Homestar TED28 BC Owner's Manual

1-855-837-2569

bC

Scan the below QR code

to download Smart Flame.

20.When the mantel slide doors cover the firebox, the firebox
will be closed, if you move away the doors, the firebox will
restar to

work. Make sure the power is turned off when you are

not use the unit.

21. The firebox can be controlled with Bluetooth by Iphone and
Android mobile phone, please refer to the page E-5, E-6 for detailed
operation instructions.

22. SAVE THESE INSTRUCTIONS

and dust.

E-1

licensed

19.The heater has a safety device that makes it stop working
once the inner temperature reaches 85º (± 2°C). To reset the
appliance, turn heater off and disconnect power, let it cool off
for 10 minutes and plug back in.

tap (outlet/power strip).

fire, electric shock or injury to persons.

9.2 kg / 10.2 kg

23 1/8 x 7 x 17 5/8 inch
59 x 17.9 x 44.8 cm

E-2

This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority
to operate the equipment.
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for
help.
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between
the radiator & your body.