HOMA Installing Air Bleed Valve and Bracket User Manual

Publication

Please Contact

Technical Support At 203

-

736-8890 With Any Additional Questions

Page

•

Valve and Bracket

Screw nipple assembly into motor cap using the

fittings shown in the photo at the right.

• Always apply teflon tape or water-proof thread
sealent to prevent leaks

• Place air bleed valve in the large hole in the metal
bracket.

• Screw the two bolts on the motor cap through the
holes on the “arms” of the bracket. Leave the
bracket slightly loose and moveable

Installing Air Bleed

• REMEMBER: The bolts on a motor cap are
frequently loctited and may need to be heated to be
removed.

• Screw the air bleed valve into the top fitting of the
nipple assembly until the bottom surface of the
valve is flush with the bracket.

• Align bolt holes in valve with bolt holes in bracket
and screw bolts completely through valve.

• Put flat-sided washers and nuts on the end of the 5

bolts and tighten all loose nuts and bolts.

88PN3005

Please Be Prepared To Provide Pump Serial Number During Call

1 of 1