Holtkoetter 6319 User Manual

HOLTKÖTTER INTERNATIONAL, INC.

155 Hardman Avenue South, South St. Paul, MN 55075

fax: [phone] • phone: [phone]

www.holtkoetter.com

e-mail: [e-mail]

Please make sure that the following parts for your lamp are enclosed:

A. Reflector
B. Aluminum Ring (attached to lamp)
C. Glass Shield
D. Allen Wrench (packed inside bulb box)
E. Large Washer (2 each, already installed)
F. Handle with plastic protector
G. Small Plastic Washer (attached to reflector)
H. Small Plastic Nut (attached to reflector)
I. Bayonet Base Halogen Bulb
J. Table Lamp

Care Instructions

Use only a soft, dry cloth to clean. If necessary, a slightly damp, soft cloth may be used to
spot clean.

Do not use common household cleaners or brass cleaners on lamps or fixtures, as the
lacquer on the outside of the brass may be damaged as a result.

Enjoy your new Holtkötter lamp.

ASSEMBLY INSTRUCTIONS FOR

Halogen Pharmacy Lamp

6319/1

(A)

(E)

Step 3. Slide the reflector (A) over
the socket. Place the large washer (E)
that was removed back onto the
socket. Screw the aluminum ring (B)
back onto the socket until it is tight.
Tighten the set screw on the aluminum
ring into place. DO NOT OVERTIGHTEN.

MAKE SURE THE REFLECTOR IS STILL
LOOSE ENOUGH TO TURN.

(I)

Step 4. Put the 100-Watt halogen
bulb (I) into the socket. Hold the bulb
at the porcelain grip, push it down
slightly and turn it clockwise. BE

CAREFUL NOT TO TOUCH THE BULB
ENVELOPE WITH YOUR BARE HANDS.

Note of Caution: The recommended replacement
bulbs for this fixture are 100 W Osram Bayonet Base
Halogen bulbs. Use of other brands of unknown
quality may cause a risk of overheating.

Bulb & Reflector Installation

(E)

Step 1. The brass arms are
made of soft, high-quality brass
that is pliable and may be bent
from shipping. If necessary, apply
pressure to straighten.

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.
Bulbs manufactured in Germany by Osram GmbH.
Final assembly by Holtkötter International, Inc. in South St. Paul, MN.

Step 2. Loosen the set screw with
the allen wrench (D). Then
unscrew the aluminum ring (B) from
the lamp arm. Remove one of the
large washers (E).

set screw

(D)

(B)

(H)

(G)

(C)

Step 5. Align the glass shield (C) with
the small screw extending from the
bottom of the socket. Place the small
washer (G) and the small plastic nut
(H) over the screw and finger tighten.

(F)

Step 6. Next, screw on the handle (F)
and finger tighten. DO NOT

OVERTIGHTEN – THE GLASS SHIELD MAY
CRACK UNDER TOO MUCH PRESSURE.

Step 7. Plug the lamp cord into the

wall outlet. Your lamp is now
operational.

Holtkötter® & Holtkötter Leuchten® are registered trademarks

of Holtkötter International, Inc. All Rights Reserved.

© Holtkötter International, Inc.