HOME OF POI Ninja User Manual

Firstly ...Nothing is indestructible. Ninja’s are designed for normal

Problem

Solution

Does not turn on.

Check the battery is working in another device.
Are they fully charged?
Is the battery inserted the correct way around? Check Polarity.
Press and hold down the power button for a few seconds to turn
on.

It went flat even though it
was turned off

Our NiMH rechargeable batteries supplied are only partially
charged so will need to be charged again sooner. Some cheap
rechargeables will only hold a decent charge for a few weeks
before needing another charge.
We recommend charging the units before any important use.

use, not abuse.

Durability.

The Ninja LED Poi contains a circuit board with small chips,
resistors, LEDs, Transformer and switches. All of which are very
fragile on their own. Some difficult components are carefully
installed by hand the rest is completed by machine robot.

The casing is injection moulded ABS plastic which is strong but again can be broken with excessive
force. It’s main purpose is to protect the circuitry from direct impacts and hold the battery and cords in
place.

The rings are either PVC or Rubber depending on the color. They create a buffer zone around the
casing to reduce most impacts, they hold the casing together as well as securing the battery lid into
place.

We do try our best to make sure each version of the Ninja LED Poi is better than previous ones. And
we really appreciate the feedback we get. However hard knocks and smashing them together or
against hard surfaces can potentially cause parts to fail or break.

Replacement Parts.

We offer in our online shop next to the option “Add to Cart/Basket” a button called “Purchase Parts”.
This will allow you to purchase the latest replacement parts to easily get the unit back to working
order.

If you are not sure what you need our support team is able to help you. [e-mail]

www.homeofpoi.com | [e-mail]

Problem

Solution

Unit turns off in use

Check batteries, very cheap or flat batteries don’t have enough
power to run the unit and can cause the lights to turn off easily.
Check the battery contacts are free of debris, clean if necessary.
Check the battery connections are tight. Some forces can bend the
battery contacts. Remove circuit board by taking off rings and
clicking open the halves of the case. Bend by hand the battery
contacts inwards. Rebuild and try again.
Your battery contacts may be oxidized. Check for any black marks
or debris on the batteries and contact points within the battery
holder. Clean with a pencil eraser, protect and clean with
Petroleum Jelly or a mineral oil.

Ninja Operating Instructions.

To switch on press the power button ‘ ‘ for 2-3 seconds and you are in mode 1. Press again for
modes 2, 3, 4, 5 etc.. To change between colors and patterns within each mode press the ‘ ’
button. To switch off hold down the power button for a few seconds. The stick will flash once then
switch itself off. The unit will return to the previously set mode and pattern when turned back on.

Ninja LED Poi Modes

A total of 84 functions + demo mode.

Mode 1. Rainbow, Slow Fade, RGB Flash, Multi-step chase, Triple phase rainbow.
Mode 2. Solids, Multi-solid... in multiple colors.
Mode 3. Chase, cogs, stars... in multiple colors.
Mode 4. Strobes, cogs, stars continued in multiple colors.
Mode 5. Mixed solid and strobes, waves and stars in multiple colors.
Mode 6 and 7. Custom patterns the HOP team designed, see website for examples.
Mode 8. Demo mode, cycles through 40 patterns, each pattern 10 seconds long.

Replacing batteries.

To access the battery area, slide the 3 rings as shown in the picture. Lift the battery cover.

www.homeofpoi.com | [e-mail]