Don’t use this drone in adverse weather conditions such as rain, snow, fog,
and wind.
-02-
2.3 Operation Requirements:
① Please don’t use this product to follow any moving vehicles .
② During the flight, only turn off the motor in case of an emergency.
③ As battery becomes low return the drone back to your starting point.
④ This product should not be used while drinking alcohol, if you are feeling
fatigued, taking medicine, or feeling any physical discomfort.
⑤ Beware of the noise volume the drone produces. Keep your distance to
avoid ear damage.
⑥ Stay away from the rotating
propellers and motors.
⑦ Don’t fly in the No-Fly Zone.
2.4 Use of Battery:
① Please ensure batteries are fitted in the correct orientation as shown in
the instruction manual.
② Avoid short circuits by fitting the batteries incorrectly, and do not crush
or squeeze the batteries as this could carry the risk of an explosion.
③ Do not mix new and old batteries as this can lead to a poor performance
of the product.
④ Dispose used batteries carefully, do not litter.
⑤ Please keep dead batteries away from heat and fire.
⑥ If the device is not going to be used for an extended period of time,
remove batteries to prevent potential damage from battery leakage.
-03-
⑦ It is recommended to only use the USB charging cable that comes with
the drone to charge the battery.
⑧ Don't connect the battery directly to wall outlets or car cigarette -lighter
sockets.
⑨ Don't attempt to disassemble or modify the battery in any way.
⑩ Don't use the battery if it gives off an odor, generates heat, becomes
discolored or deformed,or appears abnormal in any way. If the battery is in
use or being charged, remove it from the device or charger immediately
and discontinue use.
11
Don't pierce the battery casing with a nail or other sharp object, break it
open with a hammer, or step on it!
12
Always charge the batteries in a fireproof container and away from
combustible materials. Don't charge on surfaces that can catch fire. This
includes: wood, cloth, carpet, or in the application's device.
13
Don't immerse the battery in water or allow it to get wet.
14
Don’t solder battery terminal directly.
15
Keep battery out of reach of children or pets.
16
Don't short-circuit the battery by connecting wires or other metal object
to the positive(+) and negative(-) terminals.
Li-Po Battery Disposal & Recycling
Waste Lithium-polymer batteries must not be placed with household trash.
Please contact local environmental or waste agency or the waste agency
or the supplier of your model or your nearest Li-Po battery recycling center.
-04-
3.0 MAINTENANCE
① Clean the product after each use with a clean, soft cloth.
② Avoid prolonged exposure to direct sunlight and avoid buildup of heat
on the drone.
③ This device is not waterproof and must not be submerged in water
under any circumstance. Failure to maintain the device completely dry will
result in the failure of the unit.
④ Check the charging plug and other accessories for signs of damage
frequently. If any part of the device is damaged, refrain from flying until
When turning on the transmitter, the default mode is the GPS Mode. Turn
off GPS by sliding GPS switch. Check the icon “ ” or “ ”on the LCD
screen to confirms GPS status.
•Return to Home (RTH)
Press the button to start the RTH, the transmitter makes a beep sound
and the drone will fly back to the recorded Home Point.
Press the RTH button again to exit RTH procedure and regain control of
the drone.
•Emergency Stop
Press and hold the button ” “ for 3 seconds, the motor will stop immediately.
Attention: The Emergency Stop function should only be use during
emergency to avoid any damage or injury.
•Photo/ Video
Short press the button and the camera icon “ ” on the LCD screen
flashes once, the camera takes one photo.
Long press the same button, the video icon “ ” on the LCD screen
flashes slowly the camera is taking video. Long press again will exit
shooting.
•Speed Switch
Long press the button “ ” in the upper right corner, the LCD screen
showing “ ”, and you will hear a beep, which means the drone is at the
low speed.
Long press the button “ ” again, the LCD screen showing “ ”, and you
will hear two beeps, which means the drone is at the high speed.