HOMA Technology HLC734 User Manual

reless Dimmable Controller
Wi
User Guide
HLC734
Product Introduction
1
HLC734-Z is a kind of zigbee dimmable controller for UFO highbay. The controller is based on HA1.2 protocol, embedded power metering function. And the controller outputs 1-10V dimmable signal and AC. So it works with 0/1-10V or 0-10V dimmable LED driver on the market. There is a sensor interface for sensor input. The controller is a part of iLightsIn Pro smart lighting system. It gets the command from gateway, touch panel or sensor directly.
Wiring Connection
2
Sensor
AC_L In
AC_N In
AC_E In
DC Out Motion In Daylight In
GND
AC_L In
AC_N In
AC_E In
HLC734-Z­SC-A-MD­PRO
HLC734-Z­SC-A-PRO
AC_L Out
AC_N Out
AC_E Out
GND
1-10V
AC_L Out
AC_N Out
AC_E Out
GND
1-10V
1-10V
Dimmable
driver
1-10V
Dimmable
driver
LED+
LED-
Lamp
LED+
LED-
Lamp
Restore Factory Setting
3
Step1: AC power on and then off the device within 2 seconds (via circuit breaker); Step2: Repeat step1 for 4 times; Step3: Power on the device follow up with step2 , light will flash for 4 times and then keep on, the light is set to factory settings. All binding records are cleared. Step4: The brightness of the light will change to 30% if this device joined network successfully.
Model definition
4
Model definitionModel name
HLC734-Z-SC-A-PRO
HLC734-Z-SC-A-MD-PRO
HLC734-Z-SC-A-MB-PRO
Environment and Electrical parameters
5
Input
Output 1-10V
1-10V Max current
Relay Max current
Waterproof
Basic version
Motion&daylight input version
Binding motion input version
AC100-277Vac
AC100-277Vac 1-10V
15mA
5A
IP65
30poundPull
-40°C ~70°COperating Temperature
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
FCC ID: 2AJ7E-HLC734
Loading...