HoMedics HLM-SS10 User Manual

Page 1
M
A
o
e
m
k
T
e
s
a
e
l
P
Register
Your Product At:
www.homedics.com/register
Your valuable input regarding this
product will help us create
the products you will
want in the future.
e
n
t
N
o
w
Page 2
2 3
Page 3
• Humidifier should be unplugged when not in use for a long period of time.
• Do not touch the water in the main unit or the parts in the water when the unit is on.
• Never operate unit without water in the tank. Only use water in the tanks.
• Never add any additive to the water that is not produced or under the supervision of the manufacturer.
• Do not wash, adjust or move the humidifier without first unplugging the unit from its electrical outlet.
• Keep the appliance out of reach from children. Do not allow children to use the appliance without supervision.
Unique Features and Specifications
Ultrasonic Technology
This humidifier uses ultrasonic high frequency technology to convert the water into 1-5 million super particles that are dispersed into the air evenly, moistening the air.
SoundSpa
Plays 4 nature sounds with adjustable volume and 30 minute auto shut-off.
Night Light
A useful night light feature is included for your convenience.
Auto Shutoff Protection
When the tank is empty the unit will shut off automatically
Ultrasonic Nebulizer
The humidifier utilizes special spray techniques and the ultrasonic nebulizer is easy to clean for lifetime use.
Voltage Watts Tank Capacity
110–120V/60Hz 25 1 gallon – 3.78 liter
4 5
Page 4
SUMMER
NIGHT
OCEANSIDE
OFF
OFF
RAINFOREST
THUNDERSTORM
6 7
Page 5
8 9
Page 6
PROBLEM POSSIBLE CAUSE SOLUTION
Power Light is off • Unit is not plugged in
• No power at unit
SoundSpa will not turn on
Peculiar Odor • If new unit
Excessive Noise • Unit is not level
White Dust Accumulation • Hard water used
• Unit is not plugged in
• Volume is down too low
• No sound selection has been made
• Sleep Mode cycle is over
• If unit is in use, the odor may be a dirty tank or old tank water
• Low water level
• Demineralization Cartridge needs replacement
• Plug unit in
• Press the POWER button to turn the power on
• Check circuits, fuses, try a different outlet
• Plug unit in
• Turn the SOUNDSPA POWER/VOLUME knob clockwise to increase volume
• Press a sound selection button to choose a sound
• Use the SOUNDSPA POWER/VOLUME knob to turn the SoundSpa OFF, then back ON again.
• Open the water tank cap and keep it in a shady and cool place for 12 hours
• Empty the old water, clean the tank and fill with clean water
• Place unit on a flat, even surface
• Check the water level. Refill the tank if the water is low
• Use distilled water and a Demineralization Cartridge
• Replace Demineralization Cartridge
1 0 1 1
Page 7
Page 8
1 4 1 5
Page 9
Características exclusivas y especificaciones
Tecnología ultrasónica
Este humidificador usa tecnología ultrasónica de alta frecuencia para convertir el agua en 1 a 5 millones de súper partículas que se dispersan en el aire uniformemente, humedeciendo el aire.
SoundSpa
Juega cuatro sonidos de la naturaleza con volumen ajustable y 30 minutos de auto de cierre.
VELADORA
Se incluye una útil característica de veladora para su comodidad.
Protección de apagado automático
Cuando el tanque esté vacío, la unidad se apagará automáticamente.
Nebulizador ultrasónico
El humidificador utiliza técnicas de rociado especiales y el nebulizador ultrasónico es fácil de limpiar para un uso de por vida.
Voltaje Vatios Capacidad del tanque
110–120V/60Hz 25 3.78 litros –1 galón
1 6 1 7
Page 10
SUMMER
NIGHT
OCEANSIDE
OFF
OFF
RAINFOREST
THUNDERSTORM
1 8 1 9
Page 11
2 0 2 1
Page 12
Problema Posible causa Solución
La luz de encendido está apagada
El SoundSpa no se enciende
Olor extraño • Si la unidad es nueva
Ruido excesivo • La unidad no está nivelada
Acumulación de polvo blanco
2 2 2 3
• La unidad no está enchufada
• La unidad no recibe energía
• La unidad no está enchufada
• El volumen es demasiado bajo
• No se ha realizado una selección de sonido
• Se finalizó el ciclo del modo Sleep
• Si la unidad está en uso, el olor puede provenir de un tanque sucio o de agua vieja en el tanque
• Bajo nivel de agua
• Se está usando agua dura
• Se debe cambiar el cartucho de desmineralización
• Enchufe la unidad
• Presione el botón POWER (encendido) para encenderlo
• Verifique los circuitos, fusibles, pruebe con otro tomacorrientes
• Enchufe la unidad
• Gire la perilla SOUNDSPA POWER/VOLUME (Encendido SoundSpa/volumen) hacia la derecha para subir el volumen.
• Presione un botón de selección de sonido para elegir un sonido.
• Use la perilla SOUNDSPA POWER/VOLUME (Encendido SoundSpa/volumen) para apagar el SoundSpa, y luego vuelva a prenderlo.
• Abra la tapa del tanque de agua y déjela en un lugar fresco y con sombra durante 12 horas
• Vacíe el agua vieja, limpie el tanque y llénelo con agua limpia
• Coloque la unidad en una superficie plana y nivelada
• Verifique el nivel de agua Vuelva a llenar el tanque si el nivel de agua es bajo
• Use agua destilada y un cartucho de desmineralización
• Cambie el cartucho de desmineralización
Loading...