Home Scandinavia, 487/7174, 476/8654 Assembly Instructions Manual
Scandinavia - Chest of drawers
Dimensions
Width - 78cm
Depth - 40cm
Height - 71cm
Issue 3 - 23/11/2016
Important – Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400800
Assembly Instructions
476/8654
487/7174
Retain these instructions for future reference
Sainsbury’s Argos
489-499 Avebury Boulevard
Saxon Gate West
Central Milton Keynes
MK9 2NW
1
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal centre.
Care and maintenance
Tools required
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
Phillips screwdriver
(medium & large)
Flatblade screwdriver
(medium)
Small
hammer
Ruler/tape
measure
Drill
Eye protection
(when using a
hammer or glue)
7mm Suitable drill bit
(for use with wall plug)
• Check you have all the
components and tools listed on
pages 2 and 3.
• Do not use this item if any
components are missing or
damaged.
• Remove all ttings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• Do not stand or put weight on
the product, this could cause
damage.
• Assemble the item as close
to its nal position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your oor.
• Parts of the assembly will be
easier with 2 people.
• We do not
recommend the
use of power
drill/drivers for
inserting screws,
as this could damage the unit.
Only use hand screwdrivers.
• Dispose of all packaging
carefully and responsibly.
• Assembly to be carried out by
a competent adult only
• During assembly children
should be kept away from the
product due to possible risk of
injury.
• Folding and unfolding this
product should only be carried
out under adult supervision.
• Ensure that ngers and legs
are clear of all adjustments
when adjusting this product.
• Regularly check all fastenings
to ensure that they properly
tightened.
2
Components - Panels
Please check you have all the panels listed below
Front left leg
67x 3.2cm)
2
Front right leg
(67 x 3.2cm)
5
Left side panel
(62.6 x 30cm)
1
Back x 2
(60x34.4 cm)
10
Small drawer back x 2
(28 x 11cm)
13
Large drawer back x 3
(62 x 11cm)
16
Large drawer front x 3
(66.6 x 14cm)
15
Small drawer front x 2
(32.4 x 14cm)
11
Large drawer bottom x 3
(64 x 33cm)
17
Small drawer bottom x 2
(30 x 33cm)
14
Plinth x 2 (67 x 4.4cm)
9
Divider (36.6 x 14.5cm)
8
Top (78 x 40cm)
7
Right side panel
(62.6 x 30cm)
4
Drawer side x 10
(34 x 10cm)
12
Back left leg
(67 x 3.2cm)
3
Back right leg
(67 x 3.2cm)
6
If you have damaged or missing components,
call the Customer Helpline:
03456 400 800
3
Please check you have all the ttings listed below
Cam 12 mm x 30
Cam 15 mm x 8
Screw 14 mm x 1
Knob x 8
Wall plug x 1
Screw 35 mm x 28
Screw 20 mm x 1
Washer x 2
Nail x 30
Wall strap x 1
Screw x 40
Drawer runners x 5
Locking pin 34 mm x 8 Dowel 40 mm x 12
Locking pin 24 mm x 30 Dowel 30 mm x 4
Ruler - Use this ruler to help correctly identify the screws
A
D
G
J
M
P
H
K
N
I
L
O
P 1 P 2 P 3 P 4
E F
B C
Note: The quantities below are the correct amount to complete the assembly. In some cases more ttings
may be supplied than are required.
0510 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
110 115 120 125 130 135 140 145 150 155 160 165 170
105
Components - Fittings
4
Components - Key Diagram
Function of Cam and Locking Pin
9
10
17
16
x3 x2
15 1112
12
12
12
13
14
8
7
10
9
2
5
1
4
3
6
Left side
Right side
5
Assembly Instructions
Step 1
Step 2
Inserting the dowels
and mounting the
locking pins to the
legs.
Insert the dowels F
into the holes indicated
on the legs 2 and 3.
Screw the locking pins
E
into the holes
indicated on the legs
2
and 3.
Note: Insert locking pins
E as far as shown. Do
not over tighten.
Mounting legs to the side
panels.
Fit the legs 2 and 3 .
onto the side panel 1.
Note: See page 5
“Function of cam and
locking pin“.
Place the cams D into the
holes indicated on the side
panel 1 .
To tighten cams: Turn to
the right using a
screwdriver.
2
2
2
3
1
1
3
D
D
D
D
D
F
F
F
F
F
F
F
E
E
E
E
E
Rebate=Back
Loading...