INSTRUCTIONS FOR USE:
IMPORTANT - Preparing the appliance for use
The Shiatsu Massager comes with a screw located on the back of the unit to protect the massage mechanism during shipment,
which must be removed before the first use to allow the shiatsu feature to function. Use the provided Allen key. Then, properly
d
ispose of the screw.
WARNING – Failure to remove screw may cause permanent damage to the appliance.
E
rror: all remote control LEDS flash for a few seconds.
Cause: massager overloaded.
Solution: ensure the allen key bolt/screw has been removed from back of the massage cushion (using the allen key included).
S
hould the condition continue after this please contact your HoMedics service centre.
NOTE: complete steps 1 and 3 before switching the appliance on at the mains.
1. Attach the Massage seat to almost any chair using the integrated strap located at the back of the cushion. Ensure it is held
firmly in place by adjusting the strap as necessary.
2. Connect the power supply lead into a 220-240V mains outlet.
3. Once seated, use the remote control to operate the appliance. Press the
q
button to activate the control and select one of
m
assage types detailed below.
4. For a gentler massage place a towel between your back and the massager.
5. Press the
q
button to stop the massage. The LED will blink while the massage mechanism returns to the starting point before
switching off.
Shiatsu Massage:
1. : pressing this button gives a full Shiatsu massage up and down the back.
2. : pressing this button gives a Shiatsu massage focusing on the mid to upper back.
3. : pressing this button gives a Shiatsu massage focusing on the mid to lower back.
4. The ‘▲▼’ buttons allow you to target the massage to a specific area. Simply press either button to stop the massage
mechanism on the desired spot. Use the buttons to move it up or down.
5. To revert to standard massage mode, reselect one of the 3 massage zone buttons.
NOTE:
• There is a 15 minute auto shut-off on this appliance for your safety. This feature should not be considered as a substitute for
‘OFF’. Always remember to switch the appliance off when not in use.
• The moving Shiatsu mechanism always “parks” or finishes in its lowest position. It will continue to this position after the power
has been turned off. If the electrical supply is interrupted, when power is restored, the mechanism will “park” or move to its
lowest position.
MAINTENANCE:
Cleaning
Cleaning shall not be done by children without supervision.
Unplug the appliance and allow to cool before cleaning. Clean only with a soft, slightly damp sponge.
• Never allow water or any other liquids to come into contact with the appliance.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, glass / furniture polish, paint thinner etc to clean.
Storage
Place the appliance in its box or in a safe, dry, cool place. Avoid contact with sharp edges or pointed objects which might cut or
puncture the fabric surface. To avoid breakage, DO NOT wrap the power cord around the appliance. DO NOT hang the unit by
the cord.
Back flap
This massage cushion incorporates a removable back flap in suede finish fabric to add comfort to the massage experience – this
is used to soften the massage if too intense. The flap is easily removed as secured by hook and eye fastening. To clean back
flap only simply follow the wash instructions:
5
GB