Page 1
88 5061 20
Orleans
End Table
IMPORTANT NOTE
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damages occuring to the parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure a
completed product as it was designed.
Part List
A.
Top Unit
1 Pc.
B.
Leg
2 Pcs.
C.
Leg
2 Pcs.
D.
Shelf
1 Pc.
Hardware List
1/4x3/4”
Hex Wrench
1 Pc.
Small Hex Wrench
1 Pc.
Tapered Head Cap Bolt
8 Pcs.(+1 extra)
Tools required for assembly : Phillips screwdriver Tools recommended for assembly : Level
Home Styles Consumer Assistance: www.homestyles-furniture.com,
servicedesk@homestyles-furniture.com, 888-680-7460, 877-831-0319
1/4x1 1/4”
Tapered Head Cap Bolt (long)
8 Pcs.(+1 extra)
Page 2
Assembly Instructions
IMPORTANT
* Do not tighten up all the bolts until each part is properly assembled.
* You should keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
* Use a soft cloth between these parts and the fl oor.
* After assembly, item must be level to work properly. Use the included adjustable levelers to level.
STEP 1
Place Top Unit (A) upside down on a soft cloth.
Rotate the Plastic Stopper on the front rail of unit
180 degrees. (See Figure 1)
Remove drawer from Top Unit (A)
Plastic Stopper
B
A
2
/3
Figure 1
Tapered
Head Cap Bolt (long)
B
B
B
C
B
D
B
A
Tapered
Head Cap Bolt
B
C
B
B
STEP 2
Attach Legs (B) and (C) to Top Unit (A) with
Tapered Head Cap Bolts (long).
Attach Shelf (D) to unit with with Tapered Head Cap Bolts.
Attach Legs (B) and (C) to unit with Tapered Head Cap Bolts (long)
and Tapered Head Cap Bolts.
Page 3
STEP 3
Remove the Pull Handle that is installed
on the inside of drawer and re-install
it on the outside of the drawer.
Plastic Stopper
Assembly Instructions
3/3
STEP 4
Turn the unit over to its’ upright position.
Rotate the Plastic Stopper on the front rail of unit 180 degrees back to
its’ original position.
Slide drawer into place.
To level the unit, adjust the adjustable levelers on the bottom of legs.
(See Figure 2)
Note : Unit must be level to work properly.
Figure 2
Loading...