Holtkoetter 8520 User Manual
ASSEMBLY INSTRUCTIONS FOR
205 Hardman Avenue South, South Saint Paul, MN 55075
Voice: (800) 899-5444 • Fax: (888) 552-8661
e-mail: customerservice@holtkoetter.com
www.holtkoetter.com
UL requires the following safety instructions:
Lighted lamp is HOT! WARNING: Improper use of this fixture may increase the risk of FIRE,
ELECTRICAL SHOCK, EXPOSURE TO EXCESSIVE RADIATION or INJURY TO PERSONS.
IN ORDER TO REDUCE THESE RISKS, PLEASE FOLLOW THESE SAFETY INSTRUCTIONS:
1. Before replacing bulb, DISCONNECT power and allow bulb to cool.
2. DO NOT touch hot glass shield or operate lamp with a missing glass shield.
3. Keep lamp away from materials that may burn.
4. Do not remain in light if skin feels warm or look directly at a lighted bulb.
Halogen Wall Sconce
No. 8520
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.
8520/1
Care Instructions
Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the
outside of the brass may be damaged as a result. Enjoy your new Holtkötter fixture.
Holtkötter ® and Holtkötter Leuchten® are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
ASSEMBLY INSTRUCTIONS FOR
e-mail: customerservice@holtkoetter.com
www.holtkoetter.com
Please make sure that the following parts for your wall sconce are enclosed:
A. 75 Watt frosted Halopin Bulb
B. Glass Shield (two attached to fixture)
C. Allen Wrench
D. Wall Sconce
IT IS FIRMLY RECOMMENDED THAT A LICENSED
ELECTRICIAN INSTALL THIS FIXTURE. DISCONNECT
POWER BEFORE SERVICING.
General Installation Instructions
1. D
isconnect power to the outlet.
2. Using the allen wrench (C) provided, loosen, but
do not remove the two set screws (E).
3. Slide the universal crossbar strap (G) off of the
fixture.
4. Mount the universal crossbar strap (G) to the outlet
box before making the wire connections.
5. Connect the wires from the fixture with the wires in
the outlet box according to generally accepted
electrical standards
6. Slide the fixture back onto the
screws (H) attached to the
universal crossbar strap.
7. Retighten the set screws (E) to
secure the fixture to the crossbar
strap.
H
C
D
E
A
Halogen Wall Sconce
No. 8520
Install or Replace Bulb
1. Disconnect power to the wall sconce.
2. Using a flat head screwdriver, unscrew
the finished screw (F) located on the
glass shield. Remove the glass shield
(B).
3. Remove the old bulb if needed.
4. Insert the 75 Watt (max.) halopin bulb (A)
by pushing it gently down into the socket.
NOTE: BE CAREFUL NOT TO TOUCH THE
BULB WITH YOUR BARE HANDS.
5. Reinstall the glass shield using the
previously removed finished screw (F).
A
B
F
E
G
C
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.
Holtkötter ® and Holtkötter Leuchten® are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Loading...