Holtkoetter 2573 User Manual

ASSEMBLY INSTRUCTIONS FOR

205 Hardman Avenue South, South Saint Paul, MN 55075

Voice: [phone] • Fax: [phone]

e-mail: [e-mail]

www.holtkoetter.com

Congratulations, you have purchased one of the finest
brass torchieres available on the market today.
Complete with safety features such as a fully enclosed
bulb compartment and a tilt switch, this torchiere comes
with peace of mind.

The following parts are included with the torchiere:

1. Torchiere Glass Shade

2. Torchiere Glass Shield assembly (including finished
knob and white plastic washers)

3. Allen wrench for Torchiere Glass Shield (packed inside

bulb box)

4. 100-Watt frosted Bayonet Base Halogen bulbs,
3 each.

Note of Caution: The recommended replacement
bulbs for the torchiere on this fixture are 100-Watt
Osram Bayonet Base Halogen bulbs. Use of other
brands of unknown quality may cause a risk of
overheating.

Halogen Torchiere

No. 2573

INSTALL THE TORCHIERE GLASS SHADE AND BULBS

1. Unscrew the three white knobs and

remove the white ring.

2. Install the glass shade, replacing
the white ring and tightening the three
white knobs hand-tight. Be sure not to
overtighten the knobs.

CARE INSTRUCTIONS

Use only a soft, dry cloth to clean. If necessary, a slightly
damp, soft cloth may be used to spot clean.

Do not use common household cleaners or brass cleaners

on lamps or fixtures, as the lacquer on the outside of the

brass may be damaged as a result.

Enjoy your new Holtkötter lamp.

Major lamp parts manufactured in Germany by Holtkötter Leuchten GmbH.

Bulbs manufactured in Germany by Osram GmbH. Final assembly by Holtkötter in South Saint Paul, MN.

3. Being careful not to touch the bulb
envelope with your bare hands, install
the three bayonet base bulbs provided.
Push the bulb into the socket and turn
clockwise.

Holtkötter ® and Holtkötter Leuchten® are registered trademarks of Holtkötter. All Rights Reserved.

4. Place the glass shield assembly
over the center stem of the torchiere,
concave side up. Tighten with the allen
wrench provided. Your torchiere is now
operational.

© Holtkötter