The following are also excluded
Damage resulting from poor assembly
Poor treatment application
Poor care and maintenance
Changes to the design
Misuse
General wear and tear
Care, Maintenance and Recycling
The 5 golden rules of care
(1) Ensure your base is level and firm (2) Ensure the building is not sitting directly on the ground using damp proof
membrane or the optional timber base.
(3) Ensure every piece of timber and surface, especially that is hidden upon
assembly is treated with a top quality wood preservative at least twice (see note on pressure treated buildings in warranty section). Turn the panels upside down whilst painting so the treatment runs into the seams.
(4) Garden buildings are not waterproof, therefore we recommend you seal
between all the panels with a silicone based sealant .
(5) Regularly check your roofing felt for weather damage and leaks
GB
IE
The 7 golden rules of maintenance
(1) Re apply the timber treatment annually. (see note on pressure treated
buildings in warranty section)
(2) Visually check for weather damage
(3) Check and replace if necessary any Silicone sealant if used on your
building. (4) Check the roofing material for wear (5) The doors and windows may require periodical adjustment (6) Ensure your building is well ventilated especially during hot weather (7) During extremely hot periods humidify your building to prevent the timber
from drying out .
Recycling and disposal
1. Pallet and timber widely recycled
2. Cardboard widely recycled
3. Plastic strapping subject to local regulations
4. Plastic sheeting subject to local regulations
packaging
1. Timber widely recycled
2. Metal fixings widely recycled
3. Glass widely recycled
4. Roofing felt not currently recycled
Started…..
Getting
Building
05
Fascia & nail bag contents
Hardware Chart
Scale 1:1
08mmFelt Nail
(A0266) x107
16mm Panel Pin
(A0024) x64
40mmRound head nail
(A0025) x94
12mm Flat head Posi-drive screw (A0027) x04
08
12
Note These 12mm screws With roller catch
25mm Posi-drive screw
(A0032) x41
Black 25mm
Posi-drive screw
(A0031 ) x04
60mmPosi-drive screw
(A0035) x26
06
Fascia & nail bag contents
3 point Hinge 944mm
(A0507) x01
Casement set Safety vent
(A0038) x01 (A0476) x02
Black ring handle
(A0508) x01
Window Hinge
(A0013) x02
Fascia
(A0478) x04
Diamond Roller catch
(A0479) x02
Beading 205mm
(A0481) x32
8.5mm
8.5mm
(A0090) x01
07
Description
(part No ) qty
Stacked parts list
Door
(A0506) x1
968mm
521mm
34s framework
Floor joists
(A0468) x04
34mm`
34mm`
Window insert
(A0466) x01
500mm
(A0469) x01
1020mm
500mm
1120mm
Floor panel
(A0467) x01
1190mm
Plain panel (sides) Plain panel (Back)
(A0470) x02
1190mm
1020mm
1190mm
08
Door Panel
(A0471) x01
1020mm
1120mm
Gable panels
(A0473) x02
Felt strips 1.32m
(A0474) x02
331mm
1214mm
Loading...
+ 16 hidden pages