Homeselects 6664, 6662 User Manual

TROUBLESHOOTING:

Possible Cause Corrective Action

Light will not turn on.

.hctiws ecalper ro tseT .2.hctiws ytluaF .2

3. Faulty wire connection. 3. Check wiring.

Fuse blows or circuit breaker
trips when light is turned on.

1. Crossed wires or pow er wire is
gro u nd in g

out.

PRODUCT MAINTENANCE:

1. To clean the outside of the xture, use a dry or slightly dampened clean cloth (use clean
water, never a solvent) to wipe the surface of the xture.

2. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry soft

cloth to dust or wipe carefully.

LIMITED WARRANTY

The manufacturer warrants this lighting xture to be free from defects in materials and workmanship for a
period of ve (5) years from date of purchase. This warranty applies only to the original consumer
purchaser and only to products used in normal use and service. If this product is found to be defective, the
manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the product at
the manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse,
accident, modications, alterations, neglect or mishandling. This warranty shall not apply to any product
that is found to have been improperly installed, set-up, or used in any way not in accordance with the
instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of
an accident, misuse, abuse, negligence, alteration, or faulty installation, or any other failure not relating to
faulty material or workmanship. This warranty shall not apply to the nish on any portion of the product,
such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not
warrant and specially disclaims any warranty, whether expressed or implied, of tness for a
particular purpose, other than the warranty contained herein. The manufacturer specically
disclaims any liability and shall not be liable for any consequential or incidental loss or damage,
including but not limited to any labor/expense costs involved in the replacement or repair of said
product.

1. Check wire connections.

.no si ylppus rewop erus ekaM .1.ffo si rewoP .1

LED Linear Light

Models 6662 - 6664

INSTALLATION MANUAL

www.HomeSelects.com

Installation

DANGER: Before installation, turn o the main

power at the circuit breaker.

WARNING: Installation must be performed by a

qualied licensed electricion.

TOOLS REQUIRED FOR INSTALLATION
AND ASSEMBLY

Phillips

screwdriver

Safety

goggles

(not included):

Flathead

screwdriver

Electrical

tape

Wire

cutters

Wire

strippers

Install Fixture Mounting Screws

2

A. Install xture mounting screws (A)

A

Connecting the wires

3

A. Connect the white supply wire to the white xture wire.

B. Connect the black supply wire to the black xture wire.

C. Connect the ground supply wire to the ground xture wire.

D. Use wire nuts to secure all connections.

Installing the ceiling fixture

4

A. Tuck the xture wires into the ceiling box.

Installing the ceiling fixture

5

A. Install the xture base (B) onto xture screws and
secure into slots.

B. Install the magnetic cover plates

Powered by TCPDF (www.tcpdf.org)

Removing the existing fixture

1

A. Remove the existing xture.

GROUND Supply Wire

GROUND Fixture Wire

WHITE Supply Wire

BLACK Supply Wire

WHITE Fixture Wire

BLACK Fixture Wire