HomeTech WS-G-03-2, WS-G-03-2-Mini Owner's Manual

1

WS-G-03-2

ELECTRIC CURVED PANEL FIREPLACE HEATER

OWNERS MANUAL

Model Numbers: WS-G-03-2 &WS-G-03-2-Mini

Only use this heater as described in this manual. Any other use is not recommended
by the manufacturer, and may cause fire, electric shock, or other personal injury.

WARNING! Read and understand this entire owner’s manual, including all safety
information, before plugging in or using this product. Failure to do so could result in fire,
electric shock, serious personal injury, or death.

WARNING! INDOOR use only! NEVER use this heater outdoors!

SAVE THESE INSTRUCTIONS!

CAUTION! Keep this owner’s manual for future reference.If you sell or give this product

away, make sure this manual accompanies this product.

WS-G-03-2-Mini

2

IMPORTANT SAFETY INFORMATION!

WARNING

1.ALWAYS keep electric cords, home furnishings, drapes, clothing, papers, or other
combustibles at least 3 feet (0.9m) away from the front of this heater, and away from the

bottom, sides, and rear of this heater.

2.DO NOT place the heater near a bed because objects such as pillows or blankets can fall off
the bed and be ignited by the heater.

3.DO NOT COVER this heater or block the air vents at all. Doing so could cause a fire.

4.AVOID fire or electric shock! NEVER insert or allow any foreign objects to enter the

ventilation or exhaust openings of this heater.

5.Prevent Fire! Keep all flammable liquids, like gasoline or paint, away from this heater. This
heater produces arcing sparks that could ignite flammable liquids.

6.DO NOT cover this heater in any manner. Doing so could block the air flow and cause the unit
to overheat, or could ignite the material covering the heater.

7.NEVER run the power cord under carpet, rugs, runners, or any other covering. Doing so could
cause the cord or materials covering the cord to overheat.

8.AVOID FIRE! Regularly inspect all air vents to make sure they are free from dust, lint, or other
blockage. Unplug the unit and clean with a vacuum ONLY. DO NOT rinse or get wet.

WARNING

1.For residential use only! NOT for commercial use! NEVER use this fireplace for other than

its intended purpose.

2.ALWAYS HANG UNIT BEFORE USE. DO NOT turn on or use while the unit is sitting on the
floor, ground, or other surface.

3.The wall mount system is designed for use ONLY with this product. NEVER use a wall
mount system from another manufacturer.

4.Use extreme caution if using this heater near children, or where children may be present.

5.NEVER leave this heater unattended. ALWAYS unplug this heater when not in use.

6.This heater is hot when in use. AVOID INJURY! DO NOT TOUCH hot surfaces, or attempt
to move this heater while it is hot.

7.ALWAYS turn this heater off before unplugging it from the outlet.

8.AVOID INJURY! Keep the cord from crossing traffic areas to avoid tripping.

9.NEVER modify this fireplace. Doing so could result in personal injury or property damage.
Modification of this fireplace completely voids all warranties.

10.Discontinue use if this fireplace malfunctions or is dropped or damaged in any manner.

11.ALWAYS store this heater in a dry location. NEVER use the fireplace if it has become wet.

3

WARNING

1.Risk of electric shock! DO NOT OPEN! No user-serviceable parts inside!

2.ALWAYS disconnect this unit from the power supply before performing any assembly or
cleaning, before replacing the light bulb, or before relocating the electric fireplace.

3.NEVER use this heater in bathrooms, laundry rooms, or any other location where the heater
could fall into a bathtub or pool, become damp or come in contact with water.

4.NEVER hang this unit on a wall directly below an electrical outlet.

5.NEVER operate this heater if the power cord or plug has become damaged, or if the
grounding pin is damaged or missing.

6.Place the heater near a wall outlet so an extension cord is not needed.Always plug heaters

directly into a wall outlet/receptacle.Never use with an extension cord or relocatable power
tap(outlet/power strip).

7.Avoid hazards due to resetting of the thermal cut-off switch. NEVER control this unit with a
timer, or allow it to be on a circuit regularly switched off by the utility.

8.ONLY use this heater on a 120 Volt 15 Amp grounded circuit. NEVER overload the circuit.

If this heater trips the circuit breaker, unplug all other appliances on the same circuit before the
next use. Avoid plugging other appliances into the same circuit as this heater.

9.NEVER plug this heater into an outlet that is old, cracked, or has any loose wires or
connections. Plugging this heater into a faulty outlet could result in electric arcing within the
outlet that could cause the outlet to overheat or catch fire.

10.ALWAYS check your heater cord and plug connections with each use!

i) MAKE SURE the plug fits tight in the outlet! Faulty wall outlet connections or loose plugs

can cause the outlet to overheat.

ii) Heaters draw more current than small appliances. Overheating may occur even if it

has not occurred with the use of other appliances.

iii) During use check frequently to see if the plug outlet or faceplate is HOT!

iv) If the outlet or faceplate is HOT, discontinue use immediately and have a qualified

electrician inspect and/or replace the faulty outlets.

The cord supplied with the heater has a

plug with two blades (live and neutral) and
one round pin (ground). If a 3-slot
receptacle is not available, an adapter

MUST be used. The adapter MUST be
properly grounded to the outlet box (see

figure at right).

4

Preparation

E - Wall Bracket (1)

F - Decorative Glass

H-ST5x10 Screws (8)

I - M6x15 screws for TV

bracket（4pcs）-WS-G-03-2

This product includes a GLASS! Always use extreme caution when handling glass.
Failure to do so could result in personal injury or property damage.

Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts
and assembly steps are grouped for free-standing or wall-hanging use. Check the parts list to make
sure nothing is missing. Dispose of packaging materials properly. Please recycle whenever possible.

You will need the following tools (not included): Phillips screwdriver; stud finder; level; tape
measure; electric drill; 1/4” wood drill bit, 1/16” wood drill bit, and a hammer.

Parts and Hardware

B – Wood Screws ( 3 ) C – Drywall anchors ( 3 )

A – Fireplace ( 1 )

G - TV bracket（2pcs）

D – ST4x8 Metal Screws (2) RC – Remote Control

J-Glass Tray（1）

K- M6x15 screws for TV

bracket（6pcs）-WS-G-03-2-

Mini

5

Installation and Assembly

Rear View of Fireplace

19.7”

(50 cm)

Minimum 39.4”

(100 cm)

Drywall

Studs

Minimum 59.1”

(150 cm)

19.7”

(50 cm)

Wall mounted installation

Step 1. Find a safe location.

Minimum clearance on each side: 19.7”
(50 cm).

Minimum clearance below: 59.1”
(150 cm).

Minimum clearance above: 39.4”
(100 cm).

Minimum clearance from the front and
sides: 3 feet (90 cm).

Choose a location near an outlet so an
extension cord is not required.

DO NOT position the unit directly below
a power outlet.

See Safety Information on pages 2 and

3 for warnings about safe placement,
safe installation, and proper use of this

product.

NOTICE

ALWAYS unplug this fireplace heater before assembly or cleaning, or before
relocating. Failure to do so could result in electric shock, fire, or personal injury.

The wall mount fasteners included with this fireplace are for use ONLY with a
wood-framed wall covered in drywall (sheet rock). For concrete walls, cinder
blocks, or other wall types, consult a professional for the best attachment methods.

STEP 2. A. Locate the wall studs using an electronic stud-finder. B. The two outer screws should
be screwed into a wall stud, and the center screw into a drywall anchor. C. If only one stud is
available, the center screw MUST be screwed directly into it, and the two outer screws may be