HoMedics GSM-1000H-GB Service Manual
instruction manual
GSM-1000H-GB
YEAR
guarantee
PRODUCT FEATURES Unique Gel nodes provide a smooth, natural touch massage
DEMO BUTTON - For a brief demonstration of the
features of the Shiatsu Massaging Cushion, press the Demo
button. The unit will briey go through each function. Once
complete, the unit automatically turns o. The L.E.D. light
will blink to indicate the active functions.
SHIATSU GEL MASSAGE - A deeply relaxing and
rejuvenating experience invented in Japan using rhythmic
nger pressure to stimulate ‘chi’ (vital energy), relieving
stress and tension.
SHIATSU PROGRAMS - Choose from 3 preset
programs where the Shiatsu massage travels up and down in
a specic area of the back. To select a program, simply press
the button and the LED will illuminate. To deselect, press the
button again or press another button.
Full back Upper back Lower back
SPOT SHIATSU - While the unit is in Shiatsu massage,
press either button to stop and focus the Shiatsu action in
one place. Once the unit is operating in Spot Shiatsu, you
may adjust the mechanism position by holding down either
button until the desired position is reached. The Up Arrow
will move the mechanism upwards and the Down Arrow will
move it down. Once you release the button, the mechanism
will stop in that place.
POWER BUTTON q - To turn on the unit, rst press
the POWER button. The LED indicator will illuminate and
conrm your selection. To turn o the unit, simply press the
button again. The LED indicator will blink while the back
massage mechanism returns to its lowest point and then it
will turn o.
SHIATSU SHOULDER MASSAGE - Press the shoulder
button to activate. Adjust the height of the mechanism to
meet your shoulders usingWandSbuttons. For soothing
heat press the heat button .
WIDTH ADJUSTMENT - While the unit is in Rolling
massage for the back, press this button to adjust the distance
or width between the massage heads. With each press, the
massage heads will move to the next available position.
ROLLING MASSAGE - Rolling is like two hands or thumbs
working up and down your back.
ROLLING PROGRAMS - Choose from 3 preset programs
where the Rolling massage travels up and down in a specic
area of the back. To select a program, simply press the button
and the LED will illuminate. To deselect, press
the button again or press another button.
HEAT - For soothing heat when massage is on, simply
press the heat button and the corresponding red L.E.D. light
will illuminate. To deselect, press the button again and the
corresponding L.E.D. light will turn o. For your safety,
heat cannot be turned on if massage is not selected.
Moving Gel Shiatsu
massage mechanism
INSTRUCTIONS FOR USE:
IMPORTANT - Preparing the appliance for use
The Shiatsu Massager comes with a screw located on the back of the unit to
protect the massage mechanismduring shipment, which must be removed
before the rst use to allow the shiatsu feature to function. Use the
provided Allen key. Then, properly dispose of the screw.
WARNING – Failure to remove screw may cause permanent
damage to the appliance.
Error: all remote control LEDS ash for a few seconds.
Cause: massager overloaded.
Solution: ensure the allen key bolt/screw has been removed from back of
the massage cushion (using the allen key included). Should the condition
continue after this please contact your HoMedics service centre.
Strapping System
The Gel Shiatsu Massager incorporates a unique strapping system which
allows you to fasten it to almost any chair. Just slip the straps over the seat
or chair and adjust fastening straps to secure. Your massager won’t slip or
slide away.
Note: Do not use this product for more than 15 mins at a time.
The moving dual massage mechanism on the back always “parks” or
nishes in its lowest position. It will continue to this position after the
power has been turned o. If the electrical supply is interrupted, when
power is restored, the mechanism will “park” or move to its lowest position
FKA Brands Ltd
Somerhill Business Park, Tonbridge, Kent TN11 0GP, UK
Customer Support: +44(0) 1732 378557 | support@homedics.co.uk
MAINTENANCE:
Cleaning
Unplug the appliance and allow to cool before cleaning. Clean only with a
soft, slightly damp sponge.
• Never allow water or any other liquids to come into contact with the
appliance.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, glass / furniture polish, paint thinner
etc to clean.
Storage
Place the appliance in its box or in a safe, dry, cool place. Avoid contact
with sharp edges or pointed objects which might cut or puncture the
fabric surface. To avoid breakage, DO NOT wrap the power cord around the
appliance. DO NOT hang the unit by the cord.
PLUG: If the plug on this appliance is damaged,
it can be replaced with a BS 1363 plug, tted with
a 3A BS 1362 fuse. The recommended fuse for
this appliance is 3 amp. Care must å taken when
changing the plug. If in doubt, contact a qualied
electrician.
IB-GSM1000H-GB-0118-01
Loading...