Home Plus H+P User Manual

H E AT S Y S T EM

1

2

3

WIRELESS SYSTEM

FOR HOUSE HEATING MANAGEMENT

GUARANTEE TERMS – H+P PROGRAMMER

GUARANTEE TERMS:
Guarantee is granted by manufacturer for 24 months period star ting from
date of sale, but no longer than 36 months from date of the manufacture.

Defects revealed within this period, resulting from a fault of manufacturer will be
repaired free of charge or the item replaced with new, equivalent one.
Term of complaints’ investigation up to 14 (fourteen) days from date of submis­sion to the manufacturer.

Guarantee does not cover:

1. Using of product in a manner noncompliant with attached instructions.

2. Any visible damage to the controller due to improper use.
Damaging of manufacturer’s seals makes the guarantee null and void.

In the event that Heatpol are unable to repair or replace this product
we reserve the right to refund the purchase price as an alternative.

GUARANTEE CARD
Serial No.:
Serial No.:

Stamp of retail outlet, signature of seller
Caution: The guarantee card should be legibly led in retail outlet. Any corrections on

the guarantee card will invalidate the guarantee. Guarantee card valid only with proof of
purchase.

Mników 322, 32-084 Morawica
Tel/fax: [phone]
Poland

www.homeplus-system.com

2

SAFETY

The H+P programmer is powered by the battery, which is permanently mount­ed in the device. Use only approved power supply (charger) – the type is giv-

en below. Use of incompatible charger may cause re or explosion of the battery.

This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. Children shall not
play with the appliance. Cleaning and user maintenance shall not be made by chil­dren without supervision. The device complies with the directive RED 2014/53/UE

MAINTENANCE

The casing may be cleaned using a soft cloth. Avoid soaking the casing.

BATTERY CHARGING

When programmer shows low battery level, connect the suitable charger (with mi­croUSB connector) to microUSB socket on the side of programmer’s casing. Recom­mended charger: Goobay 46600. We recommend to disconnect the charger when the
battery is fully charged (the battery icon on the programmer display is fully green).

TECHNICAL DATA:

Power/charge: charger Wentronic, Goobay 46600, 1000 mA, 5V, microUSB.
Radio comunication frequency: 867,8 MHz, power transmitter <10dBm.
Operating temperature range: 0-45°C. Temperature control range: 10-30°C.
Work cycle: weekly, programmable. Work status control: OLED display.
Operating range: depending on the structure of the building and walls – ca.30m,

in the open area – more than 100m.

TECHNICAL INFORMATION/SAFETY

Check more at: www.homeplus-system.com

3

ON

OFF

Home + System allows to manage electric heating system, com­posed of max. 8 heating zones (Z1, Z2, etc.) and max. 24 radiators

installed in rooms. The system permits to group them and programm am­bient temperatures in different modes, which you can adjust individually.

4

Home + System programmer is designed to operate with electric heaters
made by Heatpol:

– H+ heater for bathroom radiators
– H+h heater for column, aluminium and cast iron radiators

Thank you for choosing the HOME + for your house!

H+hH+

H+P

www.homeplus-system.com

H+R

Remote control of electric
heating in your house

5