Home Easy HE307 User Manual
HOME
HomeEasy Remote
easy
Control Light Switch
1Gang:
The HE-307and HE-308 Remote Control
light switches are expansion units for
the HomeEasy range of products and
designed to work with all the
HomeEasy receiver sockets and
modules.
Additional HomeEasy receiver products
are required for the HE-307/HE-308 to
work.
Product Operation:
Pairing/Deleting with Remote Control:
Up to Six remote controls can be paired with each Receiver Socket or Module. To
pair the switch and a socket together, press "Learn" button. The LED will start to
flash, now press the selected "ON" button on the remote control, the LED will stop
flashing. The units are now paired together, you can test this by pressing the
selected "On/Off" button.
S1: On/Dim
S1: Off
2Gang:
S1: On/Dim
S1: Off
V1.0
Deleting Remote Control:
To delete a remote control that has been paired with a HomeEasy Receiver
socket or module, simply press the "Learn" button. The LED will start to blink;
press the "Off" button on the remote control, the LED will blink twice to
confirm that the remote control has been removed from the receiver sockets
memory.
Remote Socket reset:
To delete all the remote control units from the memory of the Receiver Socket
or module, hold the "Learn" button for more than 6 seconds, the LED will start
to blink continuously. Press the learn button again, the LED will blink twice to
confirm the deletion of all remote controls form the receiver memory.
Dimming: (Compatiable Receivers Only)
To dim a compatible receiver socket or module, switch the receiver on and
then press "On" again. The unit will now start to dim to select the required
level press "On" again.
Changing Battery:
Using a small flat screwdriver remove the front cover by placing the
screw driver in the location notch on the bottom part of the rocker cover
and unclip the cover.
On/Dim
Off
Always refer to the original instruction when using with additional products
Replace the battery with a new CR2032
battery (Byron SX100), making sure the
polarity is correct, then replace the front
cover.
Installation:
Product Specification:
Using a small flat screwdriver remove the front cover
by placing the screw driver in the location notch on
the bottom part of the rocker cover and
unclip the cover.
Once the location for the switch has been selected, the wall
switch can be stuck or screwed to the wall
WARNING: Attaching the HE-307/308 to a metallic surface will
reduce the operating distance.
1: To stick the HE-307/308 to the wall, clean the surface of all loose material
and grease using an appropriate cleaner (an alcohol based cleaner is
recommended for tiled surfaces).
When the surface is dry, remove the backing tabs on the double sided
sticky pads located on the back of the wall switch and press firmly against
the wall.
To screw the unit to the wall:
2. Using the backing bracket as a template mark and drill two holes
and fix the bracket securely using the appropriate screws and wall
plugs (included), make sure the arrow faces up.
Remote Control: HE-307/HE-308
Battery: 3v Cr2032
Range: 30 Metres (Open Distance)
Frequency: 433.92MHz
Indoor Use Only
Warning: Never Exceed the Product Specification
Product Compatability:
UP
The HE-307/HE-308 remote control wall switch is compatible with all
HomeEasy products
Contact: î î Helpline: 0845 2301 231
Contact Details:
C H Byron
34, Sherwood Rd
Aston Fields
Bromsgrove
B60 3DR
Tel: 0845 2301231
Fax: 01527 557701
Web: www.chbyron.com
E-mail:
support@chbyron.com
R&TTE
APPROVED
A
B
DKî
FIN
F
D
GR
LT
CH Byron Electrical United Kingdom. www.chbyron.com
433MHz
IRL
I
L
NL
P
E
S
0560
UK
BG
CZ
EST
H
IS
LV
SLO
CH
RO
M
N
SK
PL
Loading...