Holtkoetter 8502 User Manual
ASSEMBLY INSTRUCTIONS FOR
205 Hardman Avenue South, South Saint Paul, MN 55075
Voice: (800) 899-5444 • Fax: (888) 552-8661
e-mail: customerservice@holtkoetter.com
www.holtkoetter.com
UL requires the following safety instructions:
Lighted lamp is HOT!
WARNING: Improper use of this fixture may increase the risk of
FIRE, ELECTRICAL SHOCK, EXPOSURE TO EXCESSIVE RADIATION or
INJURY TO PERSONS.
IN ORDER TO REDUCE THESE RISKS, PLEASE FOLLOW THESE SAFETY
INSTRUCTIONS:
1. Before replacing bulb, DISCONNECT power and allow bulb to cool.
2. DO NOT touch hot glass shield or operate lamp with a missing glass shield.
3. Keep lamp away from materials that may burn.
4. Do not remain in light if skin feels warm or look directly at a lighted bulb.
5. Use of the Osram bulb provided with this lamp prevents exposure to excessive UV Radiation.
Use of any other bulb may cause a risk of exposure to excessive UV Radiation and may also
cause a risk of overheating or may rupture the bulb.
Halogen Wall Sconce
No. 8502
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.
Care Instructions
Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth can be used to spot
clean. Do not use common household cleaners on lamps or fixtures, as the lacquer on the
outside of the brass may be damaged as a result. Enjoy your new Holtkötter lamp.
Holtkötter ® and Holtkötter Leuchten® are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
ASSEMBLY INSTRUCTIONS FOR
e-mail: customerservice@holtkoetter.com
www.holtkoetter.com
Please make sure that the following parts are enclosed:
A. 60 Watt frosted Halopin Bulb
B. Glass Shield (attached to fixture)
C. Allen wrench
D. Wall Sconce
IT IS FIRMLY RECOMMENDED THAT A LICENSED
ELECTRICIAN INSTALL THIS FIXTURE. DISCONNECT
POWER BEFORE SERVICING.
General Installation Instructions
1. Remove the universal crossbar strap/socket assembly (G)
from the back of the sconce by loosening the set screw (E)
with the allen wrench (C) provided. This allows the crossbar
strap/socket assembly and bulb to be separated from the
finished backplate (F) and wall sconce (D).
2. Mount the universal crossbar strap (G) to the outlet box
before making the wire connections.
3. Connect the wires from the sconce with the wires in the
outlet box according to generally accepted electrical
standards.
G
Halogen Wall Sconce
No. 8502
Install or Replace Bulb
1. Disconnect power to the wall sconce.
2. Unscrew the glass shield (B).
3. Insert the Halopin bulb (A) by pushing it gently down into the socket.
F
NOTE: BE CAREFUL NOT TO TOUCH THE BULB WITH YOUR BARE HANDS.
4. Reinstall the glass shield.
A
D
B
4. Put the finished backplate (F) onto the socket, followed by
the fixture (D).
5. Making sure the fixture
is level, tighten the set
screw (E) with the allen
wrench (C).
Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.
D
C
E
Holtkötter ® and Holtkötter Leuchten® are registered trademarks of Holtkötter. All Rights Reserved.
© Holtkötter
Loading...