Home Styles 9001-0411 User Manual
88 9001 004C
Cuisine Cart
IMPORTANT NOTE
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damage occurring to the parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure a
completed product as it was designed.
Part List
C.
Base
1 Pc.
F.
Back Stretcher
1 Pc.
A.
Side Panel
1 Pc.
B.
Side Panel
1 Pc.
H.
Side Rack
1 Pc.
I.
Side Rack
1 Pc.
Hardware List
J.
Brush Chrome Pipes
3 Pcs.
K.
Base Rack
1 Pc.
L.
Side Tower Bar
1 Pc.
D.
Back Upright
1 Pc.
N.
Door
1 Pc.
E.
Back Panel
2 Pcs.
M.
Shelf
1 Pc.
O.
Door
1 Pc.
G.
Front Rail
1 Pc.
P.
Drawer
1 Pc.
(Please refer to the last page of these
instruction for drawer assembly steps)
Head Cap Bolt(Middle)
for T op
4 Pcs. (+1 extra)
Head Cap Bolt(long)
12 Pcs. (+1 extra)
Caster
two lock
two non-lock
4 Pcs.
Hex Wrench
1 Pc.
Small Hex Wrench
1 Pc.
Tools required for assembly : Phillips screwdriver
Home Styles Consumer Assistance: www.homestyles-furniture.com,
servicedesk@homestyles-furniture.com, 888-680-7460, 877-831-0319
Head Cap Bolt
for Side Tower Bar
2 Pcs. (+1 extra)
Machine Screw
for Knob
2 Pcs.
Wood Screw
for Caster
16 Pcs. (+1 extra)
Adjustable Pin
4 Pcs. (+1 extra)
Knob
2 Pcs.
Wood Plug
8 Pcs. (+1 extra)
Assembly Instructions
IMPORTANT
* Please keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
* Do not tighten up all the bolts until each part is properly assembled.
* Use a soft cloth between these parts and the fl oor.
Wood Screw for Caster
2
/5
STEP 1
Attach Casters to Base (C) with
Wood Screws for Caster.
(See fi gure 1)
Head Cap Bolt
A
Non-Locking Caster
C
Locking Caster
F
G
D
E
E
C
Locking Caster
STEP 2
Attach Side Panel (A) to Base (C) with Head Cap Bolts.
Attach Back Upright (D) to Base (C).
Slide Back Panels (E) into place.
Figure 1
B
Figure 2
Attach Back Stretcher (F) and Front Rail (G) to Side Panel (A) with Head Cap Bolts.
Attach Side Panel (B) to the unit with Head Cap Bolts.
Tighten all Bolts with Hex Wrench. (See fi gure 2)
Loading...