To Use Sound Spa Clock Radio
Sound Spa Clock Radio operates on either the AC adapter included or on three AA
alkaline batteries (not included).
TO CONNECT AC ADAPTER: Insert the plug into an electrical outlet and connect
the receptacle end to the side of the unit.
TO INSTALL BATTERIES: Insert three AA alkaline batteries into the compartment
on the back of the unit following the diagram inside.
SETTING AND OPERATING THE CLOCK
1. To operate the clock, you must install two AAA batteries (included with your unit)
in the farthest right battery compartment on the back of the unit.
Note: The two AAA batteries are required at all times to operate the clock, even
when the unit is powered by the AC Adapter. If you notice the LCD display or
glowing backlight becoming dim, you must replace the batteries.
2. Press the TIME SET button located on the front of the unit (Diagram A).
3. While pressing the TIME SET button, press the HOUR button until you reach
the correct hour.
4. Continue to hold down the TIME SET button and press the and MIN (minute)
button until reaching the correct time.
Note: AM will appear on the clock face during the AM hours. Be sure to set the
time for the correct 12-hour period – AM (morning) or PM (evening).
LISTENING TO SOUNDS
1. Press the SOUND button on the front of the unit to select the desired sound.
2. Press the ON/OFF button located on the front of the machine. The LED light will
illuminate when the unit is on.
3. Choose one of Sound Spa Clock Radio’s six comforting sounds by pressing the
SOUND button.
4. Adjust the automatic sleep timer to select the desired listening time: 15, 30, 45 or
60 minutes. Press the TIMER button until it says 0 for continuous play.
4
5
6. Adjust the volume switch, as desired.
7. When finished, press the ON/OFF button to turn the sound off.
LISTENING TO THE RADIO
1. Choose FM or AM radio by turning the FM/AM switch to the appropriate FM or
AM position.
2. Press the ON/OFF button located on the front of the machine. The LED light
will illuminate when the unit is on. Then press the RADIO button on the front
of the machine.
3. Using the tuning knob (Diagram B), tune the radio to the correct station.
4. Adjust the automatic sleep timer to select the desired listening time: 15, 30, 45 or
60 minutes. Press the TIMER button to the OFF position for continuous play.
6. Adjust the volume switch, as desired.
7. When finished, press the ON/OFF button to turn the radio off.
SETTING THE ALARM
1. Press the ALARM SET button on the front of the unit. ALARM will appear on the
clock face to indicate you’re changing the alarm time.
2. While pressing the ALARM SET button, press the HOUR button until reaching
the desired hour.
3. Continue to hold down the ALARM SET button and press the and MIN (minute)
button until reaching the correct time.
Note: The AM indicator also applies to the alarm. You can review the alarm setting
anytime by pressing the ALARM SET button.
4. To choose from Sound Spa Clock Radio’s three gentle-wake options, press the
AL MODE button to choose Sound, Radio or Buzzer. The AL MODE shows which
was chosen.
TO WAKE TO AM/FM RADIO:
1. Turn the unit on by pressing the ON/OFF button located on the front of the machine.
2. Choose FM or AM radio by switching the FM/AM to the appropriate FM
or AM position.
NOTE: TWO AAA
BATTERIES ARE
REQUIRED AT
ALL TIMES TO
OPERATE THE
CLOCK, EVEN
WHEN THE UNIT
IS POWERED BY
AC ADAPTER.
A
B